How can I calculate the reading on ammeter A2

Q: ISV 1кл Di 3КЛ ли 32КЛ DF 5V

A:

Q: Correct me if i am wrong I have studied different formula formula for saturation current.

A: Both are correct.

Q: reaction involve the breaking apart of larger atomic elements into smaller element.

A: In the question fill the blank   .......Reaction involve the breaking apart of larger atomic…

Q: Assuming that the diodes in the given circuit are ideal, v0?

A: The solution is as follows.

Q: A speaker converts electrical energy to blank then to sound energy

A: Speaker:  Input is electrical signal. Output is sound signal.

Q: 1.5 minutes 250mA Find C

A: Given: Time, t=1.5 minutes Current, I=250 mA

Q: If a small power system has a  base power of 5.0 MVA and base current is 1000 A, the base voltage…

A: Given: Base power =5MVA Base current= 1000 Formula used: P=VI

Q: The error for an ammeter is found as ±2%, the true range of the current it can give for 10 mA is

A: Given: The error for an ammeter, error=±2% Current, I=10 mA

Q: As the doping of a pure semiconductor is increased the resistance will Answer:

A: For a pure semiconductor if doping is increased, either free holes or electrons are created. These…

Q: Question 7 Semiconductors has number of valence electrons.

A:

Q: If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage,…

A: According to the given question we are using a 5000 micro farads capacitance , then there is a…

Q: If the average of set of voltage reading is 53V. The precision for one of the reading 52, will be O…

A:

Q: If the average of set of voltage reading is 54.2V. The precision for one of the reading 52.8, will…

A: Average of set of voltage reading 54.2V One Reading= 52.8

Q: what is the power disipated by R1

A:

Q: 120V 60Hz Lload 160mH

A:

Q: If the value of RL in Figure 1 is doubled, the current through each diode will a- halved…

A:

Q: Using the ideal model for the diodes, what is the current I in milliamps if V₁=2.5 volts and V₂=8.0…

A:

Q: Convert 100 micro ohm to Fahrenheit degrees.

A: Since Ohm Ω is the unit of resistance and Fahrenheit is the unit of Temperature. And resistance can…

Q: Rectifier Circuit for nos. 1 to 7. Determine the reading of each meter and PLave. 220V 1k V2 V3

A:

Q: The maximum power that can be generated by a wind turbine is called Select one: O Cut-in Power O…

A: Rated power is the maximum power that any plant will generate.

Q: What is the circuit in the given diagram * ?called R D1 D2. VIN Vo VRI T VR2 Not all above Clamper…

A: we will analyze given circuit for different ranges of input voltages. i.e. when diode will conduct…

Q: R₁ = 50m2 M lov R₂=51² Find the current in the dioden

A:

Q: Please answer in typing format

A:

Q: * What is wrong with this circuit? R₁ 10 kn V₁ 24 V 1N4744A 1 15 V The zener is open. O The zener is…

A: We need to check whether diode is on or off

Q: The arc passes through the body of the insulator is known as O Puncture High current Flashover O…

A: We know that a puncture arc is a breakdown and conduction of the material of the insulator, This…

Q: If the average of set of voltage reading is 56.9V. The precision for one of the reading 53.2, will…

A:

Q: Find The U235 Fule (Gram) In one Reactor? Year In A 2424.24 MW

A: Note: Fission energy present in one 1 atom of U235 is 200 Mev Mass of U235 is 235 gm

Q: Refer to the Figure 2 below, what the the given voltage levels represented by letters A, and B?

A: It is given that:

Q: 2 What is the current passing through resistor (R=180) in the circuit?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: sketch a diagram showing the ohmeter face for a reading of 1.2 k resistance indicate the setting of…

A: The use of an ohmmeter is to measure the resistance between its leads. This resistance between its…

Q: an ammeter has a range of (0-5a) and an accuracy of ±1% of f. s. d. what is the measured value for…

A:

Q: 2. Assuming the diodes are ideal, calculate I, V in the following circuits a) 10V D₁ V 10kΩ -10V D₂…

A:

Q: What is a clamp-on ammeter and what electrical principal does it operate

A: we need to answer What is a clamp-on ammeter and what electrical principal does it operate

Q: Rea Each resistor is 100 2 (a)

A: Here there are combinations of resistors. We have to use the basic methods of simplification of…

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.