I. Problem Solving. Box your final answer. 1. Find the (a) maximum tensile and compressive bending stress in the wooden beam and (b) maximum shear stress in the shaded area of a wooden beam. 4kN 2kN 3kN 2m D |1m 1m 2m 4m 3m 8m 5m 1m

Q: Detrmine the speed of rotation of the output shaft in figure below and its direction of rotation…

A: Write the expression of the gear ratio of gears A and B.

Q: Find the forward and return velocities of an offset slider crank mechanism rotating at 1500 rpm…

A:

Q: # Teeth on # Teeth on Gear RPM Pinion RPM gear 75 pinion 55 Row A 125 Row B 60 225 337 Row C 120 40…

A:

Q: I need parts 7, 8, and 9, answered pertaining to the print and instructions.

A: As we are entitled to answer only a single question. We’ll answer question no. 7 for you. Please…

Q: A pair of spur gears with 20° tooth form transmits 1.0-hp. The pinion is mounted on the shaft of an…

A:

Q: I need the answers to this question.

A: The explanation of the above terms have been explained below.

Q: Match each of the following terms to the phrase that describes it. Answers are used only once.

A: The correct match is: Drill spot           -     3Countersink      -     6Knurl                  -…

Q: what rpm and feed rate would you use if the shaft was 6 inches and made of stainless steel?

A: given; shaft diameter (d)=6in                                =0.1524mfor stainless steel;rpm?feed?

Q: The machine design has stated that a 2.5 kW electric motor with an input speed of 1000 RPM is needed…

A: Disclaimer: “Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: When it comes to finding the moment arm, you must use the distance of the line from the pivot to the…

A: Explanation When it comes to finding the moment arm, you must use the distance of the line from the…

Q: How many primary joints are there in this mechanism? 22.9 22.9 /D E 4.5 typ.

A: Primary Joints include pins, sliders and other elements that allow pure rotation or pure linear…

Q: hy is incremental positioning usually used with an axis return?

A: The absolute coordinates system the reference each position on the work piece is same or origin…

Bending Moment

In general, we can define the bending moment as the reaction induced when a certain amount of load or force is applied to an element which makes it bend.