Hydrogen sulfide is commonly associated with the "rotten egg" smell. It is also a highly toxic gas that must be dealt with carefully. This compound can decompose by the following reaction: H₂S (g) H₂(g) + S(g) Ptot: = 0.255 If the reaction vessel initially contains H₂S (g) at a pressure of 0.840 bar, determine the total pressure, Ptot in the container when the reaction reaches equilibrium. : 2 Kp = bar

Hydrogen sulfide is commonly associated with the "rotten egg" smell. It is also a highly toxic gas that must be dealt with carefully. This compound can decompose by the following reaction: H₂S (g) H₂(g) + S(g) Ptot: = 0.255 If the reaction vessel initially contains H₂S (g) at a pressure of 0.840 bar, determine the total pressure, Ptot in the container when the reaction reaches equilibrium. : 2 Kp = bar

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A weight of 0.50 g was taken impure container containing sodium carbonate and bicarbonate. Dissolved in water and then crushed with hydrochloric acid (0.1 N), the burette reading game was at the endpoint of phenolphthalein of 10.5 ml and at the end point of the orange methylation point 30.1 ml. The percentage of sodium carbonate was in ................. knowing that the weights are: Na: 23, C: 12, O: 16
2:17 ull LTE 4 MESSAGES now خالد الشاعر بس لازم تسجل ب امیل Write a net ionic equation for the reaction that occurs when potassium sulfite (ag) and excess hydrochloric acid (ag) are combined. Note: Sulfites follow the same solubility trends as sulfates. !!
A beer sample is analyzed in the laboratory to determine the international bitterness units (IBUs). The analysisis performed in triplicate with the following results: 22.5, 25.4, and 21.7. Within what range are you 95%confident the true value lies?
Look at the following Potential Hazard: Getting burned by a flash fire or explosion that results from an accumulation of flammable gases, such as Methane or Hydrogen Sulfide, around the wellhead area. What are the possible solutions for this risk ???
5.00 mL sample of 0.1136 M of standard ascorbic solution required to 12.70 mL of KlO3 to reach the endpoint. The same KlO3 solution was then used to titrate 10.00 mL sample of a peach solution and it required 8.50 mL to reach the endpoint. Determine the: A.) Mass in Mg of I2 formed prior to the endpoint, and B.) Molarity of KlO3.
kindly provide complete and full solution. I won't like it if it is not clear to read or incomplete.
Determinati an 25 ml by dissolving 110n (111) per 1 This (as ml 750ml experiment Solution The to of was The a and process Q on added The portion layer taken 1 volumetric diluted Litre Colution Two These of in diluted ml soo 1% ETA of Question A. reaction an Solution 0₁ 446 9 of A. R. hydrated sulphate, (NH4) Fe (504) ₂ · 12H₂0 2 of distilled then of wertel) 0,0446 g/L of lion Absorbance was 250 ml in to ·layers frask was Is 2. 3. Was Chlore form and were 5 ml, 10 ml, 15 ml por tions 4. Iron • iron (111) four oxine it mixture the done. (111) seperatory conducted Volume SMT as 10 ml 15 ml 20 ml Plo + absorbance formed readings a (A.R) Jayer measured the por tions Solution was Water diluted out 20 ml were then Each of these mark against funnel as was after with for 8- ity droxy quinolate. follows. to iron (111) solution was prepared of then Calibration was ) 10 obtain collected. ammonium F. W-481,979 then these Absorbance 0,076 0,169 9185 0₁234. Shook. the shaking added portions…
Answer in not more than 5 sentences per question 1. Discuss the a) direct method of weighing b) indirect weighing using the analytical balance. 2. Explain how suction filtration is carried out in the laboratory. Give the important points that must be observed in doing the process. 3. Explain why it is important to wash the precipitate. Can distilled water be used to wash all types of precipitates? 4. Discuss how to use a desiccator. When should a desiccant be replaced? Give 2 examples of substances used as desiccants.
THE okmarks People Tab Window Help signment/takeCovalentActivity.do?locator=Dassignment-take MyLabsPlus | Pear. O Chem 2 Login P Course Home google - Google S... Google Maps Home [Review Topics] [References] Use the References to access important values if needed for this questic The volume of water needed to dissolve 0.0689 grams of barium sulfite is L. Assume no volume change upon addition of the solid.
21. Some 1.0 g steel samples are believed to contain about 2.5% cobalt. If a 10% excess of the precipitating reagent, 1-nitroso-2-naphthol, is to be used, what volume of a 0.3% solution of precipitant should be used? Assume a 1:3 stoichiometric ratio for metal:precipitant. 22. A 4.72 g sample
0.890 g KIO3 was dissolved to give a 80.00 mL Iodate solution. 35.00 mL aliquot reactedwith the iodide to form triiodide. The liberated triiodide was titrated and consumed 11.65 mL of theS2O32- solution to reach endpoint. Calculate the concentration in molarity of the Na2S2O3solution.
All solute dissolve in solvent? True or false