If the resultant of the forces shown passes through point A, determine the magnitude of the unknown pulley tension T₂. The pulley is welded to the frame and is therefore not free to rotate. 0 1.6 m 285 N 0.6 m A 1.9 m 52° T₂ 1310 N 0.50 m 310 N 1.05 m 520 N

Q: In the drawing shown the loads are as follows: F1= 851 N F2= 349 N Magnitude of the tension

A:

Q: 2/68 If the resultant of the forces shown passes through point A, determine the magnitude of the…

A: For the Given system of force To determine  Unknown Tension T2 which acts on the braked pulley

Q: The link is subjected to two forces F1 and F2. Determine the resultant force and direction angle e*…

A:

Q: A belt driven pulley is attached to a shaft as shown. Calculate the magnitude and direction of the…

A:

Q: 5. A person pulls on a rope with a force of 100 lbs as shown below. What is the moment about point A…

A:

Q: Calculate the total torque produced by the forces with respect to the point o from the bar. F₁= 20N…

A:

Q: What are the tensions in each of the 4 cables supporting the lamp, if the lamp weighs 50 lbs and the…

A:

Q: A machine component is subjected to the forces and couples shown. The component is to be held in…

A: First all the forces are considered and the resultant is taken and and moment is also calculated by…

Q: n. VO ΑΣΦ 45 vec ↓↑ 7 ft F = 80 lb 3 ft B 1.5 ft of the force F about the door hinge at B. Express…

A: As per guidelines we need to answer only first question so please repost rest questions separately

Q: If the tension in cable DE is 505 N, determine the moments of this tensile force (as it acts at…

A:

Q: 1.500 kN/m 0.750 m 65 1.500 m 2.75 kN 225m 1.500m Refer to the diagram. ACD is a rigid member.…

A:

Q: Replace the force and couple moment system by an equivalent resultant force (Figure 1). Assume F₁ =…

A: Given data is

Q: Determine the angle between force FB and FE.

A: Coordinates of A,B,C,D,E with respect to given axis system,A5,0,0B0,2,3C0,-2,3D2,0,0E0,0,3

Q: Add the following forces to find the resultant force. V1 = 150 g @ 470 V2 = 550 @ 324° V3 = 350 g @…

A:

Q: | 0.5 m 0.4 m It is known that a moment with a magnitude of 200 N-m will cause rod to fail at the…

A: givenmoment with a  magnitude M=200Nm

Q: 2/88 If the resultant of the forces shown passes through point A, determine the magnitude of the…

A: