*** H(z) = 1−4z-¹ (1 − 3z−¹ + 2z-²)'

Q: Sketch its impulse response, and step response.

A:

Q: Problem 1 Given a block diagram of an LTI system below x(n) +) y(n) -1 4 a) Write the difference…

A:

Q: y[n] = x[n] – 2x[n – 1] and the impulse response h(n) is h[n] = Ad[n] – Bô[n – 1] Find the values of…

A:

Q: You are trying to develop a basic temperature tracker to control the temperature of a room. The…

A:

Q: given a system whose impulse response h[n]=δ[n]-δ[n-2]. find its difference equation with input x[n]…

A: The solution is given below

Q: Consider the plant with the following transfer function 1 (s +3)(s + 6) Consider a unity feedback…

A:

Q: Find the impulse response of the following difference equation by the iterations method or by…

A:

Q: (a) Determine the impulse response. (b) Determine a realization for its inverse system, that is, the…

A:

Q: Cosider the circuit below. The input is the i_g (t) and the output is the capacitor voltage V_o (t).…

A: Given:Initial energy stored in the capacitor is zero.we need to do:A) Find the transfer function .B)…

Q: QI/Compute and sketch the impulse response of the LTI system whose step response is: 012

A: Given data: The given figure of step response is shown below,

Q: 3. For the block diagram below, a. Find the closed loop transfer function b. Find the poles and tell…

A:

Q: R1 VioW R1=102, R2=302, C=0.05F Determine the impulse response h(t) of the circuit. Determine the…

A:

Q: (b) The trans fer function of a system is given by G(s) s2 + 10s + 30 Calculate the response of this…

A:

Q: e(t) Shown below is the output of a triangular data hold, Input to sampler Data-hold output 0 I 2T…

A: According to the question, for the given diagram of the output of the triangular data hold as shown…

Q: 2- In the figure below, show that if F1 and F2 are LTI, and if x1 = x2, then y1 = Y2. -Show that by…

A:

Q: explain in concise but good detial. Double check your work please

A:

Q: For the circuit shown, 30 Ω 0.5 F 0.25 H el + v 60u(1) V (+ 20 Ω +) 30u(t) V the generalized…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.