I just need the graph of this. A certain ideal gas (unknown) inside a close piston-cylinder assembly undergoes a set of processes that composed of Isothermal expansion from State point 1 to state point 2, Isometric heat rejection from state point 2 to state point 3, and Isentropic compression from state point 3 back to the initial condition. If the maximum pressure is 3000kPa and maximum and minimum volume is 200cm3 and 50cm3

Q: a) In an open vessel, a certain volume V of water is perfectly agitated by means of an impeller 20…

A: Given: Diameter of the impeller→D=20 Cm speed of the impeller→N=150 RPM=150/60=2.5 revolution per…

Q: Q5: A) A three forces as shown in Fig.1 does work on a body when it acts against a resisting force…

A:

Q: 2-A closed container is filed with 2 kg of R-134a refrigerant at P=200 kPa. If the volume of the…

A:

Q: Draw and label the graph of this set of processes in the P-V and T-S diagram showing the state point…

A:

Q: 2-12 Two sites are being considered for wind power gener- ation. In the first site, the wind blows…

A: Given data: V1=7 m/st1=3000 hrs/yrV2=10 m/st2=2000 hrs/yr Need to determine which is batter site for…

Q: Consider an experimental structure required to always have constant pressure. For this purpose, a…

A:

Q: A certain ideal gas (unknown) inside a close piston-cylinder assembly undergoes a set of processes…

A: Given that, Maximum Pressure, Pmax=3000 kPa,Maximum volume, vmax=200 cm3Minimum volume, vmin=50 cm3…

Q: Air and refrigerant R22 pass through a heat exchanger in two separate streams. Assume no heat…

A: The refrigerant's inlet and outlet location are separated by 1 meter height, so there will be…

Q: Which is correct for closed system Select one: а. Energy Out Mass in System Mass Out Syster Boundary…

A:

Q: P.5 Distinguish between a steady-state and an unsteady-state process.

A: Steady state means the properties of a system does not vary with time.

Q: Calculate the change in internal energy of system under below cases: (1) Heat added to system = 600…

A: From first law of Thermodynamics, in any process, change in internal energy of system ΔU is given…

Q: The mass rate of flow of air (G) used in correlation equations for heat transfer in a dryer is…

A: To Solve: G as a function of the velocity of flow (V, m/h) of air. Given: Mass flow rate of air, G.…

Q: 3-76 A system consisting of 2 kg of ammonia undergoes a cycle composed of the following processes:…

A: given that , process 1-2; constant volume from P1=10bar ,x1=0.6 to saturated vapor process 2-3;…

Q: 3.134 One kilogram of air in a piston-cylinder assembly undergoes two processes in scrics from an…

A:

Q: Newton's Law of cooling: (3.1 p. 88) A cake is removed from an oven and its temperature is 300°F.…

A: The initial temperature of the cake when it is removed from the oven θ1=300oFafter three minutes its…

Q: Q1) I have a simple piston/cylinder system containing an ideal gas at initial pressure Pi that is in…

A:

Q: 15. 1.4 m' of a gas at a pressure of 1.26 bar is compressed to a volume of 0.28 m². ar. Assuming the…

A: Given data as per question Initial state, V1=1.4 m3, P1=1.26 barFinal state, V2=0.28 m3, P2=7…

Q: thermodynamics question

A: Drawing the PV diagram of the process – Process 1-2 is the constant pressure process in which the…

Q: イn To Room temperature T = 293 K V. The gas volume changes from Vp to Va at constant temperature T.…

A: As the temperature is constant during the process , The process is isothermal . Internal energy is…

Q: Shown in the figure, an insulated rigid tank is divided into two equal parts by a partition.…

A:

Q: P2.1 The table below gives the properties of water under five different sets of conditions. Use the…

A: The table for the properties of water is given below, State pressure(bar) Temperature(oC)…

Q: A food product containing 80% moisture content is being frozen. Estimate the specific heat of the…

A: 80% moisture content is being frozen here product 82% of water is frozen 82% of water is frozen and…

Q: In figure shown, (E ) is a heat engine with efficiency of 0.4 and ( R) is a refrigerator. It is…

A:

Q: Find the heat absorbed to evaporate 5Lb of R134a from Point 1 to point 2 as shown in P-H diagram.

A: Given: Refrigerant 134a m = 5 lb   To find: Heat absorbed to evaporate, Q = ?

Q: In this problem, you will consider an "unusual” solid-state refrigeration device that achieves…

A: Given: To find: Sketch the process on the following state diagrams

Q: 2. 1 mole of an ideal gas initially at 300K and 1 atm is heated and allowed to expand re- versibly…

A:

Q: In class, Dr. Tree cited heat transfer from a hot body to cold body as an example of process goes in…

A: The two head addition process are cited below. 1. Melting of ice into water in this process heat is…

Q: 0.25kg/s of Carbon Dioxide (R = 0.1889 kJ/kg-K, k = 1.289) undergo a certain process in a close…

A:

Q: mple 4.1 A stationary mass of gas is compressed without friction from an ini- tial state of 0.3 m…

A: As per given question we have defind the  internal energy of gas change

Q: Q2 (a) A polytropic process is defined as PV" =C , where n is polytropic index and C is a constant.…

A: Drive the equation for the boundary work for the polytropic process

Q: Thermal reservoir Q₁ Thermal reservoir 2 W₁ -70 J -50 J 0₁-20 J Thermal reservoir li Q₁-20 J

A: GIVEN DATA- THREE RESERVOIR GIVEN WE HAVE TO FIND HEAT AND WORK TRANSFER CIRCLE IN RED

Q: 3. Find the two-dimensional temperature distribution T(r,z) under steady state condition. Where,…

A:

Q: What is consider as Properties of system?

A: Properties of System: Properties of a system define the charcteristic of the system. These…

Q: 6 cm Transform the force (600 N) into a force passing through point (A) and a couple whose forcer…

A:

Q: A piston cylinder device with stops as shown contains water initially at 25 C and 100 kPa "State 1".…

A:

Q: Describe a closed system with a moving boundary?

A: Closed system in thermodynamics is system in which exchange of energy in  form of heat and work…

Q: A hot water leak in one of the faucets of your apartment can be very wasteful. A continuous leak of…

A:

Q: Find the two-dimensional temperature distribution T(r,z) under steady state condition. Where, To=20…

A: Heat Transfer: According to second law of thermodynamics, heat is always transferred from high…

Q: Q5: A small tank of Helium gas, its pressure is 15.5 bar and its temerature is 293" K (Kelvin) with…

A:

Q: What is heat transfer? And modes oh heat transfer?

A: Heat transfer :-  The energy transfer due to temperature difference is called as heat transfer. its…

Q: ENTROPY CHANGE OF THE UNIVERSE

A: Given; One kilomole ofan ideal gas is throttled from an,initial pressure,p1=0.5 MPa…

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.