Given the bipolar junction transistor circuit below, find the total stability factor and the change in collector current for a temperature rise of 75°C. +12V Rc 4702 Temp (°C) Ico VBE (V) 44kN (nA) B 25 0.1 50 0.65 100 20 80 0.48 B

Given the bipolar junction transistor circuit below, find the total stability factor and the change in collector current for a temperature rise of 75°C. +12V Rc 4702 Temp (°C) Ico VBE (V) 44kN (nA) B 25 0.1 50 0.65 100 20 80 0.48 B

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: c. For the circuit shown in Figure, determine lc and VCB. Assume the transistor to be made of…

Q: Solve the collector-emitter voltage (VCE) of Figure 612. VCC T8V Beta = 110 R2 3.9kQ Figure 612…

A: We need to find out collector to emitter voltage for given circuit

Q: 2. Determine the operating point for a fixed-biased transistor with the following values: BDc = 90,…

A: Fixed Bias Circuit- Since, S is maximum. Hence, BJT is not thermal stabilize. In collector to base…

Q: 6) In the circuit below is the LED on or off? 12V + T 10000 1000 N-Mosfet

Q: The on-state conduction losses is low in MOSFET. Select one: O True O False

A: MOSFET is unipolar device is that current is flowing due to majority charge carrier only so there is…

Q: 1.62 a) Find the voltage Ve (Ans:uBY) 20n5 60v V 82 120v b) How mucn power does the 36A 120v Source…

A: Redrawing the circuit with labeling the node voltages as shown in the figure below:

Q: TIODICITET For the N-MOSFET, assume V-0.5V, Find the ranges of V, for the different regions of…

A: In the given question we need to calculate the operating region of transistor for various value of…

Q: A boost regulator has L=0.15 mH and C=0.11 mF with a duty cycle of 0.66 at a switching frequency of…

A: The peak to peak ripple in the output voltage is…

Q: In the emitter follower, the output (emitter) voltage is 0.7V below the input (base) voltage. One…

A: Given emitter follower And The output (emitter) voltage is 0.7V below the input (base) voltage. One…

Q: 3 A peak rectifier (peak follower) Cir cuit is given below. Vs is a GOH3 Sinusuidal Vollage with…

A: Given data, Vp=50 Vf=60 HzR=5 kΩVr=2 V

Q: A C-filtered center-tapped rectifier circuit is used to rectify sinusoid of 110 Vrms, 60HZ. The…

A: Given:V=110 Vrmsf=60HzMinimum output voltage=35Volttransformer ratio= 2:1load resistance, RL=1.8kΩ

Q: For the common base circuit shown in figure find le and VcB. Assume transistor is Silicon.(a=0.98)…

Q: The term "Bipolar" in Bipolar Junction Transistor (BJT) refers to a) Two junctions c) Two polarity…

A: BJT- (BIPOLAR JUNCTION TRANSITION) - bjt is a solid state device current to be flow two terminals…

Q: For positive half of the signal below, what is the peak output value of the circuit? NOTE: .use…

Q: XProblem No.1 (PI). A fixed bias NPN BJT (Beta = 90) circuit is connected to a 16VDC supply with the…

A: Given: Brief description: In the above given question they have mentioned an analog discrete…

Q: Determine Vx and the mode of operation of the PNP transistor shown in the figure below. Assume Is =…

A: Right Answer option (b) Vx=0.577 volt active Mode

Q: 20 V 10V -20 V

A: The input peak voltage is 20 V. For a positive half cycle, A diode will be in reverse bias…

Q: 2. A three-phase half-wave controlled converter is constructed using 3 SCR devices. The circuit is…

A: According to guidelines we are allowed to do only first question. Please post again for remaining…

Q: Problem #6: An abrupt p-n junction varactor is used to tune an oscillator shown in Figure 3. At zero…

Q: 2. In the emitter follower discussed in the lectures, the output (emitter) voltage is 0.7V below the…

A: The given circuit diagram is shown below: The given graph is shown below:

Q: H. W. of Lecture L(7-2)C 1. Determine whether or not the transistor in figure above is saturated for…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: Q-2: Explain the saturation of a transistor. Find the given unknowns for the figure below. a. Rc. b.…

A: The solution can be achieved as follows.

Q: Fill in the following blanks 1- for normal operation of a PNP , the base must be -------- with…

A: We have to answer one question at a time.So Solving the question first only.

Q: For a HWR circuit using silicon diode, with a load resistance of 2k ohms. If the 50Hz sinusoidal…

A: Given, A half wave rectifier uses Si diode. RL=2 kΩf=50 HzVm=250 V

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Id.…

Q: How many pn junctions are there in a BJT?

Q: What type of semiconductor device is the following current-voltage relationship most likely to…

Q: ww 2:2 ww Vec www. ☺ W Re UNP Voll

Q: the effect of doping concentration on the position of Fermi level

A: Fermi level position wrt to Conduction band given by Ec-Ef = kT ln(Nc/Nd) Where Nd is doing…

Q: P By using mathematical approach fin! @VGS O ID © VDS For the figure 16 V 2k- Vi 2 M2 VP= -8 V

Q: Q7:- (a) Design the circuit in figure below to maintain VL at 12V for a load current (IL) variation…

Q: Determine the I I,V and V for the transistor circuit in Figure. B, cBE Rc 430 0 Vcc Poc =50 24 V 4.7…

A: Given,

Q: The term "Bipolar" in Bipolar Junction Transistor (BJT) refers to O Two diodes O Two polarity…

A: We need to tell about BJT

Q: Determine Pz max for the Zener diode in the network to maintain Vl at 12v for a load variation Il…

A: In this question we need to find a PZmax .

Q: What is the Q-point for a biased transistor as in Figure F with Ig = 70μA, BDC 110, Vcc = 24V, and…

Q: Assume a knee voltage of 0.7V and B-120 for all transistors. Determine the Ve. 5VDC CO 1 0M2 3002 Vc

A: Redraw the circuit diagram,

Q: 5. A JFET has a specified pinch-off voltage of 5 V. When VGs = 0, what is Vps at the point where the…

Q: Given the transistor circuit with beta as 100. Answer the following items below. 270 k Ohrh -16 V…

A: The solution is given below

Q: 19. A biased clamper is connected to a rectangular AC input with 20V on the positive half cycle and…

A: CLAMPERS: The clampers circuit is used to insert a d.c component into the applied input signal, by…

Q: 9 why transistor is the base current in a So much les thon the cellector current?

Q: 04:- Design a bias circuit for NPN silicon transistor having a nominal B-100 to be used in voltage…

Question

2. Given the bipolar junction transistor circuit below, find the total stability factor and the change
in collector current for a temperature rise of 75°C.
+12V
R.
44kQ
Re
4702
Temp
(°C)
Ico
V3E
(V)
(nA)
0.1
50
0.65
100
20
80
0.48

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Solve for the required value of RD, in kOhms to achieve a drain current ID=5.51mA. VDD=15.38V RG=1MOhms VGS(off)=-4.17V IDSS=14.37mA VD=10.22V
A stabilization circuit has a stability factor of 0.04 and an internal resistance of 5 2. The unstabilized voltage can vary between 75 and 100 V, and the load current can vary from 40 to 80 mA. Determine the maximum and minimum values for the stabilized load voltage.
A base bias method is used in the following circuit. For Bpc - 300, the value of emitter current is: -Vc. +15 V Rc 1.8 k2 RB 560 k2 7.82 mA O 6.84 mA O 7.27 mA
The main types of field effect transistor are JFET and MOSFET b. UJT and FET O C. BJT and FET O d. None of the above
For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener voltage. The zener impedance for this current range is O a. 50 Ob. 10 - c.0.1 Ω Od. 10 Q
Find the value of the Beta
For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener voltage. The zener impedance for this current range is O a. 50 Ob. 10 - c.0.1 Ω Od. 10 Q
n channel MOSFET usually operates in mode for positive VGs. saturation depletion O None of the given choices enhancement
Time left 1:46:17 A bipolar junction transistor is described in the figure below. The transistor is implemented in the circuit with Vcc, Rc, and RB equal to 16 volts, 2k, and 10kn. Determine the value of Vout if Vin = 1.1V. V... in RB B Vec Ro V E out