If the ISP switched the network over to entirely IPv6, what would they likely change about the network which uses an NAT router with as many private IP addresses as possible? (not including the obvious different address formats) If there are some routers along the path to the rest of the internet that use IPv4, can the two endpoints still use IPv6 to communicate? How?

Q: Picking the right kind of cable to link the switch and the router is crucial. Which piece of…

A: Computer networking which refers to the one it is the term for a network of connected computers…

Q: TCP requires total transparency from all participating parties, which includes almost every endpoint…

A: Given: TCP is a transport protocol. It's dependable and connected. It's utilized by HTTP, FTP, etc.…

Q: P protocol? Describe some circumstances where it might be desirable to use source routing rather…

A: Below the header overhead in the IP protocol

Q: To what end is UDP designed? It seems that having the ability for user processes to directly…

A: User Datagram Protocol (UDP):  UDP stands for User Datagram Protocol. It's a communication protocol…

Q: To what end do you feel the need to have a dedicated IP address for your private network? Is it…

A: A private IP address on a private network can provide several benefits, including:  Remote access: a…

Q: TCP requires complete openness from all peers, which means that almost every endpoint OS must…

A: Given:   We have to discuss TCP requires complete openness from all peers, which means that almost…

Q: Pv4 and IPv6 are two different protocols. Hence, the packet structures are unidentical. Some of the…

A: IPv4 and IPv6 are two different protocols. Hence, the packet structures are unidentical. Some of the…

Q: Please use YOUR OWN MODEL -- not somebody else's. Using TCP/IP model: Create all parts of a IPv4…

A: 1. Preface It is a 7 byte field that contains an example of exchanging 0's and 1's.It alarms the…

Q: What is IP class and number of sub networks if the subnet mask is 255.224.0.0?

A: Introduction :Given , An IP subnet mask : 255.224.0.0.we have to find IP class and number of sub…

Q: Using both TCP and UDP, which of the following protocols is it?

A: Start: However, it is usual practise to utilise the same service on the same port number every time.…

Q: A TCP segment consisting of 1460 bytes of data and 20 bytes of header is sent to the IP layer, which…

A: We need to convert the bytes into bits for simplicity. See below steps.

Q: Suppose there are two ISPS providing WiFi access in a particular café, with each ISP operating its…

A: The Answer start from step-2.

Q: Given a scenario where there are two ISPs each running its own Access Point, and each using its own…

A: Step 1 The answer for the 1st and 2nd question is given in the below step;

Q: In a network that uses IPV4, 1/ what prefix would best fit a subnet containing 100 hosts?

A: Prefix /25 means that 7 bits are reserved for the host address range, which is (2)7-2=126. This is…

Q: What happens to the MAC addresses of packets when they transit across networks? What happens to IP…

A: Introduction: A MAC address is a binary number that is used to identify computer network interfaces…

Q: Suppose there are two ISPS providing WiFi access in a particular café, with each ISP operating its…

A: A) The two APs will typically have different SSIDs and MAC addresses.A wireless station arriving at…

Q: Find out how many IPv4 addresses are available overall. IPv4 names have been given more time to grow…

A: IPv4 is the latest iteration of the Internet procedure, the backbone knowledge that enable devices…

Q: If a packet arrives at the IP layer with destination IP=255.255.255.255, TTL=1, and Upper-layer…

A: The internet layer is just a set of internetworking techniques, standards, and specifications inside…

Q: What happens to the MAC addresses of packets when they move from one network to another is a…

A: ans is given below:

Q: a) Why does IPv4 reassembles fragments at the endpoint, rather than at the next router with high…

A: It involves breaking down the packet into smaller fragment so that it can be transported through…

Q: Consider an IP packet with datagram of size 850 bytes. This packet will be forwarded on the link…

A: According to the given question, it is required to determine the number of fragments. The detailed…

Q: How many IPv4 addresses are there in total? The IPv4 address's lifespan has been extended through…

A: We need to write the number of IPv4 addresses in total. Then, we need to discuss if we need to…

Q: TCP requires total transparency from all participating parties, which includes almost every endpoint…

A: Given: Transmission control protocol, often known as TCP, is a protocol that operates on the…

Q: that a router is directly attached to an IP subnetwork with address a.b.c.d/k where a.b.c.d is the…

A: In this question, we are going to explore how a router determines whether an IP packet is destined…

Q: ATCP message consisting of 2100 bytes is passed to IP for delivery across two networks. The first…

A: Introduction :Given , TCP packet size = 2100 Byte Network 1 can carry = 1200 byte / frame Network 2…

Q: IP hosts that are not designated routers are required to drop packets misaddressed to them, even if…

A: A would be inudated with the multiple copies the packets if the same host address is arrived at a…

Q: It was said that IPv6 handles the IPv4 tunnels as link-layer protocols while using IPv4 routers.…

A: Tunneling is a protocol for safely transmitting data from one network to another.

Q: Q3: If a routing table of a router is depicted by the following table, what is the next hop for a…

A: A routing table is provided for the information.

Q: Determine the total number of usable IPv4 addresses. More time has been allocated to IPv4 addresses…

A: IPv4 (Internet Protocol Version 4) addresses are 32 bits long and were initially considered ample…

Q: You want to implement a mechanism that automates the IP configuration, including IP address, subnet…

A: 1) The DHCP(Dynamic Host Configuration Protocol) is a network management protocol based on client…

Q: Given a scenario where there three routers R1, R2 and R3. R1 is connected to Switch1, then Switch1…

A: The solution for the above-given question is given below:

Q: RFC 791 describes the Internet Protocol and includes two options for source routing. Describe three…

A:

Q: TCP requires complete openness from all peers, which means that almost every endpoint OS must…

A: Transmission control protocol, often known as TCP, is a protocol that operates on the transport…

Q: Choose the routing protocol that most resembles BGP between OSPF and RIP. Why?

A: OSPF (Open Shortest Path First) is the routing protocol that most resembles BGP (Border Gateway…

Q: A 1000-byte IP datagram arrives at the router. This packet must be sent by the router to a network…

A: IP Datagram size = 1000 bytes MTU(Maximum Transmission Unit) = 100 bytes IP Header size = 20 bytes…

Q: What happens to the MAC addresses of packets when they move from one network to another is a…

A: Here is tha answer which is given below   :