Given: Two cables are tied together at C and loaded with a force P oriented at an angle a clockwise from horizontal as shown below. B A F35 35° 50° Required: The maximum allowable tension is 1000 N in cable AC and 800 N in cable AB. Determine (a) The magnitude of the largest force P that can be applied at point C; and (b) the orientation of this maximum force as expressed by the angle .

Q: I did not pay the subscription amount in order for my questions to be rejected!!! Please I need…

A: Solution: Given: Column Span = 3.3 m fck = 30.5 MPa fy = 472 MPa DL = 3.55 kPa LL = 4.55 kPa

Q: A differential manometer connects two pipes A and B, with fluid of specific gravity equal to 0.8…

A:

Q: Is the Resident Project Representative responsible for ordering supplies and equipment?

A: The Resident Project Representative (RPR) person should work on full time basis whereas the engineer…

Q: In addition to Architects, which other Project Participants are likely to directly contribute to the…

A: The first stage towards that successful work is to design it. A project design is a method of…

Q: Which type of information can be added to BIM? All the answers are correct Schedule Cost…

A: Answer:- All the answers are correct. BIM: Building Information Modelling is the holistic process of…

Q: Who monitors the shop drawings and submittals?

A: Shop drawings are design plans issued by the general contractor that are used to promote the layout…

Q: Write a few words on Contracting for Public Works Project?

A: Contracting of public works project:

Q: Describe the project delivery method?

A: Project delivery method:

Q: Describe the web-enabled project management?

A: Web Enabled project Management is used in storing and managing the project information efficiently.…

Q: What is a punch list and when should it be developed?

A: The objective of the question is to understand the concept of a punch list in the field of civil…

Q: What are the similarities and dissimilarities between RFI and shop drawings and submittals?

A: An RFI (Request For Information) is a formal request from potential vendors for basic data.

Q: Figure 20-7 Questions 1-10. 44 8. 6 38 20 24 34 Ol 76 8 80 84 88 92 10 Match the dimensions…

A:

Q: What is project scope? (Construction Project Management)

A: Project scope - It may be defined as the part of well planning works that involves determining and…

Q: Write a note on issue management?

A: - Issue management is a process in which a issue or problem is investigated, solution is planned…

Q: What are service projects?

A: Although experiences of service project can be as diverse as their developers, it is always useful…

Introduction to Engineering Design

Students are often confused with engineering and design. The term engineering design has two words with different meanings, engineering, and design. The term engineering implies applications of laws and principles of science to design and analyze physical structures and components. In civil engineering, students apply the concept of physics and chemistry to design and build structures and buildings. In engineering disciplines, the term design means determining the dimensions, loads, and associated influences on the component due to the applied loads such as stresses and deformations. The estimation of such parameters is crucial to make the component or structure foolproof.