Given: A square tank (open to the Atm) holds 3 feet of oil on top of 6 feet of water. An outlet pipe that is 2 inches in diameter provides an outlet for the water. The outlet is located 2 feet above the bottom of the tank. Find: Neglecting friction energy loss, determine the discharge of water out of the tank. The specific gravity of the oil is 0.86.

Given: A square tank (open to the Atm) holds 3 feet of oil on top of 6 feet of water. An outlet pipe that is 2 inches in diameter provides an outlet for the water. The outlet is located 2 feet above the bottom of the tank. Find: Neglecting friction energy loss, determine the discharge of water out of the tank. The specific gravity of the oil is 0.86.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

b) Two pipes (at points A and B) have been connected with the manometer as shown in Figure Q1. i) Determine the pressure at point B if the pressure at point A is 10 kPa. ii) If pipe at point B is not connected with the pipe and open to the atmosphere, what happens to the current manometer? A. B. 0.3 m Water Spesific Weight for Air = 11.43 N/m³ 3 m Oil (sg = 0.86) Figure Q1: Compound manometer
Water and oil flow in two pipeline in figure below using the double U-tube manometer as connected ,find the pressure difference PA-PB (PSI)? - Air G 1.5 ft Water 0.5 ft SAE 30 B 2 ft 2,5 ft - Mercury
Hemispherical dome - SG = 0.8 4 m 60 kPa 3 m 3 m Water 2 m B
i need the answer quickly
(a) The speed of an aircraft flying at an altitude of 11 km is measured by a pitot-staticprobe. If the differential pressure reading is 12.9 kPa, determine the speed of theaircraft in km/h. Take the density of air to be 0.4135 kg/m3
A cylinder is placed in a steady water flow as shown. Calculate the pressure difference PB - PA in psi if the flow speed at A is 10 ft/sec. .A O 1.04 O 1.53 0.67 1.92 0.82 O 1.74
please solve in 40 mins i need help i will give you positive feedback
Argon gas flows through a well-insulated nozzle at steady state. The temperature and velocity at the inlet are 570°R and 150 ft/s, respectively. At the exit, the temperature is 460°R and the pressure is 40 lb/in². The area of the exit is 0.0085 ft². Use the ideal gas model with k = 1.67, and neglect potential energy effects. Determine the velocity at the exit, in ft/s, and the mass flow rate, in lb/s.
A 25-mm-diameter pipe 35m long is used to convey oil. The oil has a density of 880kg/m³ and a kinematic viscosity of 0.25×10*m³/s. The discharge in the pipe is Q=24x10*m³/min. Given that the pipe is placed horizontally and there are no any minor losses. Determine the pressure drop between the entrance and exit of pipe.