How much cable coating should be ring cut to snap the armor during a fiber end access method?

Q: Why is it important to keep cable clutter to a minimal in a rack?

A: Introduction: The following are some of the most important advantages to be aware of: Reduces Cable…

Q: What device is there for pinpointing the precise position of a damaged cable?

A: Introduction: A device commonly used for pinpointing the precise position of a damaged cable is…

Q: Why is it important to use plenumrated cabling in the area above the ceiling tile?

A: Plenum-rated cable Plenum-rated cable is an electric cable that is laid in the plenum spaces of…

Q: 1. Express the Boolean expression for the combinational logic circuit shown in Figure 2. D- Figure 2…

A: In this question, we are given a logic circuit and for that we have to first find out the simplified…

Q: When copper cabling is used to carry T-1 traffic, what kind of connector is used?

A: Solution:-         When  ccpper cabling  is used to carry T-1          traffic, what kind of…

Q: How can you know if the ACL is malfunctioning?

A: Access Control Lists (ACL) is an abbreviation for Access Control Lists: The transmission control…

Q: 1- In single mode fibers, which is the most beneficial index profile? a. Step index b. Graded index…

A: 1. (a) Step Index In single mode fibers, the most beneficial index profile is a step-index profile.…

Q: What is the justification for plenumrated cabling above the ceiling tile?

A: Plenum-rated wiring: Plenum-rated cable is an electrical cable that is installed in building plenum…

Q: The "SMA" designation refers to the kind of connection that is used by SMA connectors.

A: The answer is given in the below step

Q: Draw the layout of the Straight-Through and Rolled cable.

A: Straight-Through are  the type of cables that have the pins on each end of the cable. In such…

Q: What are the only EBI pins can have their polarity changed?

A: According to the information given:- We have to define polarity changed by EBI pins.

Q: What kind of technology may be used to estimate the distance between a cable's damage and the damage…

A: Introduction: While excavating equipment is frequently to blame for cable damage, hand held tools…

Q: 13. The total loss in a fiber link is 5.2 dB, the design margin is 0 dB, and the optical budget is…

A: Solution:-    Fiber link loss = 5.2 dB     Design margin = 0 dB Optical budget  = 3.3 dB   To check…

Q: ld you need a crossover wire for a T1 con

A: Introduction: Below the describe why need a crossover wire for a T1 connection

Q: What type of connector is required to connect an Assignment to another shape in Pega PRPC?

A: Flow Action Connector type is required to connect an Assignment to another shape in Pega PRPC.

Q: Question 13 Which of the following causes intrinsic losses in mismatched fiber? (Choose 3) total…

A: A loss that is caused by factors involving the mismatched fiber itself is called Intrinsic loss. The…

Q: Among the following which statement or statements are True? Select one or more: Remove the jacket of…

A: Remove the jacket of the fiber from the outside of the cable using a jacket cutter The sleeve is…

Q: O None of the

A: In n-channel JFET, the drain current is equal to Odds when it's gate to source voltage is

Q: The need of using plenummed cabling in the space above the ceiling tile may be explained in two…

A: Plenum-rated wiringThere are two types of plenum-rated cable: insulated and non-insulated.Part of…

Q: Why is it essential to ensure that there is as little cable clutter as possible in a rack?

A: Reason: The downside of the rack that brings to a decline in both efficiency and performance is the…

Q: Discuss the considerations for selecting the appropriate "connector type" in fiber-optic…

A: The selection of the proper fibre optic connector type holds the key to flawless data transmission,…

Q: The colored line in the cable goes to pin #1 connecting a ribbon cable to a connector, how do you…

A: A ribbon cable is a cable with many conducting wires running parallel to each other on the same flat…

Q: which on impedance is better 50Ω or 600Ω in terms of the cable?

A: impedence

Q: Question 35 Good hardline coaxial cable cores require at least O6 in or 15 cm O12 in or 30 cm 3 in…

A: The correct answer for the above mentioned question is given in the following steps for your…

Q: What must NOT be considered before placing fiber cable in a conduit? (Choose 2) clearance between…

A: 1. Minimum BEND RADIUS. Optical fiber cable installation is as easy as, and in many cases tons…

Q: why Cat 1-4 cables are rarely used today

A: UTP or Unshielded twisted pair cables are used in local area network and PSTN (Public Switched…

Q: Name the tools that are required for making a twisted pair cables? Also write the purpose of each…

A: Twisted pair cable is a type of cabling that is used for telephone communications and most modern…

Q: In a rack, why is it critical to limit the amount of cable clutter to a minimum?

A: Answer Introduction: Organizing the cables in a rack is an art that defines the creativity of the…

Q: What are the advantages of keeping cable clutter to a minimal in a rack?

A: Introduction: Cord or cable clutter occurs when electrical cords get tangled on your desk. This…

Q: Which two powering architectures are commonly used in coaxial cable networks? (choose 2) Distributed…

A: 25.Two powering architectures are commonly used in co-axial cable networks are: 1.Distributed…

Q: difference between straight through cable and crossover cable their use and  pin configuration of…

A: Cable sortsThe most common variety of network cable is named “unshielded twisted pair” (UTP). This…

Q: What are the advantages of keeping cable clutter to a minimal in a rack?

A: Introduction: The Importance of Proper Cable Management: 1. Ease of Use One of the most important…

Q: For what reasons is it critical that a rack have as little cable clutter as possible?

A: This is a major safety hazard that must not be ignored.  If your cables are disorganized and tangled…

Q: You have been asked to design a fiber backbone cabling system for your organization. The equipment…

A: Solution: LX-5 Connector Industry standard color: Green Explanation: LX-5 is one of the best…

Q: What are the advantages of keeping cable clutter to a minimal in a rack?

A: The advantages of keeping cable clutter to a minimal in a rack are :-

Q: Write a program that declare and initialize an array of 10 elements and calculate and display the…

A: Array: An array is a collection of similar type of data elements stored in contiguous memory…