If aquifer hydraulic conductivity, hydraulic gradient and effective porosity are found 0.4 m/day, 0.05 and 0.3 respectively, calculate total discharge (Q) across the northern si of the map? The aquifer lower boundary is horizontal and always has a (-11) m elevation Note: Q = K.A.G (Q = must be a number in m3/day, e.g. 23405 m3/day or 23405)

Q: 8. Known:Rectangular Hydraulic •Q = 18 m^3 /s •channel, 3 m wide • Unfinished form concrete channel…

A:

Q: 1) Find the rate of flow in m³/sec/m (at right angles to the cross section shown in Figure 7.33)…

A: Given two stand pipes/piezometers installed at two points along the flow in  a permeable medium. The…

Q: .Hydraulic jump occurs in a 4 m wide rectangular channel. Discharge in channel 7.5 m^3 /s, hydraulic…

A: Given data: Width of the channel (b) = 4m Discharge through the channel (Q) = 7.5 m3/s Depth of…

Q: Water flows through a fully confined sand aquifer with a piezometric head gradient of 0.025. (a)  If…

A: Given   head gradient = hydraulic gradient  i=0.025and hydraulic conductivity   K=1.72 m/dayporosity…

Q: Name the two types of groundwater aquifers. Describe how they differ.

A: "Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An earth dam is shown in (Figure 1). Determine the seepage rate, q, in m³/day/m Length using…

A:

Q: Drawdown in the pumping test refers to: a) The amount of water level decline in a well due to…

A: The ground water which is stored between the rocks are called as aquifer. The aquifers are…

Q: A confined aquifer is 18.5 m thick. The hydraulic head drops 2.99 m between two wells that are 823 m…

A:

Q: shown below, water flows from A to junction J at a flow rate Q1 = 0.70 m³/sec. The reservoir/Node…

A: Elevation of reservoir A, Elevation of Node J, Diameter of pipe 1, Hazen's Williams Constant,…

Q: The seepage loss in cm²/sec for a hydraulic structure, if the flow net contains 5 flow lines and 9…

A: This question is related to the Soil Mechanics.

Q: equivalent horizontal and vertical hydraulic

A: Given :   To find: Equivalent Horizontal and vertical conductivity

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.