If I have an input sine wave in a peak detector circuit I know the output the the first op amp (that will feed back into the negative terminal) should be a little larger than the input (this is why you add a second op amp). I'm not understanding it graphically. Splitting up the circuit say you have the first op amp and the diode (no capacitor or second op amp). the output should be only the positive part of sine wave, and the amplitude will be the amplitude input minus .6V from the diode drop, right? Then adding the capacitor it keeps the same amplitude but makes more DC. with the second op amp this makes it so the capacitor doesn't discharge (which is what keeps the voltage proper up I think?) With my logic here, the voltage feeding back into the first op amp negative terminal is the voltage input, minus a diode drop. So Vin > V- (voltage feeding back into the negative terminal). Which I'm pretty sure V- is supposed to be larger. So I think I'm misunderstand something here. Please correct any of my explanation or add anything I'm that would explain voltage in vs voltage out of a peak detector if you were feeding in like a constant sin wave.
Power Amplifier
The power amplifier is an electronic amplifier designed to maximize the signal strength of a given input. The input signal strength is enhanced to a high enough level to drive output devices such as speakers, headphones, RF (Radio frequency) transmitters, etc. Unlike voltage / current amplifiers, the power amplifier is designed to drive core loads directly and is used as a storage block in the amplifier series.
Maximum Efficiency Criterion
In every field of engineering, there is a tremendous use of the machine and all those machines are equipped for their popular work efficiency so it very much important for operation engineers to monitor the efficiency of the machine, planning engineers to check out the efficiency of the machine before installing the machine and design engineers to design machine for higher efficiency than and then the utility will procure their products that will ultimately lead to profit and loss of the company. It indicates the importance of efficiency right from the initial stage as manufacturing units, intermediate stage as planning coordinators, and end-users stage as a utility.
If I have an input sine wave in a peak detector circuit I know the output the the first op amp (that will feed back into the negative terminal) should be a little larger than the input (this is why you add a second op amp). I'm not understanding it graphically.
Splitting up the circuit say you have the first op amp and the diode (no capacitor or second op amp). the output should be only the positive part of sine wave, and the amplitude will be the amplitude input minus .6V from the diode drop, right?
Then adding the capacitor it keeps the same amplitude but makes more DC. with the second op amp this makes it so the capacitor doesn't discharge (which is what keeps the voltage proper up I think?)
With my logic here, the voltage feeding back into the first op amp negative terminal is the voltage input, minus a diode drop. So Vin > V- (voltage feeding back into the negative terminal). Which I'm pretty sure V- is supposed to be larger. So I think I'm misunderstand something here. Please correct any of my explanation or add anything I'm that would explain voltage in vs voltage out of a peak detector if you were feeding in like a constant sin wave.
Step by step
Solved in 3 steps with 1 images