!!! > +566 pts /800 Question 5 of 8 > ? A horizontal pipe carries a smoothly flowing liquid of density of 1190 kg/m³. At Locations 1 and 2 along the pipe, the diameters are d₁ = 5.11 cm and d₂ = 3.81 cm, respectively. © Macmillan Learning → Is the flow speed at Location 2 higher or lower than the flow speed at Location 1? cannot tell from the data higher lower The flow speed at Location 1 is 1.91 m/s. What is the pressure difference AP between Location 2 and Location 1 (including its sign)? Ignore viscosity. O Resources Solution ? Hint Submit Answer Attempt 5 d₁ Location 1 Location 2 d2 !!! +566 pts /800 Question 5 of 8 ? ↑ > Macmillan Learning The flow speed at Location 1 is 1.91 m/s. What is the pressure difference AP between Location 2 and Location 1 (including its sign)? Ignore viscosity. AP = -2265.656 Is the pressure at Location 2 higher or lower than the pressure at Location 1? higher cannot tell lower Pa Resources Solution ? Hint Submit Answer Attempt 5

!!! > +566 pts /800 Question 5 of 8 > ? A horizontal pipe carries a smoothly flowing liquid of density of 1190 kg/m³. At Locations 1 and 2 along the pipe, the diameters are d₁ = 5.11 cm and d₂ = 3.81 cm, respectively. © Macmillan Learning → Is the flow speed at Location 2 higher or lower than the flow speed at Location 1? cannot tell from the data higher lower The flow speed at Location 1 is 1.91 m/s. What is the pressure difference AP between Location 2 and Location 1 (including its sign)? Ignore viscosity. O Resources Solution ? Hint Submit Answer Attempt 5 d₁ Location 1 Location 2 d2 !!! +566 pts /800 Question 5 of 8 ? ↑ > Macmillan Learning The flow speed at Location 1 is 1.91 m/s. What is the pressure difference AP between Location 2 and Location 1 (including its sign)? Ignore viscosity. AP = -2265.656 Is the pressure at Location 2 higher or lower than the pressure at Location 1? higher cannot tell lower Pa Resources Solution ? Hint Submit Answer Attempt 5

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 54PQ: Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius...

See similar textbooks

Similar questions

Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a) What is the flow rate in liters per second? (b) The fluid velocity in this hose's nozzle is 15.0 m/s. What is the nozzle's inside diameter?
What is the difference between flow rate and fluid velocity? How are they related?
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
Gasoline is piped underground from refineries to major users. The flow rate is 3.00102 m3/s (about 500 gal/ min), the viscosity of gasoline is 1.00103 (N/m2) s, and its density is 680 kg/m3. (a) What minimum diameter must the pipe have if the Reynolds number is to be less than 2000? (b) What pressure difference must be maintained along each kilometer of the pipe to maintain this flow rate?
Archimedes' principle can be used to calculate the density of a fluid as well as that of a solid. Suppose a chunk of iron with a mass of 390.0 g in air is found to have an apparent mass of 350.5 g when completely submerged in an unknown liquid. (a) What mass of fluid does the iron displace? (b) What is the volume of iron, using its density as given Table 14.1? (c) Calculate the fluid's density and identify it.
What is the greatest average speed of blood flow at 37° C in an artery of radius 2.00 mm if the flow is to remain laminar? What is the corresponding flow rate? Take the density of blood to be 1025 kg/m3.
Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when the nozzle is attached to the hose. The flow rate through hose and nozzle is 0.500 us. Can the flow in either possibly be laminar?
Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is the flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
Concrete is pumped from a cement mixer to the place it is being laid, instead of being carried in wheelbarrows. The flow rate is 200.0 L/min through a 50.0-m-long, 8.00-cm-diameter hose, and the pressure at the pump is 8.00106 N/m2. Verify that the flow of concrete is laminar taking concrete's viscosity to be 48.0 (N/m2) s, and given its density is 2300 kg/m3.