HW24 11.73 A 240-V ms 60-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22 KVAR (inductive). Find: (a) the apparent power (b) the current drawn from the supply (c) the KVAR rating and capacitance required to improve the power factor to 0.96 lagging (d) the current drawn from the supply under the new power-factor conditions

HW24 11.73 A 240-V ms 60-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22 KVAR (inductive). Find: (a) the apparent power (b) the current drawn from the supply (c) the KVAR rating and capacitance required to improve the power factor to 0.96 lagging (d) the current drawn from the supply under the new power-factor conditions

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Three loads are connected in parallel to a 240-V, 60 Hz supply. Load 1 is composed of three 600-W heaters, Load 2 is a 3 HP, inductive motor with an efficiency of 90% and a p.f. of 0.88, while Load 3 has an impedance of 12-j16 ohms. Determine the following: a) The apparent power of each load b) The Total Power, Total Reactive Power, Total Apparent Power, Power Factor c) The source current
What is the value of capacitance that needs to be connected in a parallel configuration to the load in order to correct the pf source to 0.94 lagging. Frequency f= 129 Hz
I need it in 5 minutes please
The variable resistor R in the circuit is adjusted until it absorbs the maximum average power. * The value of the load resistance that maximize the power transfer is... ohms 32 -j22 H j12 4/0° A R. 4.3 O 1.23 O 2.58 O 5.94 none of the above O 7.81 O
Problem 1 • A sinusoidal source with frequency of 60 Hz and rms-voltage of 100 V is connected to an RL load of 10 ohms and 100 uH. Find Power Factor From Calculation Find Power Factor From Plot L=10mH find power factor from calculation only
find The average power delivered to * .the circuit الحل بطريقة الممانعات وشكرا
Solve 9
For a source which has load has the following characteristics: • Vrms = 125 20° V • P= 400 W • pf = 0.925 lagging What is the rms current and reactive power?
A load connected to a 210 V rms 50 Hz power lineIt draws 7 kW of power with a back power factor of 0.7.To make the power factor 0.8What should be the value of the capacitor to be connected parallel to the load?