If the blood flow requirements in a resting state are 6.8 L min-1 and the the hydraulic power of the left ventricle is 1.8W, what pressure is required to obtain the required flow rate. How does this compare with the recommended safe blood pressure limits? If the typical resting volume of the left ventricle is 83 mL, and its efficiency is 76.5%, what heart rate is required?

If the blood flow requirements in a resting state are 6.8 L min-1 and the the hydraulic power of the left ventricle is 1.8W, what pressure is required to obtain the required flow rate. How does this compare with the recommended safe blood pressure limits? If the typical resting volume of the left ventricle is 83 mL, and its efficiency is 76.5%, what heart rate is required?

Related questions

Q: Suppose that the aorta has a radius of about 1.25 cm and that the typical blood velocity is around…

Q: A Venturi tube is used to measure flow rate of 37 l/s. Tube diameter is 125 mm and throat diameter…

A: We are given flow rate of water. We convert the flow rate from L/s to m3/s. We are given diameter of…

Q: 4.16 Consider a reaction turbine with inlet and outlet diameters of 2 ft. and 8 in., respectively.…

Q: A COVID patient in ICU is injected with IV intravenous fluid. The IV flows from a raised bottle to…

Q: A pump pumps water from a cistern into an empty water tank 10.0 m high. In 5.00 minutes the pump…

A: Given: h=10m, t=5m=300s, V=1200l=1.2m3 (a) The density of water is : ρ=1000kg/m3 The pressure that…

Q: A pump pumps water from a cistern into an empty water tank 10.0 m high. In 5.00 minutes the pump…

Q: L (a) The heart pumps blood into the aorta at a rate of 4 . Calculate the average speed of blood if…

A: (a) To calculate the average speed of blood in the sorte, we can use the formulaVabode =WhereVend is…

Q: If the viscosity of blood is 2.1 x 10^-3 pa.s, and capillary of 100 um radius has a length of 4cm ,…

A: The formula of the fluid resistance is R =8 η Lπ r4 where, L is the length and r is the radius and…

Question

If the blood flow requirements in a resting state are 6.8 L min-1 and the
the hydraulic power of the left ventricle is 1.8W, what pressure is required to obtain
the required flow rate. How does this compare with the recommended safe
blood pressure limits? If the typical resting volume of the left ventricle is 83 mL,
and its efficiency is 76.5%, what heart rate is required?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Solution

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

The left ventricle of a resting adult's heart pumps blood at a flow rate of 87.0 cm3/s, increasing its pressure by 110 mm Hg, its velocity from zero to 25.0 cm/s, and its height by 5.00 cm. (All numbers are averaged over the entire heartbeat.) Calculate the total power output of the left ventricle. Note that most of the power is used to increase blood pressure. Additional Materials O Reading
A room has a width of 14.1 feet, a length of 15.5 feet, and a ceiling height of 12.0 ft. The average flow rate for this room's air conditioning unit is 3.07 m^3/s. How many SECONDS will it take for the air conditioner to cycle the volume of air in the room?
Verify that work input equals work output for a hydraulic system assuming no losses due to friction. Do this by showing that the distance the output force moves is reduced by the same factor that the output force is increased. Assume the volume of the fluid is constant. What effect would friction within the fluid and between components in the system have on the output force? How would this depend on whether or not the fluid is moving?
The IV system shown below contains whole blood at a height of 0.857 m. Determine the gauge pressure (in psi) at the injection point [round your final answer to two decimal place]. 1 atm= 14.7 psi 1 atm = 1.013x105 Pa I atm = 760 mmHg h Density of whole blood = 1,060 kg/m³
Exercise 2: Ventilation Requirements. In order to calculate the quantity of ventilation air needed for habitation, we need considering: V The CO, production P m3/s, and for this example, of a sedentary adult. V The concentration Cs% of CO,% in outdoor air, and V The maximum threshold CO, concentration Cr% for the occupied space. Normally, P = 4.7x10-6 m³/s per person, Cs =0.03% and Cr =0.5%. %3D If the flow rate, Q m³/s is the rate of fresh air flowing through a room to provide acceptable conditions, a CO, balance can be made.
Assume that a raindrop has a volume of 0.05 cm^3 and you need an Avogadro's number of raindrops to fill up the cubic water tank. What is the length of the edge of the tank?
1. Find kinetic energy per cubic meter of flowing blood (V =1 m') in aorta for individual at Q = 5 liter/min, radius of aorta 1 cm. The density of blood is rest. Suppose flow rate is about p-1.05-10' kg/m. R =
If cholesterol buildup reduces the diameter of an artery by 22 %%, by what %% will the blood flow rate be reduced, assuming the same pressure difference?