G(s): 300(s+100) s(s+10)(s+40) Show that when the phase angle of G(jw) is -180, the frequency is 28.3 rad/s. Find the magnitude of g(jw) at this frequency.

Q: Convert 20 sin (wt + 10°) to cosine. A 20 cos(wt + 100) B 20 cos(wt - 80) c) 20 cos(wt + 190) D 20…

A:

Q: The circuit below has been converted to the phasor domain for you. Determine the current leaving the…

A: In this answer we will find the current value using the ohm's law as shown below.

Q: Plot the amplitude and phase spectrum (single and double sided) for the following signal: 1.…

A:

Q: In an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500 Hz,…

A: Step 1:Step 2:

Q: Calculate the phase angle of the inductor current in the AC circuit given below. 150 250

A: The solution ca be achieved as follows.

Q: Compute trignometric F.S for each of the periodic signal. Exprees each of the trignometric F.S in…

A: Since you have posted multiple questions, we will answer the first question for you. If you require…

Q: Plot the amplitude and phase spectrum (single and double sided) for the following signal:

A: It is given that: f(t)=-2+10sin(2π×105t-20°)-14cos(6π×105t+30°)+7sin(4π×105t-50°)

Q: Graph the magnitude and phase of each function versus f. jf (a) G(f) = 1+jf/10

A: As per bartleby expert policy, only one individual question is to be answered. Kindly repost…

Q: Given the following RLC circuit, determine the current i (t) of the circuit using phasors (consider…

A:

Q: What is the time constant for a RC circuit with C = 10 µF & R = 500K 3. if the peak-to-peak value of…

A: The time constant for an RC circuit is given as τ=R×C--->(1) where R is the value of the…

Q: 80 8+j13 The magnitude of the given function is jand the phase (in radians) is

A: Given  Z=808+j13

Q: 5. Determine whether the following signals is periodic or not. If periodic, find the fundamental…

A: In this question,  Check the given signals are periodic or non.      as per our guidelines we are…

Q: For a periodic signal π v(t) = 30 sin 100t + 10 cos 300t + 6 sin 500t + 4 the fundamental frequency…

A: Given- Signal equation, vt=30 sin 100t+10 cos 300t+6 sin 500t+π4.   To find- The fundamental…

Q: A voltage is given by v(t) = 10 sin(1000TTt-30°). Find the amplitude (A), frequency (f), Phase angle…

A:

Q: Replace: 18 w/ -4, 40 w/ -17, -30 w/ 11, -24 w/ -16, and 10 w/ -10. The fundamental frequency is…

A:

Q: 3-11 The waveform shown below represents a single nonperi- odic burst of a sinusoidal voltage.…

A: The waveform shown below represents a single nonperiodic burst of a sinusoidal. Sketch the form of…

Q: A series RLC circuit is connected to a 400-hZ line with an applied voltage of 35.678 V. The resistor…

A: A resistor 'R', an inductor 'L', and a capacitor 'C' coupled either in series or parallel make up an…

Q: Construct a double sided frequency spectrum consisting of both magnitude and phase spectra of the…

A: Construct a double sided frequency spectrum consisting of both magnitude and phase spectra of the…

Q: Determine the value of ER

A: The voltage across resistor can be found by multiplying current through the resistor and value of…

Q: Find the amplitude, phase, period and frequency from v(t) = 12 cos (50t + 10°). Amplitude = Phase, p…

A: Given the amplitude, phase, angular frequency , period, frequency of the given signal V(t) = 12…

Q: If you know that x(t)=Asin(wt+4) And y(t)=Bsin(wt), and 0<p<pi, then Oa) X(t) and y(t) are in phase…

A:

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.