II. If the beam carries a moving uniform load of 1.19kN/m and concentrated moving load of SN kN as indicated in the figure. Using the influence line diagram, (a) determine the max. moment due to loads at C (b) det.max positive V at C 6 m + 6 m Pin support roller SN KN A

Q: 5.3 Magnitude of effective length of compression member depends upon A) ocation where member is used…

A:

Q: e: If your student number contains a zero (0) for any of the digits indicated, assume a value of 7.…

A:

Q: Please solve the problem step by step with a clear solution

A: Step 1:Let's divide the given shape into two separate rectangles.The area of the rectangle at the…

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A: P = 525 N  = 74 MPa

Q: Question 2: Locate the X-X and Y-Y centroidal axes for the built-up structural steel areas shown.…

A: Centroid: The point at which the given plane figure is divided into equal volumes into all sides is…

Q: 5.1 What is steel tension member? A) Structural elements that are subjected to indirect tensile…

A:

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Q: Determine Mn iff'y = 60,000psi and fe=4,000psi. use (IS 456) -24 in. 4 in.

A: The values given in the question are as followsYield strength of steel(fy)=60,000 psi or 413.685…

Q: Id". Equating force at Joint B. Sdn. {Fy=0 FAB E545-FBC Cos 26.565= 0· [Fx=0. FAB Sin 45t FBC Sim…

A: Consider the FBD drawn below ;The angle made with line will be Cosine and other the angle will be…

Q: Mex Force 15 KN APPlied on nail what is The Max V If Spacing between Nail is 75cm ? 15cm 5cm 15cm…

A:

Q: W 14 x 159 of A992 Steel Section Į Pu = ? nat | Pu = ? 14 ft 10 ft lx = 40 fi 40 ft 16 ft Strong…

A:

Q: 3 500 k P = 1,000 k Р, 3— 500 k Py= 1,000 k %3D |fixed fixed Check whether a 17 ft W 14 x 211…

A: Given:- The dead load on the column = PD = 500 k The live load on the column = PL = 1000 k The steel…

Q: D) 5.4 The design bending strength of laterally supported beams is governed by A) yield stress B)…

A: Given data for question 5.4 The design strength of laterally supported beam is governed by ?

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.