if a wattmeter was connected to a 240 volt single phase circuit that contained only capacitors and the total circuit current was 20 amps the wattmeter would read.

Q: If Current and Voltage are 90 Degree Out of Phase in a single-phase circuit, then the true power…

A: If voltage and current are in 90 degree out of phase  Power factor = cos(phase angle) = cos(90) = 0…

Q: The DC resistance of a delta connected alternator measured across its two terminals is 1 ohm. What…

A: Draw the given arrangement of delta connection for measurement of resistance and using given DC…

Q: A 24-volt circuit has a total resistance of 120 ohms.   Determine the power consumption of the…

A: The obstruction offered to the smooth flow of current is called resistance. The electrical element…

Q: Question No.84 Three loads, each of resistance 50 Q are connected in delta to a 400 V, 3-phase…

A:

Q: If the no-load voltage of a 3-phase, 440 V, 50 Hz alternator is 495 V, then it's voltage regulation…

A: The solution can be achieved as follows.

Q: Find the average voltage from 45⁰ to 180⁰ @ Em = 100 Volts? b) what is the average current if this…

A:

Q: A Chopper circuit is operating at a frequency of 2 kHz on a 460 V supply. If the load voltage is 350…

A:

Q: 2. An inductive reactance of 8 N is connected in parallel with a capacitive reactance of 18 N; this…

A:

Q: Two 115-V incandescent lamps A & Bare connected in series across 230-V de source. Lamp A is rated…

A: This problem is related to circuit theory. This is based upon the concept of incandescent bulbs…

Q: The meter constant of a single phase 230 V induction watt hour meter is 400 rev/kWh. The speed of…

A: Given, a induction watt hour meter having Voltage, V= 230 V Current, I= 10 A Meter constant, K= 400…

Q: What is the Voltage per Phase? O 4340 Volts O 4430 Volts O 4530 Volts O 4360 Volts

A:

Q: The voltage-flux adjustment of a certain single phase 220 V induction watthour meter is altered so…

A: Given: Supply voltage, V = 220 V The meter is altered so that phase angle between flux and applied…

Q: Explain briefly why is there no wattmeter reading when the load is purely capacitive.

A:

Q: A single phase load is located 2800 feet from its source. The Load draws a current of 86 A and…

A: A single phase load is located 2800 feet from its source. The Load draws a current of 86 A and…

Q: How does the magnitude of the voltage across the power supply compare to the voltage across the bulb…

A: Concept If the supply element (active source) and absorbing load type of element are connected in…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,677 ohms R2 =…

A: Given the following resistances and inductors are in series with a voltage source, R1=1677 ΩR2=1966…

Q: (a) An electrodynamic wattmeter is used to measure the electrical power in a circuit. The diagram in…

A:

Q: 450 Q 6 Vrms 340 Q 600 2 200 Q

A:

Q: For the distribution system shown in the figure below, if Károp=0.000224 % voltage/kVA mile, find…

A:

Q: A wire carries a current i 3cos314t A. What is the average current over 6 seconds?

A: We are given, I = 3 cos 314t A. We need to find average value of current for 6 seconds.

Q: b) Compare and contrast a direct current circuit and an alternating current circuit using graphs.

A: The frequency of AC is depended upon the country. But, generally, the frequency is 50 Hz or 60 Hz.…

Q: 13. A rotary standard with a K, of % whr per revolution and a multiplier of 3 makes 42.4 revolutions…

A: Revolution testing:

Q: In three phase power each voltage current and power is delivered by how many degrees..

A: Phase Phase is the difference between the starting position of the two sinusoidal waveform, so it…

Q: Draw and explain a power supply diagram of 12V?

A: A power supply diagram for a 12V DC (direct current) power supply typically consists of several…

Q: Calculate the power factor and phase angle in a sinusoidal current-carrying circuit from measuring…

A: Given Data: Readings of, Ammeter Im= 2.5 A Voltmeter  Vm=200 V Wattmeter  Pm=220 W Full Scale…

Q: Thirty (30) units of 200 watts, 250 V incandescent bulbs are connected in balanced delta across a 3…

A:

Q: In electrodynamometer type wattmeter, to.............. in moving coil, a high resistance R is…

A: The explanation is as follows.

Q: What is the current in amperes in a 3-phase circuit when the load is 135 horsepower, the efficiency…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.