9 **Question 9:**How much energy is required to heat a 2.50 kg block of ice that is at -4.0°C to water that is at 21.0°C?---*Note: There are no graphs or diagrams associated with this text.*

Given:m=2.50kg (mass of the ice),Initial temperature T1=−4.0∘C,Final temperature…

Answered: How much energy is required to heat a…

Science

Physics

How much energy is required to heat a 2.50 kg block of ice that is at -4.0°C to water that is at 21.0°C?

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter18: Temperature

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Experiments performed with light indicate that light exhibits: OA) Particle properties, only O B)…

A: Photoelectric effect

Q: 9 and 10. Thanks.

A: 9.The equation for dot product

Q: A long straight wire carrying a current of 0.450 A has a loop with a radius of 5 cm. The current is…

Q: Four equal +2.00-µC point charges are placed at the corners of a square 4.00 m on each side. (k =…

Q: N vs. TIME graph below, click on the spot where the VELOCITY IS ZERO (the arrow will be placed where…

A: Introduction: When the body does not gets displaced with time, the velocity is said to be zero. So,…

Q: The coil in a loudspeaker has 55 turns and a radius of 3.7 cm. The magnetic field is perpendicular…

A: Given: In this question, the given details are, The coil in a loudspeaker has 55 turns and a radius…

Q: 60.0 N - +x 40.0 N

A: FR =402 +602 +240(60)cosi00Resultant Force FR=72.1NMagnitude of Resultant…

Q: A solenoid with radius a produces a magnetic field with strength B pointing into the page. A square…

Q: The figure shows a path of a squirrel, moving from A ( at time t=0), to point D (at 15.0 min). What…

A: From the given graph, determine the x- and y-components of the initial (A) and the final (D)…

Q: 3. If V = 12 V in the circuit below R = 100 N R2= 200 N %3| R3 = 100 N R5= 300 N R4 = 150 N R, = 100…

A: Solution: Given that V = 12 V and the values of other resistors

Q: The absolute index of refraction for a substance is 2.0. In this substance what is the critical…

A: We know that when light ray goes from a substance with refractive index of "n" to air then the…

Q: Q. Figure shows, in cross section, two long parallel wires spaced by distance d=10.0cm; each carries…

Q: ,2 54. A 5.0-kg box has an acceleration of 2.0 m/s when it is pulled by a horizontal force across a…

Q: How would you report the length of the rectangle shown next to the ruler:

A: Given:- Find:- the length of the rectangle 2.3 cm 2.258 cm 4.26 cm 2.2 cm 2.26 cm…

Q: 5) Let's use this expression to solve a problem. Star X and Star Y are intrinsically identical…

A: Given, star X is located 20 light-years from earth star Y is located 40 light-years from earth…

Q: I need help with 14.

A: The mean density of moon is,

Q: Gram is the fundamental unit of mass in SI system

A: SI base unit of mass is kilogram.It is represented by letter Kg.

Q: Jorge is going to bungee jump fro 55.0 m over the river below, The H cord should stop Jorge's fall…

A: hereunstreched length+ stretched length +2m=55m27m +extra stretched length +2m = 55 mextra stretched…

Q: Consider two thin bars of constant cross-sectional area, each of length 10 cm, with respective mass…

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub…

Q: pom 73. A gymnast of mass 52 kg is jumping on a trampoline She jumps so that her feet reach a…

A: m= 52 kg height (h) = 2.5 m stretching in first case (X1)= 75 cm =0.75 m

Q: A particle is moving along the +x axis, and the graph shows its momentum p as a function of time t.…

Q: Two objects having masses m1 and m2 are connected to each other as shown in the figure and are…

A: As there is no friction m2 will move down and m1 will move toward right.

Q: You have a 1 Ci sample of Th 232 which as a measured half-life of 1.45 x 1010 years. From the…

A: Half life of Th-232: T1/2=1.45×1010 yearInitial activity: Ao=1 Ci= 3.7×1010…

Q: A mass m is on a frictionless incline of height H, angle 0, as shown in the picture. The mass lides…

A: We have an incline of height H and inclined at angle Q from which a box of mass m is sliding down.…

Q: 13. How far did this object travel in total? Determine the following: 40 14. The acceleration from…

Q: Two objects having masses m1 and m2 are connected to each other as shown in the figure and are…

A: The two masses m1 and m2 are released, with tension T in the string. Consider the acceleration of…

Q: I need help with 15 please.

A: Given information: The time taken by the I0 to circle Jupiter (T) = 1.769 days = 1.769 (24) hr =…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Formula used

VIEW

Step 3: Calculation of total heat

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) The number of kilocalories in food is determined by calorimetry techniques in which the food is burned and the amount at heat transfer is measured. How many kilocalories per gram are there in a 5.00g peanut if the energy from burning it is transferred to 0.500 kg of water held in a 0.100kg aluminum cup, causing a 54.9C temperature increase? (b) Compare your answer to labeling information found on a package of peanuts and comment on whether the values are consistent.
Unreasonable Results (a) Calculate the rate of heat transfer by conduction through a window with an area of 1.00 m2 that is 0.750 cm thick, if its inner surface is at 22.00C and its outer surface is at 35.00C (b) What is unreasonable about this result? (c) Which premise or assumption is responsible?
In 1801, Humphry Davy rubbed together pieces of ice inside an icehouse. He made sure that nothing in the environment was at a higher temperature than the rubbed pieces. He observed the production of drops of liquid water. Make a table listing this and other experiments or processes to illustrate each of the following situations, (a) A system can absorb energy by heat, increase in internal energy, and increase in temperature, (b) A system can absorb energy by heat and increase in internal energy without an increase in temperature, (c) A system can absorb energy by heat without increasing in temperature or in internal energy, (d) A system can increase in internal energy and in temperature without absorbing energy by heat, (e) A system can increase in internal energy without absorbing energy by heat or increasing in temperature.
In some countries, liquid nitrogen is used on dairy trucks instead of mechanical refrigerators. A 3.00-hour delivery trip requires 200 L of liquid nitrogen, which has a density at 808kg/m3. (a) Calculate the heat transfer necessary to evaporate this amount of liquid nitrogen and raise its temperature to 300C. (Use cp and assume it is constant over the temperature range.) This value is the amount of cooling the liquid nitrogen supplies. (b) What is this heat transfer rate in kilowatthours? (c) Compare the amount of cooling obtained from melting an identical mass at 0C ice with that from evaporating the liquid nitrogen.
One method at getting a tight fit, say of a metal peg in a hole in a metal block, is to manufacture the peg slightly larger than the hole. The peg is then inserted when at a different temperature than the block. Should the block he hotter or colder than the peg during insertion? Explain your answer.
€69. Integrated Concepts (a) A large electrical power facility produces 1600 MW of “waste heat.” which is dissipated to the environment in cooling towers by warming air flowing through the towers by 500C. What is the necessary flow rate of air in m3/s ? (b) Is your result consistent with the large cooling towers used by many large electrical power plants?
The Sun radiates energy at the rate of 3.801026W from its 5500C surface into dark empty space (a negligible fraction radiates onto Earth and the other planets). The effective temperature of deep space is 270C. (a) What is the increase in entropy in one day due to this heat transfer? (b) How much work is made unavailable?
(a) A shirtless rider under a circus tent feels the heat radiating from the sunlit portion of the tent. Calculate the temperature of the tent canvas based on the following information: The shirtless rider’s skin temperature is 34.0C and has an emissivity of 0.970. The exposed area of skin is 0.400m2. He receives radiation at the rate of 20.0 W—half what you would calculate if the entire region behind him was hot. The rest of the surroundings are at 34.0C. (b) Discuss how this situation would change if the sun lit side of the tent was nearly pure white and if the rider was covered by a white tunic.
A bag containing 0C ice is much more effective in absorbing energy than one containing the same amount at 0C water. a. How much heat transfer is necessary to raise the temperature of 0.800 kg of water from 0C to 30.0C ? b. How much heat transfer is required to first melt 0.800 kg of 0C ice and then raise its temperature? c. Explain how your answer supports the contention that the ice is more effective.
Describe the photo of the tea kettle at the beginning of this section in terms of heat transfer, work done, and internal energy. How is heat being transferred? What is the work done and what is doing it? How does use kettle maintain its internal energy?
Integrated Concepts One 30.0C day the relative humidity is 75.0%, and that evening the temperature drops to 20.0C, well below the dew point. (a) How many grams of water condense from each cubic meter of air? (b) How much heat transfer occurs by this condensation? (c) What temperature increase could this cause in dry air?
A 4ton air conditioner removes 5.60107J (48,000 British thermal units) from a cold environment in 1.00 h. (a) What energy input in joules is necessary to do this if the air conditioner has an energy efficiency rating (EER) of 12.0? (b) What is the cost of doing this if the work costs 10.0 cents per 3.60106J (one kilowatt—hour)? (c) Discuss whether this cost seems realistic. Note that the energy efficiency rating (EER) of an air conditioner or refrigerator is defined to be the number of British thermal units of heat transfer from a cold environment per hour divided by the watts of power input.