Answered: Give the SI unit of resistivity. a)… | bartleby

Related questions

Question

Give the SI unit of resistivity.

a) ohm/metre2

b) ohm metre2

c) ohm metre

d) ohm/metre

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

What is the resistance of the following circuit measured between points a and b? R1 R2 5k 5k R5 a b 1k R3 R4 2k 2k
A 540 W electric heater is designed to operate at 120 V. What is its resistance? A) 26.7 Ω B) 22.2 Ω C) 4.50 Ω D) 20.3 Ω
6. The resistance of wire A is 12 N. Wire B, made of the same material as wire A, is twice as long and has half the cross-sectional radius. How much resistance does wire B have? A)15 Q B)12 Q C)48 Q D)96 Q
Content Material Aluminum Copper Gold Iron Platinum Silver Tungsten Problem Resistivity (22.m) 2.65 x 10-8 1.68 x 10-8 2.44 x 10-8 9.71 x 108 10.6 x 10-8 1.59 x 10-8 5.60 x 10-8 As shown below, an insulated tungsten wire is immersed in 398 g of water at 12 °C. The wire is 1.9 cm long and has a cross-sectional area of 0.006 cm². wire A.) Determine how much heat is needed to bring the water to a boil. The specific heat of water is 4186 J/kg.K. Q = B.) Determine how long it will take to bring the water to a boil if a 13 A current is run through the wire. Assume all the thermal energy generated by the wire is absorbed by the water. At =
What current will a 3.0 V battery cause to flow? The resistance of the battery is 14.0 Ω. A) 4.7 A B) 42 A C) 130 A D) 0.21 A
1. A circuit consists of a 9.0 V battery connected to three resistors (47, 17 , and 160 ) in series. (a) Find the current that flows through the battery. --- mA
3. Determine the currents I1, I2 and I3 in the circuit below using Kirchhoff's Laws. 30 2 I, Loop 1 40 2 I3 12 82 = 45 V a d C b 20 2 Loop 2 I2 E1 = = 85 V 12 e
5) a) Apply Kirchhoff's rules to the circuit below. You will need to indicate each current, one in each branch of the circuit, on the diagram. V battery R₁ R4 R3 R₂ R5
Four 1.5 V cells are connected in series to a 12 ohm light-bulb. If the resulting current is 0.45 A, what is the internal resistance of each cell, assuming they are identical and ne- glecting the wires? A) 1.32 ohm B) 0.33 ohm C) 0.45 ohm D) 1.5 ohm
12. What is the equivalent resistance of these two resistors? A) 0.48Ω Β) 2.1Ω C) 10Ω D) 21Ω Page 6 3Ω {{7Ω ΖΩ και
Wire Radius (mm) Wire Radius (m) Cross-sectional Area, pr2 (m2) 1/A (m-2) Resistance (Ohms) .9 9x10-4 2.54x10-6 3.9x105 36.54 mΩ .15 1.5x10-4 7.07x10-8 1.41x107 1200 mΩ .86 8.6x10-4 2.32x10-6 4.3x105 39.76 mΩ .65 6.5x10-4 1.33x10-6 7.5x105 68.91 mΩ .6 6x10-4 1.13x10-6 8.8x105 81.66 mΩ Given the table, what is the Slope of Resistance vs. 1/A? The wire length is 5.8m.
Pane 15. The resistance of the following resistor, fig. 2, is Green Blue Red Fig 2. a) 339 2 b) 5.6 k2 c) 560 2 d) 260 k2 16. 2A current passes through a resistor of 60 2 when a battery is connected across this resistor. The voltage across the resistor is a) 120V b) 220V c)15 V D) 30V

SEE MORE QUESTIONS