If the allowable bending stress is 124.66 MPa, compute the safe concentrated load that it could carry at its mid span besides the uniform load. Determine if the section is compact, non-compact or slender

Q: Describe procedure and uses of The SPT-T.

A: The SPT-T test is the standard penetration test with respect to the additional torsional…

Q: Explain the basic components and procedure for SPT-T.

A: In cohesionless soil the standard penetration test (SPT) is used. This test used to obtain the…

Q: Identify the two different subsystems with regards to plumbing systems.

A: Answer:- Plumbing System:- For the distribution and use of drinkable or potable water and the…

Q: What does the pacer test look for?

A: Answer -  Aerobic capacity, which is defined by endurance, performance, and fitness, is what the…

Q: What are some ways and materials contractors can use to improve noise levels in condos, office…

A: Acoustic Insulation: Installing sound-absorbing materials within walls, floors, and ceilings…

Q: A project can attain LEED silver certification if it does not achieve Storage & Collection of…

A: Answer:- LEED:- LEED stands for Leadership in Energy and Environmental Design. LEED is green…

Q: Assess mechanisms of failure and deterioration in historic buildings

A: There are following mechanism which cause deterioration in historical buildings .

Q: FAR/AMT Part 65 According to FAR Part 65, what are the privileges and limitations of the Airframe…

A: Airframe rating:It is issued to repair stations for the maintenance and the alterations on…

Q: List two methods of hazard identification used in industries.

A:

Q: Discussion on Serviceability Limits Affecting Durability

A: Introduction- Serviceability is a term used in civil and structural engineering to describe the…

Q: For the cases listed below, identify which will use an importance factor Ip = 1.5 for non-structural…

A: The component importance factor, IP, shall be taken as 1.5 if any of the following conditions apply:…

Q: Determine the number of studs 16" o.c. needed for each of the following wall segments of buildings:…

A: Studs is the vertical member used in the construction of wall framing,  Formula to calculate the…

Q: What does the pacer test look for?

A: Answer - The PACER fitness exam is an excellent method for encouraging kids to love exercise. It…

Q: a) availability; (b) maintainability; (c) condition monitoring.

A:

Q: Using Nscp 2015 Hint answer 145mm,205mm,270mm,140mm

A: Based on the assumptions made, the numbers (145mm, 205mm, 270mm, 140mm) could represent various…

Q: Describe how a septic tank and leach field treat sewage and wastewater.

A: Septic tank follows Natural microbial mechanism to treat the sewage and wastewater In Septic tank,…

Q: Discuss the significance of wireframing and prototyping in the planning phase.

A: We need to explain significance of wireframing and prototyping in the planning phase.

Management of Materials

Materials form the basic ingredient or the raw supplies before the final product. Materials cover the inventory storage in typical warehousing. All manufacturing processes and production processes require different materials.