If Us = 23.46 kN b *250mm d= 360mm, fc =28 Mpa Gnd fy :37umm, which of the follaning is the moximum spaciny of Hhe stirrups.

Q: Why is the contractor, required to submit all data through the field office and not directly to the…

A:

Q: How is the punch list prepared?

A: A punch list can be defined as a document that is prepared when the project nears the completion and…

Q: In detail what is the CSI MasterFormat and what is listed in division 28?

A: Answer  CSI MasterFormat also known as "Dewey Decimal system" is the product of the Construction…

Q: With reference to the drawings,what is the order of precedence?

A: An order of precedence is listed to resolve any disputes that arise from the conflicts between the…

Q: Why are Construction Photographs needed?

A: There are various reason for the Need of construction photograph some of them are mentioned here:

Q: Within the preceding elements,what should be the preference order for the documents?

A: An order of precedence is listed to resolve any disputes that arise from the conflicts between the…

Q: Name 3 major stages in Design phase of a construction project

A: The objective of this question is to identify and describe the three major stages in the design…

Q: there a way to write this out so it is easier to read? thanks for you rhelp would be greatly…

A: Flexural Rigidity = 100000 N/mm2   Uniform Load over each box = 10 N/m   Spring stiffness constant,…

Q: Who monitors the shop drawings and submittals?

A: Shop drawings are design plans issued by the general contractor that are used to promote the layout…

Q: It's important to define concepts like "repository" and "modeling tool" as well as "documentation…

A: Repository: It is a storage room or place, where the construction materials are stored. The…

Q: What are master specifications?

A: Master specifications are a compilation of standardized, guide specifications or pre-written…

Q: According to CSI, how many formats are there under OmniClass to organize the construction…

A: The objective of the question is to understand the number of formats under OmniClass, their…

Q: What is a punch list and when should it be developed?

A: The objective of the question is to understand the concept of a punch list in the field of civil…

Q: What are the Scheduling Changes?

A: Scheduling in construction projects is defined as the process in which the tasks, activities and…

Q: What are the similarities and dissimilarities between RFI and shop drawings and submittals?

A: An RFI (Request For Information) is a formal request from potential vendors for basic data.

Q: Specifications

A: Specification- Specification are documents which is used to give the expiation of all building work…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.