If a digitizied signal has the data rate as 32 Kbps, which one is true?

Q: In BPSK modulation, for a zero binary input, the phase will be degrees.

A: In BPSK modulation, for a zero binary input, the phase will be........... degrees a. 0 b. 270 c.…

Q: B) Draw and find the BASK signal if maximum carrier amplitude is 14V and f.=0.1MHz and the input…

A:

Q: Time left 1:38:3 The circuit shown in figure performs addition as well as subtraction. If 4-bit…

A: As signal is S=1 , therefore it will perform subtraction Using 2'd complement method and result will…

Q: Generator .Determine the out (a) 101010010. (b) 111010011. (c) 110010011.

A: Rules for even parity generator: Count the number of 1's in data bit:  If the number of 1's is…

Q: Take first two alphabets of your name e.g. if your name is WASIF then WA will be your data, then…

A: // C++ program to print initials of a name#include <bits/stdc++.h>using namespace std; void…

Q: For an FM modulator with a modulation index of m = 1, and the given parameters as below. Va(t) = 2…

A: below given the frequency spectrum

Q: 5. Perform the following functions: a. What will be the parity of the data signal to send as even…

A: a. A parity bit is an error detection bit that is added to a data block. The validation of the…

Q: If data is going to be sent from source to destination are 1000001. By using Hamming encoding,…

A: answer is

Q: 02: Assemble the binary bits of the "PCM" signal below into a DPSK waveform, in the case of the…

A: I will explain it in details,

Q: Show how to use bit masking to check whether bits 2 and bit 5 in a byte are both on.

A: Bit Masking: Bit Masking is used to access specific bits in the data. It used to toggle bits on or…

Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable.

A: A 4 to 16 line decoder contains : 4 input lines and 16 output lines(which are combinations of all 4…

Q: etermine the number of possible quantization levels if the number of bits per sample in a given PCM…

A: Quantization The process of quantization involves breaking down an analogue continuous signal into…

Q: Write a program to monitor the RB5 bit. When it is HIGH, make a LOW-to-HIGH-to-LOW pulse on RB3.

A: Write a program to monitor the RB5 bit.When it is high,make a LOW-to-High-to-low pulse on RB3.

Q: Analog-to-analog conversion, or analog modulation, is the representation of analog information by an…

A: Lets see the solution.

Q: help make the truth table for this question.   Given two 2-bit two’s complement numbers A and B,…

A: Instructions to follow:Since the numbers A and B are 2-bits two’s compliment numbers, they can be…

Q: the minimum sampling rate (according to Nyquist frequency) for the signal [ x(t) =2 * ? cos 600O ttt…

A: The given signal is, x(t) = 2cos6000πt + 5cos10000πt Minimum sampling rate is: S = 2 *…

Q: 8. Consider transmitting a digital data: 10111000101. Draw the signal representation when a. Using…

A:

Q: If a signal has a frequency of 30KHZ what is the period in Microseconds?

A: given the frequency=30KHZ   The formula is,        f=1/s given     30=1/s   hence s=1/30= 0.33

Q: 4. Using a combination of ASK, FSK and PSK: a) Sketch the unique signals, one each for 011, 100,…

A: ASK (Amplitude Shift Key) In ASK  amplitude of the carrier wave is changed (switch) according to…

Q: A signal travels from point A to B. At point A the signal power is 100W. At point B the power is 80.…

A: I Have answered this question in step 2.

Q: Recall that the maximum input voltage for a 12-bit ADC on the TM4C is 3.3 V. If the input voltage on…

A: 1) We have 12 bit ADC 2) Max input voltage is 3.3V which generates 12-bit digital output of 0xFFF =…

Q: The circuit shown in figure performs addition as well as subtraction (using 2's complement). If…

A: FA is Full Adder adds up all the inputs and the result bit will be S0, S1, S2, S3 and the carry bits…

Q: n Coding methods an we represents a 0 bit by a low to high voltage ansition, and a 1 bit is…

A: yes In the coding method, we can represent a 0 bit by a low to high voltage transition, and a 1 bit…

Q: can we represents a 0 bit by a low to high voltage transition, and a 1 bit is represented as a high…

A: Yes surely it can represents a 0 bit by a low to high voltage transition, and a 1 bit is…

Q: Q. A straight binary sequence is applied to a 4-bit DAC, and the output in figure below is observed.…

A: According to the information given:- We have to define a straight binary sequence is applied to a…

Q: Consider this 1-bit ALU design, as shown in class (note that the rounded rectangles controlled by…

A: We need to find the values of Ainvert,  Binvert, CarryIn, and Operation to get a-b.

Q: When pulse duration 0.001ms and fm 3KHZ ,the spectrum of the sampled signal is Your answer

A: 3

Q: If the bandwidth of a signal is 5 KHz and the lowest frequency is 52 KHz, what is the highest…

A: Given that: If the bandwidth of a signal is 5 KHz and the lowest frequency is 52 KHz, what is the…

Q: Based on hamming code (7 , 4) . Given the code 0 1 1 1 1 0 0, if we redid the parity bit generation…

A: Given: data bits d1, d2, d3, and d4A (7, 4) Hamming code may define parity bits p1, p2, and p3…

Q: What are the values of x, y, and z in the below circuit that will produce the following values for…

A: The values of x, yz will be decoded from the input values of F1 and F2.

Q: Discretize the following continuous-time signal at an appropriate sampling rate, and then plot he…

A: According to the question we have to plot discretized version of the equation:   here, I'm using…

Q: If A = 1111 and B =0000 then the output of 4 –bit Magnitude comparator is

A: 4-bit Magnitude Comparator - It is comparator used to compare two binary numbers of 4 bits In a…

Q: If a decoder decodes a 4-bit pattern what is the maximum number of output wires it can have and how…

A: Please give positive ratings for my efforts. Thanks.   ANSWER   As decoder has the input and output…

Q: argest positive numbers that can be stored in single precision? (b) What is the smallest value of…

A: a) The largest number that can be stored in a single-precision is approximately 3x1038. The…

Q: In a four -bit adder -subtractor and given that A(0101),B(0100),and M = 1 , what are the values of…

A: Correct answer is d. c1 = 0, v = 1