If the current through the diode is 1µA when 25V is applied across it, what is the bias condition by its resistance value (R)? Reverse bias since R is 25MΩ Reverse bias since R is 40GΩ Forward bias since R is 40KΩ Forward bias since R is 25MΩ

Q: 15 V Si V; R R Vo O A) 9.3 V O B) 10 V C) 10.7 V O D) -10 V E) 20 V

A: Given data, The above circuit is clipper circuit. Vmax = 15 V. V = 5 V.

Q: Assume each diode to be OFF when V₂ ≤ 0.7V and ON when VĎ >0.7V. Find iD1, İD2, İD³, and vō in each…

A: Given:a circuit,when , the diode is off. when , the diode is on. Find:iD1, iD2, iD3 and v0.

Q: A center-tapped FWR circuit have an output dc voltage of 51 V. What is the PIV rating for the diodes…

A: In this question we will find peak inverse voltage rating of diode in center tapped full wave…

Q: A si diode has reverse saturation current of 2.5 micro amp at 300k find forward voltage for a…

A: Given data : Forward current ID=10 mASaturation current Is=2.5 μA For silicon diode VT=25.9VAbsolute…

Q: With the Zener diode in the "on" state, IR increasing I will Iz and IR R Vz RL Vị

A: Currents in the zener diode circuit

Q: What is wrong with this dioce? XMM1 Short Not enough data O Nothing O Open 12 IDEAL DIODE…

A: For the given circuit diagram we need to find its correctness.

Q: Solve for the values of Vo and Id if diode is a ideal diode.

A:

Q: Light emitting diodes are diodes that Lutfen birini seçin: none of these. emits light naturally…

A:

Q: 6. Determine V, I, Ip, and Ip, for the parallel diode configurati 0.33 k2 R E- 10 V DSi D; Si V

A:

Q: V1 0.1V 01 0.097u DC 1e-090hm DC 10MOhm 0.1 U2 D1 1N4001G *** G

A:

Q: When a diode is reverse-biased and the bias voltage is increased, the reverse current (assuming the…

A:

Q: the forward voltage drop across a silicon.diode is about * O 2.5 v 0.7v 3v

A: To charge a battery from AC supply or convert AC into DC rectifier (converter) circuits are used.…

Q: The reverse saturation current of a diode at 25°C is 1.5 x 10-9A. What will be the reverse current…

A: We need to find out reverse saturation current at given temperature

Q: 5 k2 IL 80 – 120 V 50 V 10 k2

A:

Q: The reverse saturation current of a diode at 25°C is 1.5 x 10-9A. What will be the reverse current…

A: SOLUTION Given=>              Temprature   T1 = 250C…

Q: The average value of the half wave rectified waveform shown below is 50 V OV 5 V O 25.1V 15.9 V 50V

A:

Q: RLIMIT 1.0 k2 VBIAS 10 V

A: Given circuit shown

Q: What is the dynamic resistance of a diode if its ID = 1.87 mA?

A: At room temperature the dynamic resistance of diode is given as rd=( 26mV/ID) , for Ge and rd=…

Q: To forward bias a silicon diode with a -71.6 V anode voltage, apply a cathode voltage. +72.3 V…

A: given here anode voltage of a diode and asked to find the cathode voltage of the diode.

Q: Determine the state of diode for the circuit shown and find ID, VD. Assume simplified model for the…

A:

Q: What can you say about state of diodes 1, 2, 3 in the picture?

A: => Anode terminal voltage of diode D1 is less than cathode terminal voltage. Otherwise cathode…

Q: It will keep the VL voltage on the RL at 8v and will not exceed the maximum power of the zener…

A: Given  Vz = 8 V  Pzmax = 400 m Watt  Zener diode is ideal hence minimum zener current is considered…

Q: Given Vi=20V peak-to-peak, draw the output wav eform for the said clamper circuit below: Vi Vo 5V…

A: The clamper circuit is shown below:  The above clamper circuit is a positively biased clamper…

Q: For the circuit shown, what is the voltage Up across the Zener diode with a breakdown voltage vz 10…

A:

Q: For the diode circuit shown below, indicate the ON/OFF condition for all the diodes given VA and VB…

A: Given Circuit:Table of inputs:VAVB000444To determine:Output voltage for each case

Q: IN=IV (=± K I W set Sve Jo +

A:

Q: Show the output voltage for the input voltage Vi in the figure by plotting it over a period. (Note:…

A:

Q: Determine the output waveform. Use ideal diode. 15V Vo 7V -15V| 37Vi 30V| 23v 7V -7V -30V A В C D…

A: Diode conducts when anode voltage greater than cathode voltage and ideal diode maintains zero…

Q: solve for the current of diode x and z solve for the power consumed by the silicon diodes

A:

Q: Determine the biasing of silicon diode in figure A shown below and draw equivalent circuit based on…

A: Determine the biasing of silicon diode in figure A shown below draw equivalent circuit based on…

Q: •Vss =5 V and R=0.5 km ,For the shown circuit Vss 文 vp :The diode current is A 1.5 mA 8,5 mA 20

A: Fig: Given circuit  In the given circuit diode is forward bias  Assume that voltage drop…

Q: Select one: a. None of the answers O b. 2 diodes are reversely biased O c. the 10K resistor can not…

A:

Q: 2.2kQ 01 02 03 12 V R1 21ks

A: Calculate the voltage across R1 assuming no diodes are connected to the circuit. V=11+2.2×12 VV=3.63…

Q: In the complete diode model, the forward dynamic resistance is taken into account O the reverse…

A:

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.