Given the ACL below:   Router1>ena Router1#config t Router1(config)#access-list 10 deny host 207.207.7.18     Router1(config)#interface GigabitEthernet0/0 Router1(config-if)#ip access-group 10 out Router1(config-if)#exit Router1(config)#   Which statement below will overcome the “Implicit Deny”?     A Router1(config)#access-list 10 permit any   B Router1(config)#access-list 100 permit any   C Router1(config)#access-list 10 permit any any   D Router0(config)#access-list 10 permit any

Q: n Figure 4.0, Router Rl and Switch Sl need to be configured to support router-on-a stick inter…

A: SWITCH CONFIGURATION: Switch#show running-config Building configuration... Current configuration :…

Q: Ql: Given an IPV4 address 165.70.58.0/23, design and apply an IP addressing scheme for the topology…

A: I have answered below:

Q: Question 22 IEEE S02.1q is used Only on Cisco equipment Along with IEEE 802.3ac Only with ISL With…

A: Since you have asked multiple questions as per guidelines we can answer only one please repost the…

Q: . Explain how nmap tool can be used by both network administrator and hackers.

A: Nmap(Network mapper) Nmap is a free, open-source tool for vulnerability scanning and network…

Q: Refer to "show ip route" output of R1, what the router will do with the packet that has a…

A: Lets see the solution.

Q: The diagram below ustrates a NAT-enabled router connecting a LAN to the Internet. The IP addresses…

A: Answer is attached in step 2 along with explanation.

Q: Q1 : Why do we need to divide networks into areas when using OSPF ? Q2 : Write an equivalent…

A: Given: Need of dividing Networks into areas  Write an equivalent access-list to the given one (i.e…

Q: Instructions: Given the following Class C 192.168.10.0 network and subnet mask combinations given in…

A:

Q: A- Configure the redistribution on redistributed router i.e. RID for IGRP & OSPF in the following…

A: Redistribution configuration for RIP Steps: 1. Create an access-list in order to match all networks…

Q: 255.255.255.192 is subnet mask used by a local subnetwork, what is the maximum possible hosts…

A: Given that 255.255.255.192 is a subnet mask used by a local subnetwork what is the maximum possible…

Q: Assignment 5.2 You have a network address 64.64.20.0/22 and it must support the network shown in the…

A: According to the information given:- We have to define the following mentioned network and create an…

Q: RIP (Routing Information Protocol) use version2 Make interface in R2 passive-interface

A: RIP (Routing Information Protocol) use version2 Make interface in R2 passive-interface

Q: nslookup tracert netstat ping The command that is used to test the connectivity between two devices…

A: netstat shows whether the connection between the two devices has been established or not.

Q: a. Where will a packet destined to address 142.14.1.5 be forwarded? b. Where will a packet destined…

A: A)  When we compare the address 142.14.1.5 with the first destination address 142.14.1.4 , the…

Q: write an access control list which should only allow 192.168.10.0 & 192.167.10.0 & 192.166.10.0 to…

A: write an access control list which should only allow 192.168.10.0 & 192.167.10.0 &…

Q: You have a class c/28 subnet mask. 195.168.30.126 is a host.

A: You have a class c/28 subnet mask 195.168.30.126 is  a _______ host.

Q: root@kali:-# nmap pl-65535 192.168.1.127 * *open Starting Nmap 7.60 (https://nmap.org ) at…

A: All communication that happens over the internet is exchanged via ports. Every IP address contains…

Q: 1) In the CIDR subnet specification, 192.168.48.0/19, how many bits are used for host addressing?…

A: Question 1: In the CIDR subnet specification, 192.168.48.0/19, how many bits are used for host…

Q: Using NA 172.20.0.0/16, determine the network address with VLSM. Write down the Subnet Mask, Network…

A: VLSM which occurs when an internetwork that uses more than with the one mask for different subnets…

Q: LAN1 Usable #of Hosts: 100 Users Network Address: ?

A: I have answered below in the description.

Q: The difficulty with multicasting from a practical point of view is : a. memory allocation is…

A: The difficulty with multicasting from a practical point of view is

Q: Write the following Wireshark display filter expressions to dis- play: a) any traffic except with a…

A: Since there are multiple parts in a question so first three parts will be answered. Please upload…

Q: Based on lab exercise in P2 (Figure 2), answer the following questions: a. How many targets are…

A: Dear Student, nmap 161.139.246.215-219 Will scan for 5 target hosts ie 161.139.246.215,…

Q: 6. An ISP assigns a customer a /23 IPv4 address block. a) The maximum number ofbits the customer can…

A: Internet service provider: The ISP is defined as the interface or the platform that is used to…

Q: What is the IP address for the requested Host Domain?

A: What is the IP address for the requested Host Domain?

Q: эсхоо ах Design 4 networks each with 6 hosts for network 10.10.10.0 then write for each network: -…

A: Solution::   Step 1     The address 10.10.10.0 belongs to class A IP address where number of network…

Q: Identify the respective class, network address and host address of the given IP address.…

A: NOTE:“Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: destination IP address and Source IP address

A: Destination IP address: The location to which a casing or parcel of information is sent over an…

Q: Q1. For The Figure Below find the successor and FS (EIGRP) for path from R1 to Network 192.168.2.0…

A: Your answer is :

Q: B) For the Figure below, determine the best path from RouterA to Network 40.40.40.40 if RouterA…

A: Answer: We need to explain the which option should be selected among all and what is the condition .…

Q: R1#sh ip route -output omitted- 172.16.0.0/16 is variably subnetted, 4 subnets, 2 masks C…

A: IP routing: IP routing is the process of forwarding data packets from one network to another network…

Q: Use the Wireshark packet list display window, shown below, to answer the following question. Source…

A: The fundamental occupation of a web server is to show site content through putting away, handling…

Q: Subnets used: For the LAN addresses, you must use the classful network space 192.168.13.0. Use the…

A: Subnetting is a process in which large network is divide into smaller IP networks in order to obtain…

Q: Using the following snort rule as a model, write one rule that would detect all of the packets…

A: the answer is given below:-

Q: instructions: Given the following Class C 192.168.10.0 network and subnet mask combinations (given…

A: Class C has a subnet mask of /24 or 255.255.255.0. We are using here a subnet mask of /26 or…

Q: Use the Wireshark packet list display window, shown below, to answer the following question. Source…

A: Explanation: The above host 192.168.1.5 is used for data requests in the GET method.

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.