Given a system of pulley below. Block A has a mass of 50 kg. At point P it is recorded to have a velocity equal to 12 m/s with on increasing acceleration of 6.5 m/s^2. Determine the power input to Motor at M at this instant if its efficiency is given to be 0.80.

Q: A motor vehicle of mass 1000 kg has road wheels of 600 mm rolling diameter. The total moment of…

A: Given: The mass of motor vehicle is m=1000 kg. The diameter of wheel is d=600 mm. The moment of…

Q: The piston of an internal-combustion engine is connected to its connecting rod with a “wrist pin.”…

A: Given   Mass, m = 0.5 kg Acceleration, a = 2500 m/s2 Find   Force on the wrist pin, F

Q: Pravinbhai

A: The objective of this question is to determine the shortest time it takes for the car to reach a…

Q: Determine kinetic energy of a 10 lb mass moving at a velocity of 5 ft/sec. Provide your answer in Ib…

A:

Q: A man who weighs 180 lbs.is riding in an elevator. Find the force exerted on the man by the floor of…

A: Given Data The weight of the man is: w=180 lb (a)

Q: You are controlling a satellite with a mass of 300 kg. The main and lateral thrusters can exert the…

A: Given: mass→m=300 kg →Fmain=600 N    (in horizontal direction) →Flat=100 N   (in vertical direction)…

Q: A 500 pound weight is attached to a cable that is being lifted by a 10 inch diameter drum.  The 48V…

A: given:N=800RPMT=500 in-pound

Q: Select Greater than, Less than, or Equal to.). Greater than v The final height up the ramp reached…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.