Hello good Evening Sir, Permission, i have a question in my homework. The following bellow is question. Please advice. Thank you Regards, Irfan "Oil flows through pipes as shown below" If known : Density of oil = 800 kg/m³ Cross-sectional area (A1) = 10 cm2 Cross-sectional area (A2) = 5 cm2 Velocity (v1) = 120 m/s Temperature (T1) = 283 K Pressure(p1) = 2000 Psi Temperature (T2) = 263 K What is the velocity of the oil flowing out of the pipe? Based on the above case, do the calculations and analysis.

Q: 3. A circular cylinder of radius a is fitted with two pressure sensors to measure pressure at 0 =…

A: Considering Invscid theory

Q: I need help calculating these values using the defined quantites: Fin using the given values…

A: Given dataPond geometry : r = 100 m and h = 8 mThe inlet velocity = 0.5 m/sInlet cross-section = 3 m…

Q: What trend did you notice in the yaw angle-induced error?

A: introduction; yaw angle error is misalignment of the rotor from the wind direction.

Q: SAE 10W-30 oil with viscosity 1 x 10-4 lbf s/ft2 is used as a lubricant between two parts of a…

A:

Q: 7. An incompressible fluid is flowing through two 75mm diameter pipes at a velocity of 2 m/s in each…

A:

Q: ; An air tank has a volume of 2 m³. In the beginning the air pressure in the tank is 150 kPa. Then…

A: The volume of the tank, V = 2 m3 Initial pressure, P1 = 150 kPa Gas constant, R = 287 Jkg-K Initial…

Q: d) An incompressible fluid with density p is flowing through the duct system shown. You may assume…

A:

Q: The pressure drop (Ap) test is carried out using a pipe configuration as illustrated below:…

A:

Q: Determine required input power to motor [1.64 kW]

A: As per policy, we can solve the first problem from multiple questions.

Q: Please fill the table using given data

A: Pump Pump is a mechanical device which is used to convert the mechanical energy into pressure…

Q: gine oil at 40 C [density 876 kg/m^3, viscosity 0.2177 kg/m.s] flows in a 22-cm-diameter pipe at a…

A: The density of engine oil is ρ=876 kg/m3. The dynamic viscosity of engine oil is µ=0.2177 kg/m.s.…

Q: Elevation = 0 m (Datum) Elevation = 200 m Dia = 0.8 m Pump Dia = 1.0 m L = 500 m L = 200 m Elevation…

A: To perform ""Since you have asked multiple questions, we will solve the first question for you. If…

Q: A piston-cylinder is producing a viscous oil flow, which has the flow rate of Q, radius R=1.5 mm,…

A:

Q: 2. Draw HGL&EGL. Tank 1 Tank 2 Tank 3

A: For the solution refer below images.

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.