Green light shines through a 100-um-diameter hole and is observed on a screen. If the hole diameter is increased by 20%, does the circular spot of light on the screen decrease in diameter, increase in diameter, or stay the same? Explain. Match the words in the left column to the appropriate blanks in the sentences on the right. The wavelets do not interfere in this case The diameter of the central maximum is inversely proportional to the diameter of the hole The diameter of the central maximum is proportional to the diameter of the hole The hole is too large to observe the diffraction increases decreases does not change diameter. and so the diameter of the spot of light on the screen Reset Help with the hole's

Green light shines through a 100-um-diameter hole and is observed on a screen. If the hole diameter is increased by 20%, does the circular spot of light on the screen decrease in diameter, increase in diameter, or stay the same? Explain. Match the words in the left column to the appropriate blanks in the sentences on the right. The wavelets do not interfere in this case The diameter of the central maximum is inversely proportional to the diameter of the hole The diameter of the central maximum is proportional to the diameter of the hole The hole is too large to observe the diffraction increases decreases does not change diameter. and so the diameter of the spot of light on the screen Reset Help with the hole's

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

QUESTION 3 For problem 35.35 calculate the thickness of the acetone in micrometers if the wavelength of the source is changed to 568.0 nm. 5 sig. figs.
i need the answer quickly
Problem 1 This problem is composed of two independent parts. For each part of the below question, fill in the empty boxes with your answer (YOUR ANSWER MUST BE ONLY A NUMBER; DO NOT WRITE UNITS; DO NOT WRITE LETTERS). Part 1 Young's experiment is performed with light from excited helium atoms λ = 550 nm. Fringes are measured carefully on a screen 1.6 m away from the double slit, and the center of the 15th bright fringe is found to be 8 mm from the center of the central bright fringe and at an angle above the central axis. 0 is given by (CONSIDER THAT IS a): SMALL): b) įt 0.008 1.6 0 = d= Ay = ] Calculate , in SI units. c) [t ] Assume 0 = 0.8°. Find the separation distance d between the two slits of the aperture screen, in SI units. ♦ 1.6 0.008 + 01.6 x 550 x 10-⁹ ◆ d) --Assume d = 3 x 10-3 m. What is the distance Ay between the second and third dark lines of interference pattern on the screen, in SI units?
For part b; does the first side maxima mean m = 1? For part c; the two-frequency system would work by sending out constructive interference patterns, but would not work as well with integers of 1 because the signal would be too strong. For small integers like 3/4, this would not work due to destructive inteference, thus canceling signals for the pilot to receive. Does my answer to part c make sense or am I off base?
A. It appears that there should be a bright fringe at the location of point D. Why isn’tthere? Explain The previous figure is also labeled with points A and B which are at the locations of maximaand points C and D which are at the locations of minimum For Questions b and c below,you will need to discuss whether each of those minima/maxima stays at the same location,moves to the left or moves to the right and then explain your answers for each B. The slit width is slightly decreased C. The slit separation is slightly decreased.
Note:- • Do not provide handwritten solution. Maintain accuracy and quality in your answer. Take care of plagiarism. • Answer completely. • You will get up vote for sure.
solve all for upvote
B2
Q1
Part 2: Hanging mass = 80 g A mass of 80 g was hung from the string and three different harmonics were generated in the string. This shown below in the Setup column (the string is red). The frequency of each harmonic and the frequency uncertainty () has been given. You can determine the harmonic by counting the lobes. To determine wavelength of each harmonic, you must use the blue 4-meter stick provided. The zero end of the 4- meter stick has been exactly lined up with the left end of the string. For the wavelength uncertainty, this is your estimation of how much your measurement of the wavelength could be off by. Last, determine the wave speed and its uncertainty. The formula for the wave speed uncertainty is below (, is the wave speed uncertainty, of is the frequency uncertainty, & is the wavelength uncertainty). Trial 1 2 3 1 max wave speed= min wave speed= 1 2 2 2 Setup 3 11 18 ✓ 0₂ (Hz) (Hz) (m) 46.6 0.1 16.9 0.1 Ov=O₁λ +f0₂ 76.2 0.1 (m) V (m/s) ov (m/s) Using the values you…
For this problem, I know the answer is C but I do not know how to get there. Seeing the steps and equations would be much appreciated. Thank you
I need the answer as soon as possible