Heated air at 1 atm and 35°C is to be transported in a 150-meter long circular plastic duct at a rate of 0.35 cubic meter per second. If the head loss in the pipe is not to exceed 20 meters, the fluid velocity, in meter per second, through circular duct is Blank 1 m/s.

Q: What rotational speed must be maintained in operating a 10-in. diameter centrifugal bowl handling a…

A: A centrifugal bowl of D=10in Liquid layer Thickness of fluid layer t=2in Density of fluid ρ=72.5…

Q: Air at atmospheric pressure flows across a staggered tube bank consisting of 8 rows of tubes in the…

A:

Q: 4. Water at 30 °C flows over a wide hot plate at 1.5 m/s free stream velocity. The plate is 1 m.…

A: This is the problem of heat transfer on a flat plate. Given: Water temperature, T∞ = 30∘C or 303 K…

Q: 2. For fully developed, laminar flow of a power-law fluid in a tube, the velocity profile is n+1-…

A:

Q: Do you have a source for the equation for The relationship between pipe head loss, pump head loss,…

A: The relationship between pipe head loss, pump head loss, and impeller speed (n) in a pump system is…

Q: A domestic heat pump system has the condenser coils and evaporator coilsseparated by 10.46 meters.…

A: The length of the hose in centimeters is to be calculated.

Q: (a) Air at 1 atm (abs) is flowing through a tube having an inside diameter of 50 mm at a velocity of…

A: Given a) Ait at P=1atm Tube D=50mm T=350K V=15m/s Find Heat transfer coefficient, h Effect of…

Q: 2. The jet airplane is flying at 80" in still air, A, at an altitude of 4 km. If the air flows past…

A: Velocity at B (VB) = 80 m/s Velocity at C (Vc) = 80 m/s ZB = Zc Density of air at altitude 4 km =…

Q: Air at 1 atm and 400 K and with a velocity of U∞o = 10 m/s flows across a compact heat exchanger…

A:

Q: 7-136 A cylindrical rod is placed in a crossflow of air at 20°C (1 atm) with velocity of 10 m/s. The…

A: Given that- A cylindrical rod is placed in a crossflow air for which, Air ambient temperature, T…

Q: A 3-in Schedule 40 iron pipeline carries steam at 6 atm gauge. The line is uninsulated and is 70m…

A: Given D = 3in P=6atm(gauge) L=70m T∞=25℃           ε=0.7 Find Steam condense per hour %Heat loss…

Q: Consider airflow over a flat plate of length L=1m under conditions for which transition occurs x=…

A:

Q: A smooth pipe consists of 8 m of 120 mm diameter pipe followed by 15 m of 300 mm diameter pipe with…

A: Water at 15 Degree CDensity ρ = 998 kg/m3Viscosity μ = 1.139 * 10-3 m2/sReynold number for small…

Q: Determine the pressure difference between the two pipelines as shown below in the figure. Page=370…

A: Assumption:1) All the liquids are incompressible2) The effect of air column pressure is…

Q: 2–92 A large plate is pulled at a constant speed of U 4 m/s over a fixed plate on 5-mm-thick engine…

A: Given data: U= 4 m/s Thickness t= 5mm= 0.005m Temperature 20oC Velocity Profile is given,

Q: Q1) Air at 34°C temperature and (no) m/s velocity passes across a 2m flat plate length and Im depth.…

A:

Q: -1. An incompressible fluid is flowing at steady state in the annular region (i.e., torus or ring…

A: Given Incompressible fluid Take inner radius = r2 Outer radius = r1

Q: A disk 15 cm in diameter is placed in a wind tunnel at right angles to the incoming flow. The drag…

A: The drag force on the disk when water is flowing through it is to be estimated.

Q: : Determine the pressure difference between the two points in figure below Oil (S=0.75) X- ----- S,…

A:

Q: Calculate the kinetic energy changes

A:

Q: Air enters a rectangular duct measuring 30 cm x 40 cm with a velocity of 8.5 m/s and a temperature…

A:

Q: Compute the capillary rise in mm of pure water at 10 Celsius expected in an 0.8 mm diameter tube.

A:

Q: Head developed by a centrifugal pump depends on its A speed ⓇB impeller diameter both (a) and (b)…

A: In chemical industries pumps are used to transport chemicals from one place to another place. A…

Q: Q1) Water is placed in a piston-cylinder device at 0.5 MPa and 95°C. Determine the work does the…

A: Given: Water is placed in a piston-cylinder device at P = 0.5 MPa = 0.5×106 Pa and; temperature T =…

Q: Paddle agitator

A:

Q: 5-79. In the pipe of Figure 5.65, a water manometer is connected to the ends of a piezometer tube…

A: Given Data: The temperature of air T=80oF=299.817K The pressure of air P1=30 psig=206842.719 pascals…

Q: determine: a. the outlet temperature of the cold water, b. the effectiveness of the heat exchanger,…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: A water pipe is connected to a double-U manometer as shown in Figure below at a location where the…

A:

Q: The time constant has dimensions of: A time B length (© (dimensionless) (D) energy

A:

Q: Air at a velocity of 20 m/s and at a temperature of 29 °C is in cross flow with a cylindrical steam…

A: Given data: Velocity of air = 20 m/s Temperature of air = 29 0C Diameter of pipe = 30 cm Surface…

Q: px 10³ beg 10³

A:

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: A 1m wide belt moves as shown in the figure. Determine the power required assuming linear velocity…

A: Given: width of belt, w = 1 m Length of belt, L = 5m viscosity of liquid, μ = 2 mPa.s ⇒2 × 10-3 Pa.s…

Q: 17.17. The fins on the radiator of your car are about 2 in long. When your car is going 60 mi/h, the…

A: length of fin x=2 inchvelocity approaching the fins  v=40 mi/hr = 17.88 m/s