Answered: If an AC source has instantaneous…

If an AC source has instantaneous voltage given as V(t) = 13v Sin(120Tnt) is connected to 6.5 Q resistor, then the value of the maxi current is, Select one:

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter21: Alternating-Current Circuits And Electromagnetic Waves

Section: Chapter Questions

Problem 1P: (a) What is the resistance of a light bulb that uses an average power of 75.0 W when connected to a...

See similar textbooks

Related questions

Q: In an RC series circuit, the EMF is € = 12.0 V, the resistance = 1.6 MQ and the capacitance = 3.4…

A: In the question, For a series RC circuit, resistance of the resistor is R=1.6MΩ=1.6×106Ω The…

Q: A resistor dissipates 2.00 W when the rms voltage of the emf is 10.0 V. At what rms voltage will the…

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = h, R…

A: Given: L=5/3 H, R=10 ohms. C= 1/30 F , E(t) =600 volts initial charge and current =0

Q: Consider the RLC circuit shown below, where the initial current flowing through the circuit at time…

A: Given that the RLC circuit where the initial current flowing through the circuit at time t = 0 is…

Q: An RC circuit has R=6.7k02 and C= 2.0 μF. The capacitor is at a voltage Vo at t=0, when the switch…

A: Concept: To determine the time taken by the capacitor to discharge to 1.0% of the initial value, we…

Q: What maximum current is delivered by an AC sourcewith ΔVmax = 48.0 V and f = 90.0 Hz when connected…

Q: A voltmeter and an ammeter are used to respectively monitor the voltage across and the current…

Q: The circuit below shows an AC power supply connected to a resistor R = 22.4 0. ΔΙ', R w max @ The…

Q: The circuit below shows an AC power supply connected to a resistor R 20.2 0. AV R w ( The current…

Q: Consider two identical simple RC circuits each composed of a capacitor (2.30 mF), a resistor (27.0…

A: Given that:- Capacitance of capacitor=2.3mF Resistance of resistor=27k ohm

Q: A series RLC circuit has a peak voltage of 11 v and a peak current of 2.00 A. If the current lags…

Q: A voltmeter and an ammeter are used to respectively monitor the voltage across and the current…

A: Given

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 5 1.…

A: Given a LRC series circuit L=5/7h R=10ohm capacitor C=1/70f E(t) =350V We have to find maximum…

Q: A) For the regulation circuit in Fig. below, if {Vz = 5 volt, Rz=11 (Q, (Iz+Iz)=0.2A & the…

A: We look into the property of a Zener diode a little and then go on to apply Kirchhoff's circuit law…

Q: An a.c voltage source has an output of (2.0x10^2V)sin2πft. The source is connected to a 1.0x10^2 ohm…

A: Given that the expression of voltage source and the value of resistor. Then We have to determine the…

Question

If an AC source has instantaneous voltage given as V(t)
13v Sin(120Tt) is connected to 6.5 Q resistor, then
the value of the maxi current is,
Select one:
O a.
13 A
O b. 84.5 A
O c.
0.5 A
O d. 2 A
Next page
cess
Exam
File Upload - Final
Jump to...
Exam
Caid Ah

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
In this chapter, most examples and problems involved direct current (DC). DC circuits have the current flowing in one direction, from positive to negative. When the current was changing, it was changed linearly from I=ImaxtoI=+Imax and the voltage changed linearly from V=Vmax to V=+Vmax where Vmax=ImaxR .Suppose a voltage source is placed in series with a resistor of R = 10 that supplied a current that alternated as a sine wave, for example, I(t)=(3.00A)sin(24.00st) . (a) What would a graph of the voltage drop across the resistor V(t) versus time look like? (b) What would a plot of V(t) versus I(t) for one period look like? (Hint: If you are not sure, try plotting V(t) versus I(t) using a spreadsheet.)
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
(a) When the switch S in the circuit of Figure P28.14 is closed, will the equivalent resistance between points a and b increase or decrease? State your reasoning. (b) Assume the equivalent resistance drops by 50.0% when the switch is closed. Determine the value of R.
A 20.00-ohm; 5.00-watt resistor is placed in series with a power supply, (a) What is the maxim tun voltage that can be applied to the resistor without hanniug the resistor? (b) What would be the current through the resistor?
Find the current through a person and identify the likely effect on her if she touches a 120-V AC source: (a) if she is standing on a rubber mat and offers a total resistance of 300 k; (b) if she is standing barefoot on wet grass and has a resistance of only 4000 k .
Figure P29.60 shows a simple RC circuit with a 2.50-F capacitor, a 3.50-M resistor, a 9.00-V emf, and a switch. What are a. the charge on the capacitor, b. the current in the resistor, c. the rate at which the capacitor is storing energy, and d. the rate at which the battery is delivering energy exactly 7.50 s alter the switch is closed?
Currents of approximately 0.06 A can be potentially fatal. Currents in that range can make the heart fibrillate (beat in an uncontrolled manner). The resistance of a dry human body can be approximately 100 k . (a) What voltage can cause 0.06 A through a dry human body? (b) When a human body is wet, the resistance can fall to 100 . What voltage can cause harm to a wet body?
Find the current through a person and identify the likely effect on her if she touches a 120-V ac source: (a) if she is standing on a rubber mat and offers a total resistance of 300 k (b) if she is standing barefoot on wet grass and has a resistance of only 4000 k .
A 500- resistor, an uncharged 1.50-F capacitor and a 6.16-V emf are connected in series, (a) What is the initial current? (b) What is the RC time constant? (c) What is the current after one time constant? (d) What is the voltage on the capacitor after one time constant?
Integrated Concepts (a) An immersion heater utilizing 120 V can raise the temperature of a 1.00 102 -g aluminum cup containing 350 g of water from 20.0°C to 95.0°C in 2.00 min. Find its resistance, assuming it is constant during the process. (b) A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.