II. We have two circuits, A and B. In circuit A, a lamp is connected to a 12 V battery. In circuit B, the same lamp is connected in series to an inductor and a 12 V battery. If we close these two circuits at the same time, which lamp will reach its maximum intensity (brighter) first? Explain.

II. We have two circuits, A and B. In circuit A, a lamp is connected to a 12 V battery. In circuit B, the same lamp is connected in series to an inductor and a 12 V battery. If we close these two circuits at the same time, which lamp will reach its maximum intensity (brighter) first? Explain.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Brief overview of Types of Resistors, Capacitors and Inductors. Its functions and their circuit…

A: Concept used: Circuit elements such as resistor, capacitor and inductor have wide spread…

Q: 10. The resonance frequency of this circuit is 1000 H z. To change the resonance frequency to 2000 H…

Q: Cathode Ray Oscilloscope: The oscilloscope can be used as a voltmeter, therefore, Select one: d. It…

A: The voltmeter is a device that measures the potential difference when connected across the circuit.…

Q: 1. A small water-heating coil is submerged in a container with 200g of water and 100g of ice,…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: 1. Tifanny is trying to get a light to burn brighter by increasing the current in its circuit. Would…

A: Answer (1) No , adding a resistor in series with the bulb doesn’t allow it to light brighter…

Q: 7. In an AC circuit there are two devices connected in series. If the current in the circuit and the…

A: Current (I) = 2 Sin(2000t + 1.801) Ampere Potential difference = 100 Sin(2000t + 0.873) volts

Q: *Problem 8 Consider a three-phase transmission line consisting of three concentric con- ductors, as…

A: To answer: The electric and magnetic field comparision Total power

Q: We have two circuits, A and B. In circuit A, a lamp is connected to a 12 V battery. In circuit B,…

A: Given:- We have two circuits. In circuit A, a lamp is connected to a 12 V battery. In circuit B,…

Q: 3. We can easily find the LR circuit time constant from a graph of the current versus time. The…

Q: Plz don't use chat gpt

A: Step 1:

Q: 74: An A.C. circuit consist of a resistor of 50 and inductor of 10 mH connected in series with 50 V,…

A: We have to find-(i) Capacitance which is to be connected in series to obtain maximum current…

Q: Answer the following questions regarding the DC circuit shown in Figure 1. 60 Ω R Ω P₁ P₂ mow 100 mA…

A: Given, Resistances, R1=60ΩR2=RR3=50Ω Current through resistors, i1=100mAi2=ii3=200mA a. According to…

Q: The transformer between a wall outlet and a cell phone has an output of 0.4 A at 4.3 V. What is the…

Q: 5. Suppose the following circuit is left open for a long time. 24 VT 5000 Ω 80 mF (e) what is the…

Q: An oscillating LC circuit consisting of a 2.0 nF capacitor and a 1.0 mH coil has a maximum voltage…

Q: 3) Suppose a current is given by the equation I=1.70sin(250t), where I is in amperes and t in…

A: Given, Current, I=1.7sin(250t) Resistance, R=24Ω

Q: You have three switches (two-position switches), a battery, a light bulb, and an infinite supply of…

A: When a switch is "off" the input is 0. When a switch is "on" the input is 1. The truth or output…

Q: Here you see the circuit board that I passed around in class one day, the control board from my…

Q: Some surgery is performed with high-voltage electricity passing from a metal scalpel through the…

A: In the time of surgery, using metal scalpel high voltage is passed and current passes through the…

Q: 2. Suppose that the switch in an RC circuit with Eo = 0 is closed at time t = 0 when the capacitor…

Q: An oscillating LC circuit consisting of a 2.0 nF capacitor and a 1.0 mH coil has a maximum voltage…

A: Given: C=2nF = 2x10-9F L=1mH = 1x10-3H Vmax = 4V

Q: 1. Calculate the current through a 5 μF capacitor if the voltage across it is v(t) = 10 cos 6000t V

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Given the following resistors, what capacitance should you choose in the design of a high-pass…

Q: The voltage across a 200-mH inductor is given by v(t) = 3t² + 2t + 4 V for t >0. If i(0) = 1 A.…

A: We have for inductor V=Ldidt

Q: None

Q: DA transformer has a primary of 235 turns and a secondary of 25 turns. If I plug it into an AC utlet…

Q: 16. An AC voltage source, with a peak output of 150 V, is connected to a 75-2 resistor. What is the…

A: Given data: Voltage(v)=150V Resitance(R)=75-ohm To find: Energy dissipated

Q: An AC source is connected to a series combination of a lightbulb and a variable inductor. If the…

A: The expression for the emf, ε0=IR+2πfL

Q: A 5 kW coil has a length of 45 cm. If a length 5 cm is cut from the coil, what power (in kW) is…

A: Given data: Original Length of coil (L0) = 45 cm Power (P) = 5 kW Length cut from the coil (x) = 5…

Q: When an electric circuit is turned on, it take an unusually long amount of time for the current in…

Q: 7. Consider the following circuit: 2 Assume that the capacitor does not have any charge at the…

A: (a). The given circuit is a series LRC circuit. And the phase difference between the current in the…

Q: Q3 In the circuit shown in the figure below, if the continuous resistance of the coil is 45 ohm and…

A: This is a question regarding the of a Bridge Rectifier. When an ac input voltage is applied across…

Q: The output voltage, Vo, is given by Rf R2 Vo R1

A: This is a question from Analog Electronics. To solve this question we will use the concept of…

Q: I connect a 1012 Ω resistor, a 1.2-µF capacitor, and a 0.85-H inductor in series with a V = 200…

Q: In the circuit shown, both capacitors are fully charged by setting the switch in position 1. w2 w1…

A: The question deals with the LC oscillator frequency. The LC circuit is utilized in old radios to…

Q: (a) What is the maximum current in a 4.90-µF capacitor when it is connected across a North American…

A: Given that:-Capacitor is connected with AC sourceVrms=120 Voltf=60 HzC=4.90 μF=4.90×10-6 FCapacitive…

Q: 8 The R-L parallel circuit shown in Figure 18-1 has an apparent power of 325 VA. The circuit power…

A: In this qusetion figure is missing but not required for solution 8 and 9. 8. Given, Apparent Power =…

Q: 5) For the following circuit R1 = R2 = 60.0 ohm. R3 = 250.0ohm. R4 = 325.0ohm, R5 = 260.0ohm, and…

Q: How does the addition of capacitors or inductors affect the behavior of alternating current (AC)…

A: The behavior of alternating current (AC) circuits is affected by the addition of passive components…

Q: An inductor and a resistor are connected in series to a battery as shown in the figure below, where…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

II.
We have two circuits, A and B. In circuit A, a lamp is connected to a 12 V battery. In
circuit B, the same lamp is connected in series to an inductor and a 12 V battery. If we
close these two circuits at the same time, which lamp will reach its maximum intensity
(brighter) first? Explain.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The spool is a transformer. It consists of two windings of copper wire, "the primary coil 1, the secondary coil 2." The primary coil is composed of 220 turns of wire. The secondary coil is composed of 120 turns of wire. (1) The secondary coil terminals are connected to a light bulb. Nothing happens. The primary coil is connected to a AC power supply. What do you observe about the light bulb (2) a) Explain why a changing voltage (across the primary coil) creates a changing magnetic field around the transformer. b) Explain why the changing magnetic field around the transformer, induces a changing voltage in the secondary coil. (3) The experimenter brings a heavy cast iron bolt towards the transformer. Why does the heavy iron bolt appear to get “sucked in” to the central hole in the transformer? b) What do you observe about the light bulb? c) How can you explain this?
A series RLC circuit withR= 6Q; L = 0.1H and C = 0.2 F has no applied voltage. Find the 1 subsequent current if the initial charge on the capacitor is 10 C and the initial current is zero. А. i (t) (e-10t + e-50t) A 4 С. i (t) (e-10t e-50t) A = (e-10t 4 5 (e10t + e-50t) A 6 В. i (t) e50t) A D. i(t)
5) Consider the DC-circuit shown below. This is an example of a parallel circuit, with a 12 V power source, and two resistive elements. Label the circuit diagram completely, showing magnitude and directions of the total circuit current, I; the polarity of the 12V power source; the polarity of the voltage drops across each resistor; and the magnitude and direction of the current flow in each of the resistors mounted in parallel. Also label the value of the potential, in volts, at the points a, b, c, and d, in the circuit; what do the values imply about the voltage drop across resistors in parallel? Show all of your work. 12 V R= 6LŹ R= 6 S2
2.) Para llel Circuit R, = |452 R3 62 50V I, Is 2. V,
28918 the ATHS-T2-EOT-PHY71-Makeup-Retest Free Response Question: Capacitor charging/discharging CIRCUIT A 18 - 20 + 60289187dc1 109:37 CIRCUIT B ideal batteries of 60289187dc1s Find the time constant for each of the circuits (in terms of the given 60187dc1 CIRCUIT C in R S C/2 circuits that require the same time to fully charge the Answer this 89187dc1 6028 7dc1 question in the space provided below. 2R 50289187dc1 and identify the two сараcitor. 1870 0289187d 20% 60289187 187dc1 II 0289d 60289 0289187 C60289187 dc1 60289187dc1
40. The current through an inductor cannot change instantaneously. True False 41. The current through a capacitor is zero unless the voltage is changing. True False 42. A capacitor is an electric device that has current carrying conductors wound over an iron core. True False
In the analogy between an RLC circuit and a mass on a spring moving through a viscous fluid, which element in the RLC circuit represents the spring? O the resistor O the capacitor O the inductor O the power supply
26. At time r=0, the voltage across a 102 resistor connected to an AC voltage source v(t) = 6V cos(2r(50HZ)t) is 6V. What is the current through the resistor 0.1 seconds later? A. 0A %3D B. 0.1A C. 0.6A D. 1A E. 6A
Q.5. The frequency of an alternating voltage is 50 cycles/sec and its amplitude is 120V. Then its rms value of current will be (a) 101.3V (c) 70.7V _TE (b) 84.8V (d) 56.5V 1965
4) The most basic DC circuit consists of a battery (direct current source) and a resistor connected with conducting wires. Draw such a circuit for a 10V battery and a 500 resistor. Indicate the direction of current on your diagram and find the current magnitude in this circuit.
10
A capacitor is attached to an AC voltage source. Which change will result in a doubling of the current?A. Halving the voltage and doubling the frequencyB. Doubling the frequencyC. Halving the frequencyD. Doubling the voltage and halving the frequency