II. Problem Solving A 400 resistor is connected in parallel to a coil having a resistance of 102 and an inductance of 3H. If a single- phase AC voltage source having an instantaneous value of v(t) = 35 sin(50t) V is connected across the parallel connection, look for the following: a. The phasor and instantaneous current across the 4000 resistor b. The phasor and instantaneous current across the coil

II. Problem Solving A 400 resistor is connected in parallel to a coil having a resistance of 102 and an inductance of 3H. If a single- phase AC voltage source having an instantaneous value of v(t) = 35 sin(50t) V is connected across the parallel connection, look for the following: a. The phasor and instantaneous current across the 4000 resistor b. The phasor and instantaneous current across the coil

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
An emergency power supply is required to provide a three-phase sinusoi- dal voltage source of 208 V (L-L) at a frequency of 400 Hz. The power is to be obtained from a battery consisting of cells in series, each cell hav- ing an internal voltage of 2.2 V and an internal resistance of 0.006 m. The load on the three-phase, 400-Hz system requires a fundamental fre- quency apparent power of 7.2 kVA at 0.9 power factor lagging. The in- ductance of the load is such that harmonic currents are negligible. How many cells should be connected in series to provide the required output? The switches may be regarded as ideal.
Problem 3 a) In Figure 1, the current through a 550 nF capacitor is i= 12 x 10-3 A sin(2000t + 20°). What is the sinusoidal expression for the voltage e? b) In Figure 2, the voltage across a 110 mH coil is e = 150 V sin(377t + 45°). What is the sinusoidal expression for I %3D the current i? i – - e e Figure 1 Figure 2 Page 1 of 2
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
3. An inductor having a 50 ohms resistance and 100 ohm inductive reactance is connected to a 100 volts, 60 hz a-c source. Draw the phasor diagram and waveform diagram of the current and voltage of the circuit showing their phase an
The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mA
A utility company plans to connected a total of 20uF of capacitance to a 7,200 volt line. To make this connection, four capacitors will be connected in series. What is the capacitance of each capacitor?
An inductor and a 470 ohm resistor are connected in series with a function generator. The current is 53.7mA RMS 8kHz. The reactive power is 2.32 var. Find the value of the inductance.
The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there are no reactive components in the AC circuit the resistance of the circuit is equal to the reactance of the reactive components the inductive reactance and capacitive reactance are equal in magnitude there are no inductors in the circuit
A2 KO resistor and 30 mH inductor are connected in series, across a 120 V A.C power source oscillating at 60 Hz frequency .Calculate i) The current in the circuit i) The voltage drop across the resistor & inductor ii) The power dissipated in the circuit. iv) The apparent power & reactive power in the circuit. v) Draw the phasor diagram.
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source.