Given A pipe is tapered to form a nozzle as shown in the figure, and the nozzle produces a jet velocity of 102 ft/s. 1.0-in diameter Flow 0.75-in diameter Required Calculate the required pressure in the larger section to produce the jet velocity given, in psi to the nearest 10th. The fluid is water at 180°F (Appendix A).

Q: Crude oil (with specific weight γoil = 55 lb/ft3 ) is pumped at a rate of 400 gallons per minute…

A: Given data, Q = 400 gallons/min = 4007.48×60ft3/s density of soil (γoil) = 55 lb/ft3pressure at A…

Q: Q4. The tank is filled with aqueous ammonia (ammonium hydroxide) to a depth of 3 ft. The remaining…

A:

Q: The horizontal nozzle in the given figure has D1 = 12 in and D2 = 6 in, with the inlet pressure p1 =…

A: Compute the horizontal force provided by the flange bolts to hold the nozzle fixed?

Q: Calculate the pressure difference between the 2 points shown on the figure below (P1 - P2)? Fluid in…

A: Given :-       The pressure difference between 2 points ( P1-P2)           SG =13.6           Cross-…

Q: In the supply system (Q=0.89cfs) shown in the figure, the pressure required at the delivery end is…

A: Q = 0.89 cfs Diameter = 4 in = 0.333 ft Length = 1000 ft Pressure at delivery end = 65 psi Water…

Q: Two vats are connected by a submerged pipe with a square cross-section, as shown in Figure Q2. A…

A: h2 > h1 Let density of fluid be ρ

Q: Q6/ For the pipe enlargement shown in Fig. the pressures at sections (1) and (2) are 56.3 and 58.2…

A:

Q: A Pitot tube shown in the figure below has air of velocity V flowing as shown. If one of the…

A:

Q: Water flows from the ground floor to the third floor in a 4-storey building through a pipe 50 mm in…

A: Discharge, Q=2 L/s Diameter of the pipe, D=50 mm Roughness coefficient, k=0.03 mm Opening diameter…

Q: Water flows through a 90° bend in a horizontal plane as depicted in the figure.

A:

Q: Gasoline flows steadily downward through the pipe shown in the figure below. Viscous effects are…

A:

Q: Question 6 In the schematic below, water flows through the pipe and enters a sudden contraction…

A: Anchoring force Wind, tide, and waves combine to create the forces that an anchor must contend with.…

Q: For the pipe enlargement shown, the pressure at sections (1) and (2) are 56.3 and 58.2 psi,…

A:

Q: For the system in the figure, calculate the distancevertical between the surfaces of the two…

A: Step 1:QStep 2: Step 3: Step 4:

Q: An empty water tank has a diameter, D=6ft, and height, H=10ft, an inlet valve with a diameter, din…

A: The water tank has a diameter D= 6ft height, H=10ft,inlet valve with a diameter d(in)=6”outlet valve…

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.