IF the Flow rate through the Pump 0.1 mls of water, Find the Punp head.The manometer reading is 100 cm Hg. given that the suction Side diameter ir

Q: 7. A lubricating oil of viscosity 0.1 Ns/m² and SG of 0.9 is pumped through a 30 mm diameter pipe.…

A:

Q: While attempting to extinguish a fire, firefighters are holding a nozzle at the end of a hose. If…

A:

Q: The laminar flow of a Newtonian fluid between parallel plates is illustrated in the below figure.…

A: Consider the laminar flow of a Newtonian fluid flowing between the two plates. The total gap between…

Q: Q2 // The diameter of a pipe at section 1 and 2 are 10 cm and 15 cm respectively. Given velocity of…

A: Given that, The diameter of the pipe at section 1 D1 = 10 cm = 0.1 m The diameter of the pipe at…

Q: For a flow over a flat plate the normalized velocity profile is --² where y is in mm 2 U a)…

A: Answer: a) we know that, Displacement Thickness = δ* = ∫0δ (1- uU) dy  Displacement Thickness = δ* =…

Q: 1-Water with kinetic viscosity v-0.494 mm2/s flow through a pipe with diameter 18mm with velocity…

A: Kinetic viscosity = 0.494 mm2 /sdiameter = 18 mm V= 0.1 m/sf  = 0.03 mm

Q: Oil of density 936 kg/m³ and kinematic viscosity 100 mm²/s is flowing in a horizontal circular pipe…

A: Given Data : Density of oil (ρ) = 936kgm3Kinematic viscosity (κ)=100 mm2s=100×10-6m2sDiamter (D) =1…

Q: Determine the Reynolds number for a flow of water at 25 ° C in a lin diameter sanitary pipe at a…

A: At Temperature = 25 C  Properties of water Density= 997 Kgm3 Viscosity, u =8.90 × 10−4  Pas mass…

Q: For the water flow at 20 °C, use the manometer measurement to estimate the (a) centerline velocity…

A:

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: The velocity profile of a fluid in a horizontal circular pipe having a radius R is found as; Vz =0.4…

A: Given data: Velocity profile for a fluid in a circular horizontal pipe is given by the following…

Q: Q3: The flowrate of a fluid in a pipe is measured using a pitot tube which gives a pressure…

A: Perform force balances for streamline flow in pipe:

Q: There is a drop in the bubble with the diameter of 10mm and pressure of 250 KN/m?. If the surface…

A: In fluid mechanics, surface tension is defined as the property of the surface of a liquid allows it…

Q: 13.1 Anoil with kinematic viscosity of 0.08 x 10-3 n2/s and a density of 57 lbn flows through a…

A: The flow in the tube is assumed to be fully developed. It is assumed to be a steady-state condition.…

Q: 4. Water flows through a smooth horizontal 2 m long tube of 2 mm diameter with an average velocity…

A:

Q: At what distance from the leading edge of a flat surface will the transition from laminar to…

A: Dear User ,According to Bartleby policy , we can answer only 3 subparts of a question , kindly post…

Q: Unit for mass flow rate and molar flow rate

A: The mass flow rate is defined as the differential mass of the fluid flowing per unit of time. The…

Q: 10 ft 10 ft Very large Water 3-in steel pipe FIGURE 6.25 Tank draining by gravity, with pipe and…

A: Water is flowing from the bottom of a tank via 3 in steel pipe. Volumetric flow rate is to be…

Q: Calculate the kinetic energy changes

A:

Q: 1. An oil having a density of 1200 kg m3 and a viscosity of 0.02 Pa s flows through a 25 mm diameter…

A: It is to be mentioned whether the flow of oil is laminar or turbulent.

Q: Water at 20°C flows in a cylindrical pipe with internal diameter of 2 cm. At what critical fluid…

A:

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: measures local or point velocities by measuring the pressure difference between the total pressure…

A: We have to answer which instrument is used to measure the point or local velocity by measuring the…

Q: Paddle agitator

A:

Q: In the Figure.Q3, The energy decline of the connections and the pipe before the pump is 3m.…

A:

Q: State the Navier-Stokes equation for the case of three-dimensional flow and give the uses of…

A: --> Give the navier- Stokes equation for three dimensional flow. --> uses of navier- stocks…

Q: 24. Obtain the equation of motion for a one-dimensional, inviscid, unsteady. compressible flow in a…

A: Area of cross section of pipe is constant.Fluid flowing through the pipe is one dimensional,…

Q: The U tube shown is rotated about the left vertical leg at 30 rpm. The pressure at point A is…

A:

Q: calculate the largest discharge for which the flow will be definitely laminar Water flows in a 2 cm…

A: This question is based on fluid mechanics. The flow in consideration is Laminar flow. Data given :…

Q: A fluid is flow through a pipe with velocity 3 m/s of diameter 1 meter and viscosity is 2 Pa s if…

A: Given  Diameter of pipe D =1 m Velocity of fluid through pipe V = 3m/s Density of fluid d = 800…

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: As shown in the figure, the manometer reading is 15 cm of mercury when the tank is empty (water…

A:

Q: 9. The fixed parallel plates kept at 80 mm apart have laminar flow of oil between them with a…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The power of viscosity correction factor is for laminar flow.

A: Consider the laminar flow of a fluid in the thermal and hydrodynamic entrance region. The viscosity…

Q: The volume flow rate,Q over a V-notch depends on fluid properties namely density, kinematic…

A: Volumetric flow rate of over a V-notch depends on given fluid properties.

Q: 4. Consider two-dimensional, laminar, unidirectional flow between parallel (spacing: 2h), vertical…

A: Distance between two parallel plates = 2h Two dimensional, laminar, and unidirectional flow takes…