Given engine oil at 60 oC flows over the upper surface of a 5 m long flat plate which temperature is 20 oC. Justify the value of x (m2/s) to get the turbulent flow for the total drag force and the rate of heat transfer per unit width of the plate. Discuss your idea

Q: Consider laminar flow entering a tube. Before the fluid enters, the velocity profile is constant and…

A: Hydrodynamic entrance length for laminar flow through pipe (zent = 0.05 x D x Re) Where, D = Pipe…

Q: ninar flow o ver a flat plate thickness at the end of th for the same free stream v watcr and air…

A:

Q: A 0.75 m by3m flat plate is towed at 5 m/s on a 2.5-mm-thick layer of SAE-30 oil at 38°C, with…

A:

Q: Problem 6: A cube with edges of length L = 0.23 m and density g. = 3.2x10³ kg/m³ is totally…

A: Length of the cube, L= 0.23 m Density of the cube, ρc= 3.2×103 kg/m3= 3200 kg/m3 Density of the…

Q: Air at standard pressure flows across a flat plate at 3m/s. The temperature surface is 50oC and the…

A:

Q: Imagine a plate 1 m long by 1 m wide at a temperature of 80 °C. Water is passed over its surface at…

A: Length of the plate, L=1 mWidth of the plate, W=1 mTemperature of the plate, Ts=80oCSpeed of water,…

Q: A 1 m wide and 3 m long flat plate, held stationary, parallel to the flow direction of a uniform on…

A: find the drag coefficient on the plate.

Q: Water at a temperature of 25oC flows parallel over a flat plate with free-stream velocity of 2 m/s.…

A:

Q: A flat plate with surface area of 3.4 m2m2 is sliding on a horizontal table with 4.2 mmmm thick oil…

A:

Q: Q5) Air at -10°C flows over a flat surface at 10°C with a free stream velocity of 80 m/s. The length…

A: given data air temperature = -10°C air speed = 80 m/s surface temperature = 10 °C length of plate =…

Q: Consider laminar flow of water over a flat plate of length 1 m. If the boundary layer thickness at a…

A:

Q: 1-The wind blows with velocity 0.4 m/s parallel to the both sides of a flat plate with rectangular…

A: Note: As per Bartleby guideline only 3 subparts have to be solved at the time. So, upload other…

Q: Air at standard pressure flows across a flat plate at 3m/s. The temperature surface is 50oC and the…

A: V= 3m/sTs = 500 CTo = 200 Cx=1 m

Q: a) Air at 30°C (density=1.165 kg/m³, kinematic viscosity = 16x10-5 m²/s) flows over a flat plate at…

A: According to question:- density of airρ=1.165kg/m3kinematic viscosity of airν=16×10-5m2/sfree stream…

Q: Air with free stream temperature of 10 C is flowing over a flat plate (1.5m long and Im wide). The…

A:

Q: Air is flowing at a speed of 30 m/sec over a flat plate. The air temperature is 20o C and its…

A:

Q: Example 6. For free flow of air over a plate, it is given that Grashof number is 7 x 10° and Prandtl…

A: Given:Gr=7*109Pr=0.25

Q: Air flow at a constant speed (Ug = 10 m/s) is forming a two-dimensional incompressible laminar…

A: For solution refer below images

Q: 4. During a cold winter day, wind blows parallel to a 4 m high and 10 m long wall of a house. If the…

A: Given: The height of wall is h=4 m The length of wall is L=10 m The temperature of air is T∞=5°C.…

Q: Air at standard pressure flows across a flat plate at 3m/s. The temperature surface is 50oC and the…

A:

Q: Helium at 20° C and low pressure flows around a thin plate 1 m long and 2 m wide. You want the…

A: Given, Length = L = 1 m Width = B = 2 m Temperature = T = 20 oC = 293 K Frictional resistance = F =…

Q: An incompressible fluid flows over a flat plate with zero pressure gradient. The boundary layer…

A: Given:Initial velocity of fluid= v1final velocity of fluid=4v1v2=4v1Boundary layer thickness=1 mm…

Q: In your own words, list at least three “red flags” to look out for when performing laminar boundary…

A: Red flags while performing laminar boundary layer calculations: 1). Boundary layer calculations are…

Q: s given that Grashof nu

A:

Q: Consider an airflow over the surface of a flat plate with a temperature Ts = 250 °C. At some…

A:

Q: 3-Air flows over the flat plate at velocity 3 m/s and ambint temperature 15 C.The plate is maintaned…

A:

Q: To test the heat transfer for the famous Goodyear blimp, a small-scale prototype is being tested in…

A: Given Data: Cylinder Diameter D = 1.2 m Cylinder Length L = 6 m Wind  Velocity V = 6 miles/hr Wind…

Q: You are designing an IC heatsink which uses round pins in cross-flow.  The heatsink must dissipate…

A:

Q: Air at 20 C is flowing over a flat plate ( 6m long and 1.5m wide). The plate is maintained at 140 C.…

A:

Q: determine the type of flow.

A: determine the type of flow.

Q: Provide an example list of Laminar and Turbulent Flow.

A: ● Laminar flow is a smooth flow which flows without any interference or intermixing of fluid layers…

Q: Air at 20 °C flows over a flat aluminum plate at 30 m/s to cool electrical components on the other…

A: Solution :- Given data :-air at 20 °C                   flat aluminum plate =30 m/s…

Q: Q3: A square flat plate of 1 m² area whose two surfaces temperature is 90 °C is cooled by air at 20…

A:

Q: 8- Air (p = 1.21 kg/m') flows over a thin flat plate 1 m long and 0.3 m wide. The flow is uniform at…

A:

Q: Lated to Reynolds numb Re & Re (C

A:

Q: What is mean transport area? How can this be used in solving geometric considerations for mass,…

A: transportation area- transportation area define by mode of transportation of object or people. with…

Q: Briefly explain the shear stress and velocity profile for turbulent flow

A:

Q: Engine oil at 40°C flows over a 20-m-long & 3-m-wide smooth flat plate with a free-stream velocity…

A:

Q: (B) The space between two large plane surfaces kept (2.5 cm) apart is filled with liquid of…

A:

Q: A 1.5-m-long and 0.5 m wide flat plate is immersed in water flow with velocity of kg 5 m/s. (F= 1000…

A: note : ?as per our company guidelines we are supposed to answer ?️only first 3 sub-parts. Kindly…