If a piece of block weighing 150 kg is to be pulled up by a winch using two cables on a 25 deg inclined plane, find the least force each cable will be subjected to set the block in motion. Assume the coefficient of friction to be 0.25.

Q: 1. Determine the magnitude and direction of friction force which the vertical wall exerts on the…

A: Determine the magnitude and direction of friction force which the vertical wall exerts on the 50-kg…

Q: The box shown in the figure has a weight of 250 pounds. The coefficient of static friction between…

A:

Q: An arrangement of three boxes is shown in figure below. Box A weighs 25 N and rests on an inclined…

A:

Q: A wedge rests between a 75-lb drum and a wall as The coefficient of friction between the shown in…

A: Given data: Weight of the drum = 75 lb = 34.02 kg Coefficient of friction between drum and floor =…

Q: 1- The cylinder shown in the diagram weighs 200 pounds. If the coefficient of friction at all…

A: Given data  Weight of the cylinder (w) = 200 lb coefficient of friction (μ) = 0.25   To determine…

Q: Inclined Ramp A box sitting on a horizontal surface isattached to a second box sitting on an…

A: According to the given information, we know inclined Ramp A box sitting on a horizontal surface is…

Q: 2. Block A weighs 100N and block B weighs 300N both rests on an inclined plane downward to the right…

A: Here I am going to find the tension in the cable due to the blocks on inclined plane.

Q: 2. Compute the horizontal force P required to prevent the block from sliding down the plane for the…

A: GivenW=100 lbθ=30oμs=0.65

Q: 1.) Compute the weight of block B that will prevent the two block system from sliding. Block A…

A:

Q: lfway up it. The coefficient of friction at the wall is 0.20. Assume the weight of the ladder to be…

A:

Q: A uniform ladder of length L and weight w is leaning against a vertical wall. The coefficient of…

A:

Q: A 20-kg triangular block sits on top of a 10-kg rectangular block shown in the figure below. The…

A: given data; mass of triangular block(M) =20kg mass of rectangular block(m)=10kg friction coefficient…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.