Answered: if the head of the water is 3.2 m

Engineering

Civil Engineering

if the head of the water is 3.2 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3. Under a constant head of 3.2 meters, water flows through an orifice on the vertical side of a huge tank. 1 m below the orifice, how far horizontally from the vena contracta will the jet contact the ground?
A vertical circular tank that is 1,5 m high, has sloping sides. The tank is 50 m and 30 m in the top and bottom diameters respectively. Discharge takes place through a triangular orifice situated at the bottom of the tank. The orifice has a base of 0,8 m long, 0,5 m below it's vertex. If the tank is originally full of water, what time is required to empty the tank? Take discharge coefficient as 0,63.
A cylindrical tank 1m in diameter and 6m high contains 2m of water, 1.50m of oil (specific gravity = 0.8) and air under pressure of 20 KPa. If the 10cm diameter orifice located at the vertical side is 30 cm above the bottom of the tank, find the actual discharge at the orifice if C = 0.95.
A vertical circular tank that is 1.5 m high, has sloping sides. The tank is 50 m and 30 m in the top and bottom diameters respectively. Discharge takes place through a triangular orifice situated at the bottom of the tank. The orifice has a base of 0.8 m long, 0.5 m below its vertex. If the tank is originally full of water, what time is required to empty the tank? Take discharge coefficient as 0.63 Show all formulas and values that are substituted PLEASE
A pontoon 6m x 6m x 3m floats in water with a draft of 2m. The orifice at the bottom of the pontoon is 160mm in diameter with a coefficient of discharge of C= 0.60. Determine the time required for the pontoon to sink its top after opening the orifice at the bottom.
SITUATION 4: Water is drained from a large reservoir using two horizontal pipes connected in series. The first pipe is 20 m long and has a 10-cm diameter, while the second pipe is 35 m long and has a 4- cm diameter. The water level in the reservoir is 18 m above the center line of the pipe. The pipe entrance is a sharp edged, and the contraction between the two pipes is sudden. Neglecting the effect of the kinetic energy correction factor, determine the discharge rate of water from the reservoir. Assume the friction factor for all pipes is equal to 0.02 and the loss coefficient is 0.05 for a sharp edged entrance, and is 0.46 for sudden contraction. 18 m Oil tank 20 m 35 m
A horizontal jet of 57 liters/sec strikes tangentially on one or another of a series of moving curved vanes, each having a deflection angle of 60 degrees. The water as it leaves the vane has an absolute velocity of 12 m/sec and makes an angle of 30 degrees with the horizontal. (a) Determine the horizontal force exerted on the vanes. (b) Determine the power developed.
Two conical vertical tanks with the same radius of 2m are connected by a pipe line 7.5cm in diameter and 8m in length. The bigger tank with an altitude equal to 3.5m is initially full of water while the smaller tank with an altitude of 2m is empty. If the pipe valve is open to allow water to flow from the bigger tank to the smaller tank until it is full, find the height of the water remaining in the bigger tank.
Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe length is 100 m. If the water pressure needs to be at a pressure of 1.6 atm on a lower level. What should be the different in elevation between the upper and lower levels in order to achieve this pressure? Take the density of water 1000 kg/m3 and gravity is 9.81 m/s2, consider the energy loss.
2.) A 90-mm circular orifice is situated 0.5 m from a bottom of a closed cylindrical tank 4 m high contains 2.5 m of water. In order to discharge water at 11 hp, what pressure of air (kPa) is required to be maintained in the air space?
A 50 mm diameter siphon discharges water from a reservoir (Point 1 elev = 20m) into open air (Point 3 elev. 10m). The head loss from the reservoir (point 1) to the summit (point 2 elev = 28m) is 3 times the velocity head in the siphon and head loss from the summit to the discharge end is 4 times the velocity head in the siphon. Determine the velocity in the siphon in m/s? 3 The correct answer has a margin of 0.05 from the exact answer. TOCUL T OWCT. 7:13 PM 27°C Rain showers 入口の ENG 04/10/2021
The jet on a water feature shoots a column of water H = 23 m high. The nozzle is located just above the surface of a reflecting pool and has a diameter of 2 cm. A submersible pump with a 15cm diameter exit pipe and a 30 cm diameter inlet pipe located D= 50 cm below the surface of the pool operates the jet. For this configuration, find the pressure [kPa] at a point at the pump intake (A). Nozzle Outlet Pipe A° Pump Inlet Pipe H