If you are to add another box with a mass of 5kg, how far from the pivot point should you put for the system to be in equilibrium? * 0.9m 15kg 8kg 5kg 2.2m 1.8m O 1.67 m 1.76 m O 2.47 m O 2.84 m O Correct answer not found

If you are to add another box with a mass of 5kg, how far from the pivot point should you put for the system to be in equilibrium? * 0.9m 15kg 8kg 5kg 2.2m 1.8m O 1.67 m 1.76 m O 2.47 m O 2.84 m O Correct answer not found

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A uniform rod AB of weight 500 N and length 4.0 m is supported at two points P and Q as shown below. AP = QB = 0.80 m. A man of weight 800 N is walking from Q to B. Find the maximum %3D %3D distance x from Q the man can walk before the rod topples about Q. P Q A 1 -| × |- O 0.4 m O 0.8 m O 0.75 m O 0.6 m
Kathrine lets go of a cube of mass of m = 5 kilograms on her physics demo device she created. Her cube goes down a super smooth slide surface that has a height vertical distance of h=85 cm. At the end of the slide, her cube crashes into and sticks to the lower end of a vertical pole that has a mass M=10.5 kg and length 1-2.00m. Right after the crash, the pole pivots about a hinge point near its upper end through an angle (theta) before it stops for a moment. See the image given below to visualize Katherines system. You are tasked with Figuring out the following three things The speed of her cube just before it hits the pole The angular speed of the pole just after the crash The angle (theta) through which the pole pivots a. b. C. 0 Kathrine and her device
In the figure, a small 0.131 kg block slides down a frictionless surface through height h = 0.815 m and then sticks to a uniform vertical rod of mass M = 0.262 kg and length d = 2.20 m. The rod pivots about point o through angle before momentarily stopping. Find 0. A ₂ 0
The uniform thin pole has a weight of 30 lb and a length of 26 ft. If it is placed against the smooth wall and on the rough floor in the position d = 10 ft, will it remain in this position when it is released? The coefficient of static friction is us = 0.3. B 26 ft
A thin washer of internal radius 5 cm and external radius of 12 cm carries a load of 15mC distributed evenly on its surface located on the Y axis. A small 7.5g sphere with a load of 3mC is placed exactly in the center. A small push is given along the axis of the washer (the x-axis) to remove it from rest. How fast will the sphere be moving when it is 2m from the center of the washer? (hint, ignore gravity and energy is conserved)
You place a 15 kg brick 0.5 m to the left of the fulcrum. Where on the right side would you place a 5 kg brick to place the system in equilibrium? A 0.75 m В 0.25 m 1.5 m D 1.0 m
A simple pendulum is made of a 50 cm-string anda bob of mass m. At t = 0, the pendulum is at its equilibrium position and is given an initial velocity v = 0.1 m/s. The maximum angular speed, Өтах, is: O 0.8 rad/s O 0.1 rad/s O 0.4 rad/s 0.2 rad/s O 0.05 rad/s
Two plastic toys are hung from the ends of a uniform rod of mass 20.0 g and length 0.500 m to form a mobile. If the toy on the left end has a mass of 5.00 g, while the other one on the right end is 10.0 g, where should the rod be supported as measured from its LEFT end to keep the system in equilibrium? O 0.286 m O 0.333 m O 0.214 m O 0.0357 m
A uniform bar has a length of 1m, and a mass of 5kg. If a 10 kg mass is attached to one end of the bar (at x=0), and a 30 kg mass is attached to the other end (at x=1m). The center of mass is closest to which point? x=0m x=0.3 m x=0.33 m x=0.5m x=0.67 m x=0.70 m x=1.00 m
I’ve asked this question already but the explanation didn’t make any sense Could you explain it in an easier way? ☹️
A spherical shell of radius 2.84 cm and a cylinder of radius 6.97 cm are rolling without slipping along the same floor. The two objects have the same mass. If they are to have the same total kinetic energy, what should the ratio of the spherical shell's angular speed @shl to the cylinder's angular speed weyl be? @shl 2.63 Wcyl TOOLS x10
A balance has a 5.0kg object at 0.5m from the fulcrum, and a 20.0kg object a certain ways in the opposite direction from the fulcrum. Where would the 20.0kg object need to be for the system to be balanced? Suppose you placed the 20.0kg object at 0.5m away from the fulcrum in the opposite direction of the 5.0kg object. This would result in an unbalanced system. Where could you then place a 10kg object to rebalance the system?