Answered: how do terminal voltage, emf, current…

how do terminal voltage, emf, current leaving battery and internal resistance compare for series vs parallel circuits (ex. would it be greater or less) and why so?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 28PE: Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being...

See similar textbooks

Related questions

Q: For the circuit shown, if I = 30, the reactive %3D power generated by -j4

A: The reactive power generated by the capacitor is given by: Q=Ic2×Xc Where, the current Ic, using the…

Q: Given a set of capacitors: 12nF, 6nF, 9nF, 4μF, 2pF, and 7μF, solve the following problems: 1. Solve…

Q: 1. (a) Briefly explain what happens to the voltages and currents when you connect a battery to a DC…

Q: Series and Parallel Circuit: Open Interactive Simulation A. Construct a circuit containing 5 -…

A: a. if 3 resistors R1,R2,R3 are connected in series, then the effective resistance is the sum of the…

Q: 2. A simplified model of an axon based on a simple RC circuit is shown below. Consider an…

Q: Can the terminal voltage of a battery ever exceed its emf?Explain.

A: emf of a cell is the potential difference across its terminal in open circuit. Terminal voltage of a…

Q: 2. In the circuit below, C1=60µF, C2=20µF, C3=9µF, and C4=12µF. This circuit is connected to a 120V…

Q: 3. A circuit consists of a resistor (R=102), a voltage source (V=10 V), and three capacitors (Ci= 1…

Q: 3. Compare the differences for capacitors in scries and parallel. Then compare the differences for…

A: Compare capacitors and resistors in series and parallel .

Q: 18. Refer to the circuit of Figure 19-64. a. Write the nodal equations. b. Solve for the node…

Q: 9:/ The RC Circuit in the followsthg Figure has R=3 KL and C= 5MF. The Capacitor has Valdage 6 at…

A: The RC circuit in the following figure has R = 3 k ohm a and C = 5 micro F. the capacitor has…

Q: In the figure shown, what is the oquivalent capacitance (in microFarad) of the circuit shown if each…

Q: 1. (a) Briefly explain what happens to the voltages and currents when you connect a battery to a DC…

A: Curren decreases from the maximum value and, the potential across the capacitor will increases. T

Q: 2. The equivalent capacitance of two capacitors in series is 0.03 uF and when connected in parallel,…

Q: What minimum number of 45 W lightbulbs must be connected in parallel to a single 210 V household…

A: Power is given P = 45 W.Voltage source V = 210 V.Current I = 48 A.

Q: Three capacitors 12 µF, 6µF, and 4µF are connected in parallel with an 8 v battery. Determine: 6.…

A: The equivalent capacitance of the parallel combination is C=C1+C2+C3+...…

Q: total energy

Q: 3. Cı = 3 µF, C2 = 4 µF and C3= 3 uF, are connected in series and parallel. Determine the equivalent…

Q: Power factor can often be improved by the use of a capacitor of appropriate capacitance in the…

Q: 3.Consider the RC circuit below. lok a 4K tzó see lok 20k 20k 80k 2mf (a)The switch S has been at…

A: Voltage on capacitor will develop due to left side of the circuit . Since it is given that switch I…

Q: 7. A simple RC circuit consists of a 1-]F capacitor in series with a 2800-0 resistor, a 6-V battery,…

Q: 3. For the following resistor R, voltage I=3A and R-50. The resistor physically supplies power or…

A: Given data: Current (I) = 3 A Resistance (R) = 5 Ω Required: Power (P)

Q: 1. The time constant RC has a unit of second/farad. second/ohm. 1/second.…

A: Given Time constant RC where R= resistance C= capacitance

Q: chapter28-question4 The RC-Circuit has R=8.7 kQ and C=3 µF. The capacitor is at voltage Vo at t=0,…

Q: If three resistors connected in series to a battery. Suppose R, carries a current of 17.5A, R2 has a…

A: Now it is given that all the resistors are connected in series. This means all the resistor will…

Q: 72. The rather simple circuit shown below is known as a voltage divider. The symbol consisting of…

A: (a) We need to find the…

Q: .) Determine Req for the combination of resistors shown below. eq= 7.4411 R₂=11Q R₁ =4Q R₂=19 Q x…

Q: A6 = A C₁= 3µF HI C₂= 4μF T C3= 5µF T 1-What is the total voltage gain in the circuit? 2- What is…

A: Hi, as this problem contains multiple sub-parts, hence the first three sub-parts will be solved for…

Q: 16. a circuit consisting of a battery with an emt of 12V, a vesistor with a resistance of 1.2h2, a…

A: A circuit consisting of a battery with a voltagea resistor of resistanceAnd two capacitors with…

Q: 7. What is the correct order of the capacitances of these circuits, from lowest to highest? Assume…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Question

5.. how do terminal voltage, emf, current leaving battery and internal resistance compare for series vs parallel circuits (ex. would it be greater or less) and why so?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
Integrated Concepts If you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600F capacitor, what is the resistance in the flash tube?
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
Regarding the units involved in the relationship t = RC, verify that the units of resistance times capacitance are time, that is, . F = S.
The [R drop across a resistor means that there is a change in potential or voltage across the resistor. Is there any change in current as it passes through a resistor? Explain.
Consider the circuit shown in the preceding problem. Write equations for the power supplied by the voltage sources and the power dissipated by the resistors in terms
7. A simple RC circuit consists of a 1-]F capacitor in series with a 2800-0 resistor, a 6-V battery, and an open switch. Initially, the capacitor is uncharged. How long after the switch is closed will the voltage across the capacitor be 4.1 V?
i want 4 and 5
7. What is the correct order of the capacitances of these circuits, from lowest to highest? Assume all capacitors have the same capacitance. HHH a. B
Given a set of capacitors: 12nF, 6nF, 9nF, 4μF, 2pF, and 7μF, solve the following problems: 1. Solve the total capacitance for a series circuit and illustrate the circuit. 2. If the series circuit is connected to a 30 V battery, find the total charge. 3. Given the same voltage, solve for the energy.
s. Complete the table using the given three resistors and a power supply below with their respective resistances and voltage as: R, = 30 R2 = 9 Q R3 = 18 Q { = 12 Volts SERIES CONNECTION PARALLEL UNKNOWN CONNECTION R, V, V, V, V,