how long will it take to charge a 1000μF capacitor through 1 KQ resistor tofull 16V source voltage? d) forevera) 1000 microsecondsb) 10secondsc) one dayd) foreverWhat maximum voltage can be safely applied to series resistors, 1.2 KQ 14 Wand 680 0%W?a) 9.81Vb) 17.32. Vc)27.07 Vd) 32.52VWhen a capacitor is being charged from a 12V power source, the currentflowing through thecapacitor willa} increaseb} decreasec) remain the samed) can't be determinedCalculate the voltmeter reading in the circuit shown in the figure when wiperarm of the potentiometer is set at 25% up fromthe bottom. note: theresistance value is 3.3 Kilo-ohms.9Va) 2.13 Vb) 3.12 Vc)2.31 Vd) 6.25 V1k3k3

Since you have posted the multiple questions so we are supposed to answer the 1st one.

Answered: how long will it take to charge a…

how long will it take to charge a 1000μF capacitor through 1 KQ resistor to full 16V source voltage? d) forever O a) 1000 microseconds Ob) 10seconds O c) one day O d) forever

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 1) Find out voltage and charge of each capacitor of the following configuration. C1 = 5 µF, C2 =…

A: Series parallel capacitance are consist in the circuit. Find the out voltage and charge of each…

Q: How long does it take to fully charge a 1 nanoFarad capacitor through a 10K resistor?

Q: 10 µF capacitor is charged from a 12 v source through a 7 kohm resistor s an initial voltage of - 3…

Q: 3. A parallel-plate capacitor has a square plates of edge length 1cm and a plate spacing of 0.10 mm.…

A: This question comes under electrical circuit theory . It is based on the concept of formula of…

Q: » If the switch is closed when the capacitor is fully uncharged, how long will it take for the…

A: Circuit diagram is given as,

Q: A transformer having a nominal voltage = 399V and a no load voltage = 420V at its secondary, the…

Q: What did you observe about the time it takes for the capacitor to fully charge (5RC) as the series…

Q: If a 6-µF capacitor is charged through a resistor a 10 k-ohm resistor, what is the circuit time…

A: Given: A capacitor is charged through a resistor. Capacitance, C=6 μF Resistance, R=10 kΩ

Q: 7. Three capacitors are connected in parallel across a 230 V, 60 Hz supply. These capacito have…

A: Given: 3 capacitor in parallel. C1=10μF, C2=30μF, C3=60μF Circuit will be:

Q: A mica capacitor has square plates that are 8 cm on a side and separated by 6.62 mils. What is its…

A: Given, A mica capacitor with square plates has Side, a=8 cm Distance in plates, d=6.62 mils…

Q: With the aid of diagrams/illustrations describe the operation and applications of the following…

Q: Compute the equivalent capacitance Ceq as labeled in (Round the final answer to three decimal…

A: For the given circuit the value of the total capacitance needs to be calculated and the same can be…

Q: The plate area of a parallel-plate capacitor is 0.01 m². The distance between the plates is 2.5 cm.…

A: Given- The plate area, A = 0.01 m2. The distance between plates, d = 2.5 cm. The insulating medium…

Q: In Electrolytic capacitors, the capacitance value can be decreased by increasing O Dielectric medium…

A: Although formula of capacitance is given by C=εAdWhere,ε=Realtive permitivityd=distance between the…

Q: A 1 Megaohm resistor is connected in series with 1 microfarad capacitor. If the circuit is suddenly…

Q: A capacitor of 4.56 uF capacitance is connected to a d.c. source through a resis tance of 1 megaohm.…

A: We have a capacitor which is connected to a D.C source through resistance . We have been asked to…

Q: The circuit shows a network of 4 identical capacitors. When the switch is in position 1, the…

A: Since all the capacitors are identical, C1=C2=C3=C4=C The relation between Capacitor (C) and charge…

Q: Design a C converter by drawing according to the values given below. The C ´uk converter has 24 V…

A: To design Cuk converter We have to find different parameters of Cuk converter

Q: A capacitor of value 100uF is connected across a 200 V, 50 Hz supply. Calculate : (i)reactance of…

A: We have an capacitor with, C = 100 μF = 100 * 10-6 F Voltage (V) = 200 V Frequency (f) = 50 Hz…

Q: Four capacitors of 1µF , 3µF ,5µF and 6µF are connected in series across 300V AC supply. Evaluate…

Q: For the circuit attached, determine: A. The voltage across each capacitor. B. The energy stored in…

A: In this question , we have given an electrical circuit having number of capacitor connected in…

Q: Explain the behavior of the capacitor voltage and capacitor current at the instant the switch is…

A: In this question We need to explain the behavior of the capacitor voltage and capacitor current at…

Q: The value code on a certain capacitor is 222. What is its rated capacitance? A) 2.2 nF B) 222 uF C)…

Q: 1. For the circuit in Figure, determine: (a) the total capacitance, 4 µF (b) the charge on each…

A: Here we will use parallel and series combination of capacitor, then we will find out the voltage and…

Q: 10 0 12µF 12 Q SV 6µF Y ven: C1 = 12 µF C2 = 6.0 µF V = 6.0 Volts %3D R1 = 10.0 0 %3D %3D R2 = 6.0 0…

Q: In the figure a 17 V battery is connected across capacitors of capacitances C1 = C6 = 5.0 µF and C3…

A: given

Q: The energy stored in a 50 mH inductor is 25.6 µJ. The curren through it is : O a. can be any value O…

Q: 4.7uF capacitor is allowed to be charged by a 9-volt battery through a 100 kilo-ohm resistor. what…

A: Given C = 4.7uF V0 = 9V R = 100k

Q: While a 6-µF capacitor is charged through a resistor, the current drops to half of its maximum value…

A: Given Data: time t = 3 second initial current = Io capacitor value = 6 uF

Q: 5. A series combination of an 18.0 mF capacitor and a resistor are connected to a 125 V battery.…

A: From the given information we can draw the circuit as

Q: A capacitor is rated at 1000uF of capacitance. If its minimum value is 850uF, what is its maximum…

A: In this question We need to determine the maximum allowable value. If A capacitor is rated at 1000…

Q: A 2000 µF capacitor is charged by a constant current dc source. After 100 seconds, the voltage…

A: Given data, C=2000 μF∆t=100 sV1=100 VV2=200 V

Q: Refer to Figure If 50V is applied across the capacitors and Q=0.5, determine the voltage on each…

Q: You have two identical capacitors, each of which can hold charge Q, when it has a 6 V potential…

Q: 2. A capacitor stores 6 micro-coulombs of charge with a potential difference of 3 volts across the…

Q: 5) The inductor in the figure A below is 47 uH with a tolerance oftl0%. Given the current waveform…

A: Inductor value L=47 μ H tolerance =± 10 %

Q: 3 µF 4 µF 4. Four capacitors are connected to each other and a battery at 10 V as shown a) Find the…

A: This circuit have series parallel combination of capacitance. Find the total capacitance if switch…

Q: C1 C2 5 uF C6 10 uF 5 pF C5 5 pF C8 5 uF C9 C10 10 uF 15 uF C7 10 uF V 100 V C3 10 uF C4 10 uF C11…

A: we need to determine equivalent capacitance and voltage drop across C6.

Q: 9 What is the capacitor current when the capacitor is fully charged?

A: Q= CV Q= charge stored in the capacitor C= capacitance of capacitor V= Voltage across the…

Q: 4 μF 252 9) An RC Circuit is shown above. The switch has been in position a for a very long time. a)…

Q: Select the value of C to produce the desired total capacitance of CT = 8 µF in the circuit in the…

A: When the capacitors are connected in parallel, Total capacitance can be computed as:…

Q: If the current through a 10 mH inductor is increasing at 5 A/s, what is the voltage across the…

A: Given that L =10mH di/dt = 5A/s The voltage across the inductor is calculated as shown below

Q: What is the voltage across the plates of the capacitor if the capacitance is 10 microfarad and the…

Q: The voltage across a 5uF capacitor increases in a linear fashion from zero volts to 10 volts for the…

A: In this question we will find current through capacitor with given voltage across capacitor…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

how long will it take to charge a 1000μF capacitor through 1 KQ resistor to
full 16V source voltage? d) forever
a) 1000 microseconds
b) 10seconds
c) one day
d) forever
What maximum voltage can be safely applied to series resistors, 1.2 KQ 14 W
and 680 0%W?
a) 9.81V
b) 17.32. V
c)27.07 V
d) 32.52V
When a capacitor is being charged from a 12V power source, the current
flowing through thecapacitor will
a} increase
b} decrease
c) remain the same
d) can't be determined
Calculate the voltmeter reading in the circuit shown in the figure when wiper
arm of the potentiometer is set at 25% up fromthe bottom. note: the
resistance value is 3.3 Kilo-ohms.
9V
a) 2.13 V
b) 3.12 V
c)2.31 V
d) 6.25 V
1k
3k3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

• Three equal value of inductor (L) are connected in parallel, what will be the effective inductance comparing to a single inductor? It will be triple multiple of a single inductor, L*L*L= L3 It will be 3 times the single inductor L It will be 1/3 times the single inductor L No change in value of effective inductor
Find the charge across the capacitor C3 CT C3 E 50μ | 80μF 100μ F 150V O 15000 µC O 15000C 15 μC O NONE
1. Determine the charge and voltage across each capacitor in the following circuit, assum- ing that the battery has been connected for a long period of time. 6.0 nF 1.0 nF 3.0 nF 5.0 NF 3.0 nF 12.0 V 4.0 nF
A capacitor charged to 200 V has 2000 µC of charge. The value of capacitance will be 100 F 100 µF ✓ 10 µF 10 F
The energy required to charge a 10 µF capacitor to 100 V is a) 0.1 J b) 0.05 J c) 5 x 10(-9) d) 10 x 10(-9) J
2.5
refer to attached schematic diagram: How much time is needed to discharge the voltage of the capacitor to 24 V, assume that the capacitor is fully charged? 40 V 5.1 0.51 s 1.5 s Charge 40 V Charge 2k0 refer to attached schematic diagram: If the 2k0 is shorted, what do you think will happen? the capacitor will discharge faster the capacitor will not discharge the capacitor will be damaged the capacitor will not charge change 500μ. 2k0 Dachge 500μ
When charging a capacitor: O the current in the circuit decreases exponentially with time O the current in the circuit decreases linearly with time O the current in the circuit increases exponentially with time O the current in the circuit increases linearly with time
Determine the voltage developed across the 2 mH inductor if the current is 3 sin 6t A. (You must provide an answer before moving on to the next part.) The voltage developed across 2 mH inductor is cos 6t V.
Find the value of the capacitor voltage at steady state when the switch is closed.
What did you observe about the time it takes for the capacitor to fully charge (5RC) as the series resistance R changes? Explain.
)Listen Two capacitors, C = 6 µF and C, = 12 µF, are connected in series to a 100VDC source. The charge on C, is: Da) 3.6 mC Ob) 400 µC c) 800 µC d) 1.8 mC acer