Given : E=117 Vac R1 =45 Ohms R2 = 72 Ohms XL = 50 Ohms R1 R2 L1 Vac Find: RT = Z= Phase angel = - IT = 8.

Q: List the minimum trade size Type EMT for each of the following applications. (Objective 12-1)…

A: As per Bartleby expert policy only first individual question is to be answered. So, answering only…

Q: Considering the termination temperature ratings of the equipment used in residential wiring, discuss…

A: In residential wiring the selection of conductor ampacity is always determined based on the 60°C…

Q: What are the ATEX requirements of the explosion protected equipment?

A: Understanding ATEX Requirements for Explosion-Protected EquipmentIn industrial environments where…

Q: Define a wiring diagram?

A: The wiring diagram is the diagram that show the details of all the connections of the objects…

Q: what code article deals with securing and supporting emt conduit?

A: NEC (National electricity code) is a set of standards for safe installation of electric wiring in…

Q: A 4" conduit installed with 4 # 750 kcmilTHWN-2, and 1 #1 THWN conductors. The conduit due to…

A: It is given that: Pull boxes are utilized in straight pull configuration so that the conduits enter…

Q: What kind of instrument is capable of determining the distance to the place of cable damage?

A: The explanation is as follows.

Q: Why is it crucial that cable systems be installed and maintained in accordance with a structured…

A: We need to explain why is it crucial that cable systems be installed and maintained in accordance…

Q: Service conductors supplying a building or other structure must not of another building or other…

A: From Article 230 of National Electric Code (NEC), the following information can be obtained:Service…

Q: a metal device box has four 12 AWG conductors, two internal clamps, and a duplex receptacle. Total…

A: A metal device box has four 12 AWG conductors. According to the national electric code table,…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.