Given the following section of an earthwork for a proposed road construction on a hilly portion of the route. The width of the road base for cut is 6m for allowance of drainage canals and 5m for fill. Slide slopes for cut is 1:1 and for fill is 1:5:1 Sta. B 3.7 -0.8 +1.8 a. Compute the value of X b. Compute the area in fill. c. Compute the area in cut.

Q: 1. A lot is divided into 10 squares of 10 m. on its side and the elevation at each corner is given…

A: NOTE - : Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: iven the following slope staking notes, the prismoidal correction factor in cu. Yds., to be applied…

A: Basic for cut = 48 ftbasic for fill =40 ftcut slope, s =2:5:1To find:Prismoidal correction factor

Q: settlement of PL^3/24ei at a

A: Given that, Settlement atA=PL324EI. The objective is to determine the SFD and BMD.

Q: Q3). Calculate the cross section area of cut and fill for the followings: St. 1) h = 2m cut at…

A: Cut and Fill : Cut and fill operation in construction is also known as excavation and embankment.…

Q: versus n for each of the five variables. What do the results suggest about the importance of the…

A:

Q: The soil is excavated with a total of 3437.5m³ (including the swell of 25%) of soil. What is the…

A:

Q: of trapezoidal section has to be √3 excavated throught A power Canal hard Clay at the least cost…

A:

Q: Water flows at 25 m^3/s down a rectangular channel made of unfinished concrete. The channel has a…

A: Q = 25 m3/sS = 0.008b = 4 mdepth of water = 2.6 mn = 0.018use increment = 0.1To find:The critical…

Q: How much is the strike separation (i.e., line AB on the map)? Scale: 18mm = 100m 82m 181m 67m 24m O…

A: AB = 32 mm