Given cirwit. 4 Vpp 20012 V₁ 560 M&M&M R2 6801 R₁ C₁ TIUF 6₂ N V₂ 470R 2 R3 INF 07 Calwlate the expected valves V₁ and V₂ (and phase angles).

Q: The output voltage waveform of a four quadrant chopper is shown in figure. In the waveform, Vdc is…

A: First write the expression for given output voltage waveform and than evaluate the rms value of the…

Q: lve for the Vrms (magnitude only) across the resistance if R2 = 1000 ohms and Xc = 2363 ohms. %3D HE…

A:

Q: In case RL load, it is desired to get an average load voltage of 75 V. Determine the firing angle if…

A:

Q: A single-phase load has an active power of P = 2 kW at 180 V @60HZ and the power factor is cos% =…

A: a) Apparent power, S S=20000.75   =2666.67VAQ=2666.67*1-0.752   =1763.83VAR

Q: Express R1 using Rx, Ry, and Rz when performing wye to delta conversion R3 no Rx Rz R2 R1 Ry O A.…

A: we need to express R1.

Q: For the circuit shown, determine the current through the 2+j5 ohms impedance.

A:

Q: What is the use of finding phase margin? How will you determine stability using phase margin?

A: we need to know What is the use of finding phase margin? Usefulness of finding phase margin: phase…

Q: 5.0 8.2 32 20 LIOV 0-907 0-62 e Solve for the branch crvents and show current direction by souper…

A: In this question,  Find the current in each branch using the super position theorems

Q: In the Synchronous machine phasor representing Blondels two reaction theory, which of the following…

A: Question:  In the Synchronous machine phasor representing Blondels two reaction theory, which of the…

Q: what will be the power factor, if the inductive reactance is equal to the capacitive reactance of 20…

A: Given: Inductive reactance is equal to capacitive reactance of 20 Ω XL=XC=20 Ω The resistance is 20…

Q: What is the apparent power if the reactive power is 300 VAR and real power is 700 W? 761.6 VA 14.14…

A: Reactive power Q=300 VAR. Real power P=700 W.

Q: The sum of the following two e.m.fs will be e1 = 10 sin wt and e2 = 10 cos wt O 10 O 20 sin wt O…

A: We need to find out the resultant of two sinusoidal signal

Q: : sketh the output veltage for t following circut V: aka ス。 SD, -70

A:

Q: I. CIRCUIT DIAGRAM. R1 L1 150 26.5mH C1 100 Vrms 60 Hz =132.63µF 0°

A: In series RLC Circuit,XL=XC   Resonance ConditionXL>XC      Inductive Circuit  (R+j XL-j…

Q: Q5 For the network shown. 24 V Determine Zi, Zo, AVNL, AVL and Aps. Find the output 5.6 K voltage…

A:

Q: Solve for the Vrms (magnitude only) across the resistance if R2 = 1052 ohms and Xc = 2217 ohms. HE…

A:

Q: Find Zc || z, = 12 + j52 Z2=7- j242 z,=8+ j6N ZA O 24.763 - j34.568 ohms 20.14 - j51.48 ohms 55.06 +…

A:

Q: R. Ro b. Toad the circuit in the a lo ad f ormed by figure, there 's seric s Ro and the in ductance…

A:

Q: A 5 OH MS RESISTOR IN SERIES WITH AN INDUCTOR HAVING ANINDUCTANCE OF L= 15,92 MILLI HENRY IS…

A: Note: As per the  guide lines of the bartleby we are supposed to solve 3 questions, when they are…

Q: The pu impedance of a circuit element is 0.15. If the base kV and base MVA are halved. Then the new…

A: Given, Per unit impedance of a circuit element, Zpuold=0.15. New kV values, KVnew=12KVold. New MVA,…

Q: P 64W 8. 20 Rr 50n

A: The solution can be achieved as follows.

Q: For the circuit shown below, detemine the voltage of the -j10 2 capacitive reactance.

A: The circuit is as shown below :

Q: What is the calculated phase angle between the load voltage and current? Using the calculated phase…

A: V=10 V peak f=1 KhZ   For given load we have to find load phase angle  power factor apparent power,…

Q: f=2000Hz Find the currents IAB, IBC, ICA, IaA, IbB, IcC, Iba, Icb, Iac.

A:

Q: Leading power factor implies that current leads voltage-a capacitive load Select one: True C False

A:

Q: For the circuit shown, determine the Thevenin equivalent voltage seen from the terminals marked A)…

A:

Q: For the circuit of the following figure, if R=26 0, Zc=-J26 0, and ZL=J30 0, and if the value of the…

A: you know, S =VI* =P+jQ where S = complex power            V = Supply voltage             I = CURRENT…

Q: Question: A 1-phase full bridge inverter can operate in load commutation mode in case load consists…

A: A single phase bridge inverter can operate in load commutation mode in case load consists of  1.…

Q: QUESTION 4 A resistor, a capacitor, and an inductor are connected in series with a function…

A:

Q: 02Agle phae aveltag cnterin the figure elm haaret ad of end the ingut vetape i 1201, se l. The deles…

A: We will derive output rms voltage from the given firing angle.  From obtained output rms we will…

Q: Average active power in a Three Phase Circuit= W Select one:

A: Active power in a 3 phase circuit can be calculated by two method either by line current line…

Q: Find ZA || z,= 12 + js2 z2=7- j24 2 Z3= 8+ jó 2 ZA 15.675 + j49.219 ohms O 24.763 - j34.568 ohms…

A: In this question we will find impedance using star to delta transformation.....

Q: Determine the nodal voltage V1 if l=2L35° A, and R=8 2, for the following figure: -j2 N V1 20/-90° V…

A: Voltage V1 using nodal analysis and phase difference between voltage source and current source?…

Q: For the circuit below, find Vout & phase angle between Vin & Vout, identify if it's (Lag/Lead) = in…

A:

Q: 8A voltage of 25020 is ad pplied to Inquctive cirwit of mpedance q Sompedance (5+40) caleulate…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance…

Q: BJT with VCC=10v, RC=9.8Kohm, B=100 and RB=200Kohm. VBB= ? *

A: VCC=10 VRC=9.8 kΩβ=100RB=200 kΩVBB=? emitter current IE=VCC-VBERBβ+RC=10-0.7200kΩ100+9.8kΩIE=0.7 mA

Q: 62 30/0° V rms -j22 Determine the power factor of the entire circuit of as seen by the source.

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Input voltage is 120 v, solve the output current

A:

Q: Compute the value of the following twiddle factor:   W4 16

A: In this case, the following twiddle factor is to be determined: