Humid air at 1 atm, 35°C, and 45 percent relative humidity is cooled at constant pressure to the dew-point temperature. Determine the cooling, in kJ/kg dry air, required for this process.

Q: Problem 8. The piston shown is moving downward in its track at 26 cm/sec, as shown in Figure 8. All…

A: The piston shown is moving downward in its track at 26 cm/sec, as shown in Figure 8. All dimensions…

Q: Given the top and front view create a section view.

A: Find Create a section view using the given top and front views.

Q: Convert to isometric drawing mark point A as the lowest point

A: use a 30-60 triangle to create the isometric  figure ng follow the left, front and top illustration…

Q: Which percentile is typically for designing lower-limit dimensions? - 95th 5th 50th 99th

A:

Q: Draw the orthographic views of the following isometric figure.

A:

Q: create 2 fourbar designs that include the dimensions and angle of motion

A: It is asked to draw four bar mechanism with given motion

Q: A) Draw the two limiting positions of the following crank-slider mechanism. Indicate all known sizes…

A: Given:To find:(a) Draw the two limiting positions.(b) Determine the piston stroke.

Q: Give all the location dimensions between the datum target areas , A1 and A2. X = _________________,…

A: Give all the location dimensions between the datum target areas , A1 and A2.X =0  ,  Y =74   ,   Z =…

Q: Draw the plan, Front view and the Side view of the following figure and do the dimensioning.

A: Please refer the following orthographic views of the given object.

Q: igh precision in angular measurements can be made using a sine bar. For using a 200 mm sine bar to…

A: Given:Length of sine bar, L=200 mmangle=49o 20'angle=49+2060=49.33oDiameter of rolls, d=35 mm

Q: 0.50 1.25 3.00 1.00- 2.00 1.00

A: Given,

Q: Q1: Use scale (1:1), draw the front, top & side views of shape shown below. (50 M)

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional.…

Q: Draw the isometric views of the following shapes in 1st angle projection

A: Solution: Isometric view means making 3 dimensional figure . The isometric view of given figure is…

Q: Partition the given figure and find the x and y coordinates.

A: Task at hand is to find the centroid of the shape in the figure