The operation of a system is described as follows:i)When the START Button is pressed, the COUNTER #5 is ONi) After 5 counts, the memory D200 is filled with data #00A2, and D300 is filledwith data HO00C.Then the data inside the both memory addresses are compared. When thevalue inside1. D200 > D300, the GREEN light will tum ON2. D200 - D300, the RED light will turn ON3. D200 < D300, the YELLOW light will turn ON.iv) When the STOP button is pressed the light goes OFF(a)Fill up the DM data memory in Table (a).Table (a)15 14 13 12 11 10 976543210 Hex ValueD200D300(b)Draw the flowchart for system described above.

i) When the START Button is pressed, the COUNTER #5 is ON i) After 5 counts, the memory D200 is filled with data #00A2, and D300 is filled with data H000C. ii) Then the data inside the both memory addresses are compared. When the value inside 1. 2. D200 – D300, the RED light will turn ON 3. D200 < D300, the YELLOW light will turn ON. iv) When the STOP button is pressed the light goes OFF D200 > D300, the GREEN light will tum ON Fill up the DM data memory in Table (a). Table (a) 15 765 43210 Hex Value 14 13 12 1 10 98 D200 D300 b) Draw the flowchart for system described above.

i) When the START Button is pressed, the COUNTER #5 is ON i) After 5 counts, the memory D200 is filled with data #00A2, and D300 is filled with data H000C. ii) Then the data inside the both memory addresses are compared. When the value inside 1. 2. D200 – D300, the RED light will turn ON 3. D200 < D300, the YELLOW light will turn ON. iv) When the STOP button is pressed the light goes OFF D200 > D300, the GREEN light will tum ON Fill up the DM data memory in Table (a). Table (a) 15 765 43210 Hex Value 14 13 12 1 10 98 D200 D300 b) Draw the flowchart for system described above.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Question 4 If DS=0080H and offset value is 02ABH. What is the physical address value of the memory location? 00AAB 00BAB OAABA 00ABB OAABB
This is a review question and they are not graded. PLEASE FOLLOW the instructions below. Please show your solution so that I could understand the subject. This is a simple logic gate question.
Which one of the following instructions will cause a memory read when it is executed? MOV BL, AL MOV BL, 0203 MOV AL , BL MOV AL, [0203] OR MOV [0203], AL
Please answer the question
For the ROM memory chip shown, find the capacity (including units) . organization: is this memory volatile or non-volatile? (circle one) D7 DO A B IC GZA G28 G1 A16 A17 A18 YO Y1 Y2 0 Y30 Y4 AD ROM A15 VocVpp MEMR OE CE Each Y controls A19- Y50 Y7 Given the ROM memory chip and decoder circuit below (the decoder used is the 74LS138) is used in a system with a 20-bit address bus, find the address range (in hex) the chip will respond to: upper one block lower
Question 5 What is the device address used by the instruction OUT A4, AL?
Draw the block diagram of a CPU showing the basic units. Explain the functions of each unit shortly.
I will make the implement part myself. Hello, Please do what is requested carefully. Logic circuits answers that I usually get from Bartleby are wrong. Please ensure.I will post the question 3 times.Can you answer Question A?
please type so that i can read it
What is concurrent Assertion. Write a concurrent assertion If "signal 1 " is high on a given positive edge of the clock, then after 3 clock cycles, signal 2 shall be high
QUESTION 3 When performing math functions, care must be taken to ensure that the values remain in the range that the data-table or file can store. O True False QUESTION 4 The NEGATE instruction cannot be use to change the sign of a number from negative to positive. O True O False
Q. Choose the correct answer: 1. A PAL is a logic device which is: (a) one-time programmable (b) an erasable programmable (c) electronically erasable and programmable (d) both (a) and (b)