If the load is resistive, then the power factor will be O 1 Leading O Lagging

Q: 24. A sinusoidal voltage is applied to the resistive circuit in Figure 11-80. Determine the…

A:

Q: Find the frequency in hertz.

A:

Q: ave winding is suitable for voltage and enerator. D low, high O high, high low low

A: Two type of windings are used in DC machines. 1. Lap 2. Wave

Q: A Load absorbs 10 kVA at a leading power factor of 0.6. The complex power is: Select one: O a.…

A: Given,Absorbsed power, S=10 kVAPower factor, PF=0.6 leading

Q: Determine the current passing through 2 2 resistor. j42 ww (a) (b) j2 Q 4.0042- 42.32° A…

A:

Q: Find the compless power absorbed by the load.

A: This question is based on the concept of complex power drawn by a load. The load is connected across…

Q: Determine the rms current I as shown in figure 1. Source voltage is eady in RMS value (Answer must…

A:

Q: The load consists of everything to the right of nodes a and b. What is the power factor of the load?…

A: The Power factor of the RLC circuit is defined as: cosϕ=RZ Given: R=40 ΩL=47.75 mHC=31.83 μFf=200…

Q: Find current thru - j5 capacitive reactance use any method. -jsa 100/0 VA) 50 (1) 10/30A j42 1.026 -…

A: Using source transformation reduce the circuit and than using ohms law  find current in -5j…

Q: Hi the question in the photo but can you please just find the percentage voltage regulation with…

A: Explanation: load = 10 kVA load voltage (Vfl) = 240 volt Power factor = 0.78 Therefore, Load current…

Q: The load consists of everything to the right of nodes a and b. What is the power factor of the load?…

A:

Q: A synchronous machine is generating power of 2.6 MW, If the machine can deliver a maximum power of…

A: Power delivered by synchronous machine =(maximum power it can deliver) ×sin(power angle). Given…

Q: find average power of the voltage source 10Ω j10 2 -j5 -j2.4 2 j102

A: In this question , we will find average power from voltage source..

Q: In Class A chopper, if duty cycle is varied from 0 to 1, the output voltage will vary from zero to…

A: In this question, choose the correct option What is output voltage variation if duty cycle carried…

Q: What is the expected voltage drop across each load in this circuit? #doodle 6 V and 6 V 0.01 V and…

A:

Q: Add the following three phasors: 12240', 9280", 2/120' O 21262 O 252240 O 142-12 O 56284°

A:

Q: What is the value of the equivelent impedance? 250 j1SA w m 302 20 j102 51.09 +9.8j 0.46+0.21j…

A: Choose the correct option Find the equivalent impedance across the terminal as shwon in the figure.…

Q: Find the RMS Valve

A: We will solve for the RMS value of the given triangular wave.

Q: Tu netuork show in opeating in the thndy doulce. If V, = 2aes2t state wilh sinusoidal ve and V, 2…

A:

Q: For the following voltage and current waveforms, the length of the current waveform parts are equal.…

A:

Q: Obtain the magnitude of the current l, in Figure. express answer in amperes 5Ω 40/90° V τ 8Ω -j2Ω…

A:

Q: on A Load absorbs 10 KVA at a leading power factor of 0.6 The complex power is: Select one: O a…

A: The is a problem of circuits.  Given:- Load power |SL|= 10 kVA  Power factor, cos(phi)= 0.6 leading…

Q: The voltmeters in the figure measure RMS voltages. If V1 = 13 V and V2 = 3.5V what is V3? R L VI V2

A:

Q: What is the value of the equivalent admittance? 100 ww sa -20 j10 a

A:

Q: Considere un circuito LC con los siguientes valores : L de valor 100 H C de valor 0.01 µF La…

A: Consider an LC circuit with the following values:   L value 100 H C of value 0.01 μF The resonance…

Q: VBB +10 V RB 1 M2

A:

Q: VD The nectifijer shown has a punely -KSIstire houd R Dekerminc the la) efficientyns (6)peak inverse…

A: Assuming ideal diodes ,  Inputpower = load power. Vs × Is× pf = Iorms2×R Substitute all in terms of…

Q: The power factor of an alternator depends on

A: The solution is provided in the following section:

Q: If a Load absorbs 10 kVA at a lagging power factor of 0.6. Then the complex power is: Select one: O…

A: In this question , we will find complex power of load..

Q: The shunt dc generator runs, tbut there is no output voltage because of Select one Oa all mentioned…

A: In this question , we will write about voltage build up in dc shunt generator..

Q: If a Load absorbs 20 kVA at a leading power factor of 0.6. Then the complex power is: Select one: O…

A: A leading power factor means the impedance of the circuit is capacitive and causing the phase…

Q: 24. A sinusoidal voltage is applied to the resistive circuit in Figure 11-80. Determine the…

A: As per the guidelines of Bartley we supposed to answer first time subpart only for solution of…

Q: The phase measured in the clockwise direction is. O a. negative O b. positive

A:

Q: Q22. Class A chopper is supplying a DC motor with FWD, motor inductance= 6 H & resistance= 12 Q,…

A: