give an example of a dynamic fluid force. describe the situation/movement where the dynamic fluid force is present, classify it as a drag or lift force, point out if the goal of the movement is to maximize or minimize the drag force and how that is accomplished practically. Finally point out the specific component of the equation that is altered during this situation

Q: The figure below shows a hovercraft that "floats" on a cushion of air, allowing it to move freely…

A:

Q: Draw the diagram of the dimensionless velocity profile and 11 for the boundary layer on the surface…

A: To discuss the dimensionless velocity profile in a boundary layer under a pressure gradient, we need…

Q: An approximated velocity profile for a laminar boundary layer is given as u(y) z Usin 28 where U is…

A: (a) Write the given data. uy=Usinπy2δμ=1.94×10-5 Ns/m2U=10.8 m/s δ=3 cm

Q: 5- Air at 20C is flowing Over a flat plate at 3m/s. If the plate is 30 cm width and at 60 C…

A:

Q: s drag?

A: kindly refer below solution.

Q: Please don't provide handwritten solution.

A: The given parameters are:Freestream temperature, T∞ = 245 KFreestream pressure, p∞ = 4.35 × 10^4…

Q: 2. Integrate the pressure P and shear stress Tr9 over the entire surface of the sphere and obtain…

A:

Q: Figure la shows a commercial vehicle and a car. Sketch carefully the detail flow patterns that you…

A: In this problem, it is asking about the flow pattern and also asking why aerodynamic forces are…

Q: We are testing a flat plate of length L = 1.125 m and width W = 0.225 m in a stream of air flowing…

A: For flat plate boundary layer conditionWe Re=5×105Thus Re=ρVLμ Re=1.2×20×1.12518×10-6 Re=15×105Thus…

Q: The two spheres stand with a stop element as in the figure. The spheres are connected with…

A: Given: The specific gravity of steel ball= 5.98 The density of air= 1.225 kg/m3 The density of…

Q: Air at 20°C forms a boundary layer near a solid wall, in which the velocity profile, U = Umax sin TY…

A:

Q: Q/ Prove that the drag force expression for the boundary layer with the velocity profile Sin ) is…

A:

Q: As given in the figure below, a square block weighing 1.1 kN has a 20° inclination and is 0.25 m x…

A:

Q: Find the drag force applied by the wind blowing at

A: Given: U= 80 km/h To determine: The drag force due to wind blowing

Q: A truck carrying fully-filled water container that is 2.5m long, 2.5m wide, and 2m high the entire…

A:

Q: m/s support

A:

Q: QI/ If the velocity profile of the boundary layer is =-O find the thickness of boundary Uo 28 layer,…

A: Momentum Thickness,θ=∫0δuu∞1-uu∞dy…

Q: Q4. Consider an aircraft flying in straight and level flight with total wing area 110 m², wing…

A: Apply the energy equation for rising flight in order to determine the climb rate that the aircraft…

Q: 6- A 10-m-diameter rotor for a wind turbine is to be designed for use in an area where the…

A: QND3= constantflow is directly proportional to area of approach , since wind characteristic speed is…

Q: _A- Airbus 320 fly in steady level flight with altitude 11000m, find the lift force required to…

A: For the steady level of flight, the lift force is equal to the weight force then the plane is in…

Q: A smooth steel (SG = 7.86) sphere is dropped in glycerin. Determine its constant fall velocity using…

A:

Q: Consider a commercial airliner flying at a speed of 540 mph (relative to the air) at an altitude of…

A: Givenairline flying at a speed altitude means molar mass, (M) temperature variation with altitude is…

Q: cool not coPP I in air at 25°C and latm. Use drag coefficient C the spheres fall at their terminal…

A: Re =ρVDμ =VDν  chracterstics of air at Ts+T∞2=300+3502= 325 K  using data book ν =5.12×10-5m2/s k =…

Q: 2. You are working for a glider manufacturer and have been asked to analyse the laminar boundary…

A: For the solution refer below images.

Q: A vortex ring is travelling from a less dense environment p, to denser medium p2 so that P2 > P1. If…

A: Give, Vortex ring is travelling from less density to high density, i.e., ρ2>ρ1 The size of the…

Q: 3. What would be the change in drag force exerted on a spherical spacecraft (Diameter-5m) travelling…

A:

Q: Question 2 Air flow at a constant speed (Us = 10 m/s) is forming a two-dimensional incompressible…

A:

Q: Define a Newtonian Fluid, and with the aid of a sketch, explain the no-slip boundary condition and…

A: The different phenomenon are explained below with proper diagrams.

Q: . What force in Newton is required to drag the block at 3 m/s,

A: Need to find Force ( drag)

Q: Help me solve this problem A uniform air stream of Ma corner as shown in figure. T stream are 223 K…

A: as per our guidelines i solved 1st 3 questions

Q: U₂ = 2²-² 2.0 m (Equation 1) 4 B 10.0 m 10.0 m Figure Q1-2 Question 2 Air flow at a constant speed…

A: Given: The air flow rate, U = 10 m/s The boundary layer thickness, δ = 6.6094 mm

Q: You are designing an airfoil for a new hobby RC plane.  Because of your limited knowledge, you have…

A:

Q: A stirrer mixes liquid chemicals in a large tank. The free surface of the liquid is exposed to room…

A:

Q: A correlation of computational fl uid dynamics results indicatesthat, all other things being equal,…

A:

Q: A smooth steel (SG = 7.86) sphere is dropped in glycerin. Determine its constant fall velocity using…

A: To determine the constant fall velocity of the steel sphere in glycerin using the modified…

Q: A two-dimensional analysis on the flight of FL FN an airfoil is shown in the figure. The airfoil…

A:

Q: A bird moving in air or a fish moving in water experiences a force opposite to its direction of…

A: During the bird's or fish motion in air and water, respectively, they experience a drag force in the…

Q: boundary layer, the shear stress at trailing edge and the drag force on one side of plate 1 m long,…

A:

Q: A solid cone of angle 2θ , base r 0 , and density ρ c is rotatingwith initial angular velocity ω 0…

A: