1₂ + V₁ R₁ 1 Aio 1₁ R₂ + This circuit is to be analyzed using superposition. Determine the value of v' due to the current source l₁ acting alone (that is, all other independent sources have been zeroed). The value of the voltage source is V₁ = 5 Volts and the current sources are 1₁ = -8 Amps and 12 = -8 Amps. The resistor values, in Ohms, are R₁ = 16 and R₂ = 10. Give your answer in Volts and use 3 significant figures.

1₂ + V₁ R₁ 1 Aio 1₁ R₂ + This circuit is to be analyzed using superposition. Determine the value of v' due to the current source l₁ acting alone (that is, all other independent sources have been zeroed). The value of the voltage source is V₁ = 5 Volts and the current sources are 1₁ = -8 Amps and 12 = -8 Amps. The resistor values, in Ohms, are R₁ = 16 and R₂ = 10. Give your answer in Volts and use 3 significant figures.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

For the circuit below, determine the resistor current. The source is 8 volts, the Zener potential is 5.2 volts and the resistor is 5k ohms.
Please answer it with clean and step by step solution. This subject is Electronics specifically. Thank you and keep safe.
In the circuit shown below, if R1=5 ohm, R2=10 ohm and Vin = 2V. Then the current (I) will equal to: Vino Vout R1 R2 O a. -0.6A O b. 0.4A O c. -0.2A O d. -0.4A Oe. 0.6A
Determine the resistor voltage. The source is 6V, Zener potential is 5.1V and resistor is 1k ohms.
Write solution neatly. Thankyou!
A 0 – 150 voltmeter has a resistance of 2000-ohms per volt. It is desired to change this voltmeter to a 0 – 600 volt instrument by the edition of an external multiplier. What is the resistance, in ohms, of this external multiplier?
In the figure below, explain in what situation ammeter A reading will be nonzero.
150 100 + VA- a -4V AVA -7V 81. B b Figure 2 shows a simplified model of a gas-discharge lamp. One characteristic of these lamps is that they exhibit negative resistance; in other words, as current increases the voltage drops further, making such lamps inherently unstable. As such, a current-limiting ballast is required. For the connection shown in the figure: 1. Find the equivalent Thevenin circuit of the lamp. 2. Find the ballast resistance needed to limit the current drawn from a 24-volt source to 6 amperes.
COPY THE ILLUSTRATION BELOW AND IDENTIFY THE BRANCH CURRENT AS STATED. R1 = 12 OHMS R2 = 72 OHMS R3 = 168 OHMS .... .O A solo: 12 72 36
Determine the values of the currents for max current and min curent in the voltage regulator Zener of 12 V, to mantain a constant voltage and gives off a current inside a 1mA.
2)This multiple choice question from MEASUREMENTS INSTRUMENTATIONS course.
Three resistors of 5, 10, and 15 ohms respectively are connected in series with a 24V source voltage. What is the current in the 5-ohms resistance? a.0.2 A b. 08 Ac. 0.6 A d. 0.5 A