Given a 60-meter tall wind turbine tower and is capable of withstanding shear wind up to 20m//s. The maximum deflection of the top of the tower is 1.25% the total tower height in order to avoid the turbine clades striking the tower. Consider standard factors of safety. Make any assumptions with values to find the pressure, power, and safety facto

Q: Discuss Brayton and Rankine cycles

A: Brayton cycle, It consist of 4 process, 1. 1-2 process-Isentropic compression process 2. 2-3…

Q: nagine you have a house with low over the roof with a speed

A:

Q: A hydraulic pump delivers 12 litres per minute towards pressure of 270 bar.Find the following  (a)…

A: Given data: Pump discharge rate, Q = 12 L/min. Pressure, P = 270 bar. The overall efficiency of the…

Q: Find the air horsepower of the AHU fan that delivers 25,000 CFM through a 4ft x 4ft duct with a…

A: To find: The air horsepower of the AHU fan. Given: The flow rate is Q=25,000 CFM1 m60 sec=416.67…

Q: 3. A 10-ft diameter by 15 ft height vertical tank is receiving water (p = 62.11b/ft3) at the rate of…

A: GivenD=10ftH=15 ftρ=62.11 lb/ft3Q˙in=300 gpm=0.668403 ft3/sd=6 in =612ft =0.5 ftV=5fps=5 ft/s…

Q: Write any four advantages of Vertical Axis wind turbine.

A: Vertical axis wind turbine - it is a type of turbine which has the blades mounted on the top…

Q: An adal-fow gas turbine rotor receives a flow of gas at a velocity V The gas leaves the stator with…

A:

Q: For the sprinkler shown, find a. the torque required to hold it steady, and b. the rotation rate in…

A:

Q: Q3/ The horizontal pump in Fig. below discharges 20°C water Neglecting losses, what power in kW is…

A: GIVEN:discharge fromthe pump Q=57m3/h

Q: Parvinbhai

A: The objective of the question is to calculate the maximum torque that a hydraulic motor can generate…

Q: A 10-hp pump (installed a the ground level) draws water from a well 30 ft below ground level ane…

A:

Q: Three bladed type wind turbine with an area of 255 sq.m was installed in a windy cliff with 25 m/s…

A:

Q: Q.1) for the system shown in figure (a). The pump has the characteristics shown in figure (b). What…

A: Pressure in lower tank, PL=35 lb/in2=35*144=5040 lb/ft2Pressure in the upper tank, PU=10…

Q: A fan develops 116.84-mm WG static pressure and 21.59-mm velocity head when delivering 317.4 CMM of…

A:

Q: What is the annular energy production (AEP) for a 3-MW wind turbine in a class 4 wind regime? (Take…

A: A 3-MW wind turbine in a class 4 wind regimeClass 4 in a good wind regime, Capacity Factor = 40%To…

Q: A pump draws water from a reservoir A(EL 0m) and lifts it to reservoir B(EL. 80m), the headloss are:…

A: Given data: Datum is located at point A                    Elevation of B = 80 m…

Q: An 82 m in diameter, 1.5 MW wind turbine has a rated wind speed of 12 m/s. What is the efficiency…

A:

Q: Rafe Air is contained in an insulated rigid column at 20 degree Celsius and 200 kPA. A paddle wheel…

A: The temperature of the air,T1=20oC=293 K. The pressure of the air,P1=200 kPa The paddle work on the…

Q: A turbine is to be built in the south of Jordan for electrical power plant station. As a consultant…

A: Given,

Q: Q5/ A centrifugal pump impeller runs at 1500 rpm & has internal & external diameters of 0.2 n & 0.4…

A: A centrifugal pump is a mechanical device that moves a fluid by transferring rotational energy from…

Q: 4 m of water, and each of the three elbows ha uces the diameter by a factor of 0.60 (60% o ntraction…

A: Given Data The pipe diameter after the pump is:Dafter=1.8 cm The pipe diameter before the pump…

Q: 4. A 16.50 ft. diameter by 32.8 ft. height tank is receiving water (p = 62.3 lbs/ft³) at the rate of…

A: GivenD=16.50fth=32.8 ftρ=62.3 lbs/ft3Q=405GPMd=6in V=5.36 ft/st=28min

Q: 2. The figure shows a pipe reducing section that is bolted on to the end of a pipe. Water flows…

A:

Q: A petrolengine has mechanical efficiency 0.8 and lower calorific value of ispoots 44.2 MJ/kg. The…

A: qm=0.8CV=44.2 MJ/kgbore= 0.06stroke = 0.08N=2000rpmfuel = 8liter/hW=220Nρ=750kg/m3R=400mm or…

Q: Find an expression for speed of sound as a function of bulk modulus of elasticity.

A: GIVEN DATA- SPEED OF SOUND IN TERM OF BULK MODULUS OF ELASTICITY WE HAVE TO FOUND

Q: The pressure of the water base of a Pelton Wheel is 4850 kPa and the velocity at the same point is 6…

A:

Q: A petrol engine has mechanical efficiency 0.8 and lower calorific value of 44.2 MJ / kg. The engine…

A: Given Data: Mechanical Efficiency η=0.8 Calorific value C.V=44.2MJkg Bore D=0.06 m stroke L=0.08 m…

Q: I need handwritten otherwise I'll dislike A two-bladed horizontal axis wind generator has a 30 m…

A:

Q: Design a rocket nozzle, knowing that you have a chamber pressure of 6.28 MPa, mass flow rate of…

A:

Q: can a wind turbine have an efficiency of 85% ? Give reasons to support your answer

A: No, a wind turbine can not have an efficiency of 85%. Wind turbine efficiency is the amount of…

Q: (d) Figure Q.4(d) shows a truck with a mass of 6000 kg travels up a 35° slope at a constant speed of…

A:

Q: Q1:-Calculate the power of the turbine as shown in fig.(1), neglecting the losses Fig.1 30 m D;=7.5…

A: The pressure in a fluid increases with depth. This means that a water container will have high…

Q: Using data given below, determine the main dimensions and blade angles of a Francis turbine. Net…

A: Given that H=65 m , N=700 rpm , BHP=400 , ηH=0.94 ;ηo=0.85 ;⇒wheel width at inletwheel diameter at…

Q: A two-blade wind turbine is installed on top of a hill experiencing winds of up to 80 mile/h.…

A: Given data: Upstream velocity = 80 mi/hr =vu = 35.7632 m/s Downstream velocity = 50 mi/hr = vd = 50…

Q: A static thrust stands as it showed in the Figure. The intake velocity is 200 m/s, exhaust velocity…

A: Given data:-  The intake velocity = 200 m/s, exhaust velocity=500 m/s, intake cross-section area =1…

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.